Shelf life is a parameter of the lifetime distribution of a food product, usually the time until a specified proportion (1-50%) of the product has spoiled according to taste. The data used to estimate shelf life typically come from a planned experiment with sampled food items observed at specified times. The observation times are usually selected adaptively using ‘staggered sampling.’ Ad-hoc methods based on linear regression have been recommended to estimate shelf life. However, other methods based on maximizing a likelihood (MLE) have been proposed, studied, and used. Both methods assume the Weibull distribution. The observed lifetimes in shelf life studies are censored, a fact that the ad-hoc methods largely ignore. One purpose of this project is to compare the statistical properties of the ad-hoc estimators and the maximum likelihood estimator. The simulation study showed that the MLE methods have higher coverage than the regression methods, better asymptotic properties in regards to bias, and have lower median squared errors (mese) values, especially when shelf life is defined by smaller percentiles. Thus, they should be used in practice. A genetic algorithm (Hamada et al. 2001) was used to find near-optimal sampling designs. This was successfully programmed for general shelf life estimation. The genetic algorithm generally produced designs that had much smaller median squared errors than the staggered design that is used commonly in practice. These designs were radically different than the standard designs. Thus, the genetic algorithm may be used to plan studies in the future that have good estimation properties.

Small satellites refer to a new breed of smaller and computationally capable satellites, which serve as a ?faster, better, cheaper? means of realizing space missions. To ensure success of a small satellite mission, it is important that systems engineering be applied at the initial stages of the program formalization to provide a basis for defining mission strategies, managing requirements, risk analysis, performing design trades and estimating cost. The objective of this thesis is to formalize a small satellite mission plan while providing recommendations in areas involving design optimization, systems engineering, project management, cost modeling, subsystem design and selection. Finally, this thesis details the preliminary design of a conceptual ?MSUSAT? small satellite, using Commercial Off The Shelf (COTS) components, from a systems engineering perspective. It explains the choice of orbit, payload and other subsystem components that are necessary to ensure that the mission fulfils its objective.

No description available.

No description available.

Crab meat is important to the economy of coastal Virginia. The objectives of this study were to complete a shelf-life study on two different packaging styles of fresh crab meat and to test the inhibition capabilities of Carnobacterium piscicola against the pathogen, Listeria monocytogenes. In a shelf-life study, a 12 ounce food grade polyethylene traditional snap-lid container of fresh crab meat was compared to an 8 ounce SimpleStep® trays with Cryovac™ film of equally fresh crab meat sealed with 10,000 cc/m2/24hr oxygen transmission rate (OTR) film. Eleven g samples were used for the microbial shelf-life study conducted at 4°C for 12 days. Aerobic plate counts of crab meat indicated microbial growth from the SimpleStep® trays with Cryovac™ film in 10,000 cc/m2/24hr OTR versus the polyethylene snap-lid was not significant (P>0.05). In objective two, 25 g samples of fresh and pasteurized blue crab (Callinectes sapidus) meat were inoculated with 0.1ml of each, C. piscicola and L. monocytogenes. Three different concentrations of the inoculation levels were studied on select days at both 4°C and 10°C. Microbial spoilage was defined as 107 CFU/g. In fresh crab meat, at both 4°C and 10°C, crab meat spoilage occurred at 7 days or less. In the pasteurized crab meat, at 4°C and 10°C, spoilage did not occur prior to 26 days, and studies were terminated at 28 days of storage. The growth of the two organisms in fresh crab meat was found to be significant for the differing concentration levels and sampling days (P<0.05). The growth of the two organisms in pasteurized crab meat was significant for different concentration levels, sampling days and temperature (P<0.05). In both fresh and pasteurized crab meat, regardless of the inoculation ratios, the L. monocytogenes and C.piscicola followed similar growth trends, but L. monocytogenes was higher in the 2:2 CFU/g concentration and lower at the 6:2 CFU/g concentration level. Although C. piscicola did not completely inhibit L. monocytogenes growth at any concentration ratio, some inhibition was observed. / Master of Science

Linguiças cozidas defumadas armazenadas a temperatura ambiente, é um produto tipicamente brasileiro, no qual são empregadas algumas barreiras para a extensão do shelf life: cozimento, defumação e embalagem à vácuo. Estudos de durabilidade comprovaram que muitas não atendem ao shelf life esperado. Na empresa estudada, somente 23% dos lotes das linguiças em estudo atenderam a 90 dias de armazenamento desejados para a indústria de alimentos e 17% dos lotes não chegaram à 45 dias. Foram realizadas avaliações microbiológicas antes do cozimento (média de 5,03 log UFC/g), após cozimento (média de 1,56 log UFC/g) e após resfriamento (média 1,54 log UFC/g) para os gomos com calibre de 40-44mm; comprimento 23-26cm; com peso variando de 260-300 gramas onde foram submetidos ao processo de cozimento e defumação por, no mínimo, 5 horas, atendendo no mínimo 71,1°C no centro térmico do gomo. Os parâmetros físico-químicos também foram avaliados e atendem a legislação, com valores de aw 0,938 e pH 6,33, favoráveis ao desenvolvimento microbiológico. Também foram realizadas análises sensoriais para avaliação dos atributos sensoriais ao longo do armazenamento a temperatura ambiente. / Smoked sausages stored at room temperature, is a typical Brazilian product, in which some hurdles are used to extend shelf life: cooking, smoking and vacuum packing. Durability studies have proven that many do not achieve the expected shelf life. In the studied company, only 23% of the lots of the sausages under study attended the 90 days of storage desired for the food industry and 17% of the lots did not reach 45 days. Microbiological evaluations were performed before cooking (average of 5.03 log CFU/g) after cooking (mean of 1.56 log CFU/g) and after cooling (mean 1.54 log CFU/g) for the caliber 40-44mm; length 23-26cm; with weight varying from 260-300 grams where they were submitted to the cooking and smoking process for at least 5 hours, attending at least 71.1°C in the thermal center of the oven. The physico-chemical parameters were also evaluated and comply with the legislation, with values of aw 0.938 and pH 6.33, favorable to the microbiological development. Sensory analyzes were also performed to evaluate the sensory attributes along the storage at room temperature.

Determining the relative importance of processes that control the generation and preservation of continental margin stratigraphy is fundamental to deciphering the history of geologic, climatic and oceanographic forcing imprinted on their sedimentary record. The Northern Carnarvon Basin (NCB) of the North West Shelf of Australia has been a site of passive margin sedimentation throughout the Neogene. Cool-water carbonate sedimentation dominated during the early-middle Miocene, quartz-rich siliciclastics prograded over the shelf during the late-middle Miocene, and carbonate sedimentation resumed in the Pliocene. Middle Miocene to Pliocene siliciclastics were deposited as clinoform sets interpreted as delta lobes primarily based on their plan-view morphology and their relief of 40-100 m. Shelf-edge trajectory analysis suggests that part of this stratigraphic succession was built during a long-term, third order, regressive phase, producing shelf-edge deltas, followed by an aggradational episode. These trends appear to correlate with third-order global eustatic cycles. Slope incisions were already conspicuous on the slope before deltas reached the shelf-break. Nevertheless, slope gullies immediately downdip from the shelf-edge deltas are wider and deeper (>1 km wide, ~100 m deep) than coeval incisions that are laterally displaced from the deltaic depocenter (~0.7 km wide, ~25 m deep). This change in gully morphology is likely the result of greater erosion by sediment gravity flows sourced from shelf-edge deltas. Total late-middle to late Miocene margin progradation increased almost three times from 13 km in the southwest to 34 km in the northeast, where shelf-edge deltas were concentrated. Flat-topped carbonate platforms seem to have initiated on subtle antecedent topographic highs resulting from these deltaic lobes. A reduction of siliciclastic supply to the outer paleo-shelf during the Pliocene combined with the onset of a southwestward-flowing, warm-water Leeuwin Current (LC) most likely controlled the initiation of these carbonate platforms. These platforms display marked asymmetry, likely caused by an ancestral LC, which created higher-angle, upcurrent platform margins, and lower-angle, downcurrent clinoforms. The along-strike long-term migration trend of the platforms could be the result of differential subsidence. These platforms constitute the first widespread accumulation of photozoan carbonates in the Northern Carnarvon Basin. They became extinct after the mid-Pleistocene when the LC weakened or became more seasonal. / text

This study aims to establish a depositional framework for an area of the Louisiana shelf, north-central Gulf of Mexico. The depositional history of the study area is poorly understood, especially within the last cycle of major eustatic fluctuation (~18, 000 yrs BP – present). Data sets used in this study include pre-existing and previously unanalyzed two-dimensional, highresolution seismic profile records (Acadiana 86 and Acadiana 89), geotechnical foundation boring data (Coleman and Roberts, 1988a), and an industry lease block survey report (Cole, 1983). Seismic sequence stratigraphic methods are employed in this study to analyze seismic profile data. Seismic sequence analysis results indicate the presence of five unconformable surfaces and five seismic facies units. Through correlation of seismic profile data with lithologic and chronologic data, it is possible to conclude that these seismic facies units represent shelf-margin deltaic deposition during the last lowstand of sea level (~18, 000 yrs BP), sourced by the Pearl River. .

The Florida Reef Tract in Southeast Florida is made up of hard-bottom formations. The shape and size of the tract is constantly changing. One major factor contributing to these changes is the movement of sand. This is influenced by location-based, human-induced, and natural factors. These shifting sands cover or uncover reef structure. Images of the Florida Reef Tract in Palm Beach County were analyzed by the Department of Geosciences at Florida Atlantic University, using a partially automated method of mapping. There are notable changes in reef structure throughout the years 2004-2006, in which many major storm events occurred in the region. A time series analysis was conducted throughout these years. Losses and gains of reef structure were quantified and compared throughout the county as a whole, in beach renourishment project areas, and inlet intervals. Trends suggest that the major storms of 2004-2006 may have had effects on the reef tract. / by Joseph G. Pitti. / Thesis (M.A.)--Florida Atlantic University, 2011. / Includes bibliography. / Electronic reproduction. Boca Raton, Fla., 2011. Mode of access: World Wide Web.

The submerged paleodrainage system of the early Balize delta complex that extended onto the inner continental shelf at 1500 YBP has not been completely studied in great detail. This study interprets the environmental deltaic facies of the Balize Delta, in the Sandy Point region offshore the southeastern Louisiana coast from 120 km of seismic data and 48 vibracores. The stratigraphic and environmental units established in this study provide a geological framework for this area. Overlying Holocene deposits interpreted to be muds of prodelta and lower delta front origin were interpreted as having been deposited from the retreating delta sit atop a transgressive surface, indicated by the toplapping seismic reflectors, the ravinement surface. The deltaic facies below the ravinement surface are of regressive origin an inner shelf delta with widespread delta front sheet sands from a dense group of many distributaries. This research provides a concise methodology adapted from multiple studies for modeling deltaic facies of offshore sand resource targets. / by Zachary Samuel Mester. / Thesis (M.S.)--Florida Atlantic University, 2011. / Includes bibliography. / Electronic reproduction. Boca Raton, Fla., 2011. Mode of access: World Wide Web.