The effects of seismic forces and thermal expansion on bridge performance necessitate an accurate understanding of the relationship between passive force and backwall deflection. In past case studies, skewed bridges exhibited significantly more damage than non-skewed bridges. These findings prompted studies involving numerical modeling, lab-scale tests, and large-scale tests that each showed a dramatic reduction in passive force with increased skew. Using these results, a correlation was developed between peak passive force and backwall skew angle. The majority of these tests had length to height ratios of 2.0; however, for several abutments in the field, the length to height ratio might be considerably higher than 2.0. This change in geometry could potentially affect the validity of the previously found passive force reduction correlation. To explore this issue, laterally loaded, large-scale pile cap tests were performed with densely compacted sand at a length of 11 ft (3.35 m) and a height of 3 ft (0.91 m), resulting in a length to height ratio of 3.7. The backwall interface was adjusted to fit three various skew angles including: 0°, 15° and 30°. The behavior of both the pile cap and adjacent soil backfill were monitored under these conditions. The peak passive force for the 15° and 30° tests were found to be 71% and 45%, respectively, of the peak passive force for the 0° skew test. These findings are relatively consistent with previously performed tests. Passive forces peaked at deflections between 2% and 5% of the backwall height, decreasing with skew angle. All skews exhibited a log spiral failure plane that transitioned into a linear plane. These results also agreed with previously reported values for large-scale passive force-deflection tests. Rotation of the pile cap was detected in the direction opposite to the skew. Higher pressures were found to be on both corners of the pile cap than in the middle portion, as is suggested by the elastic theory.

Passive force-deflection behavior for densely compacted backfills must be considered in bridge design to ensure adequate resistance to both seismic and thermally induced forces. Current codes and practices do not distinguish between skewed and non-skewed bridge abutment geometries; however, in recent years, numerical models and small-scale, plane-strain laboratory tests have suggested a significant reduction in passive force for skewed bridge abutments. Also, various case studies have suggested higher soil stresses might be experienced on the acute side of the skew angle. For these reasons, three large-scale tests were performed with abutment skew angles of 0, 15 and 30 degrees using an existing pile cap [11-ft (3.35-m) wide by 15-ft (4.57-m) long by 5.5-ft (1.68-m) high] and densely compacted sand backfill confined by MSE wingwalls. These tests showed a significant reduction in passive force (approximately 38% as a result of the 15 degree skew angle and 51% as a result of the 30° skew angle. The maximum passive force was achieved at a deflection of approximately 5% of the backwall height; however, a substantial loss in the rate of strength gain was observed at a deflection of approximately 3% of the backwall height for the 15° and 30° skew tests. Additionally, the soil stiffness appears to be largely unaffected by skew angle for small displacements. These results correlate very well with data available from numerical modeling and small-scale lab tests. Maximum vertical backfill displacement and maximum soil pressure measured normal to the skewed backwall face were located on the acute side of the skew for the 15° and 30° skew test. This observation appears to be consistent with observations made in various case studies for skewed bridge abutments. Also, the maximum outward displacement of the MSE wingwalls was located on the obtuse side of the skew. These findings suggest that changes should be made to current codes and practices to properly account for skew angle in bridge design.