No description available.

No description available.

No description available.

No description available.

The effects of sulfur dispersing agents (SDAs) in the oxygen pressure leaching of nickel concentrate at medium temperature were investigated. Liquid sulfur-aqueous solution interfacial tensions and liquid sulfur-sulfide mineral contact angles were measured at 140ºC, 690 kPa overpressure by nitrogen, and 1.0 mol/L NiSO₄. The effects of SDAs including lignosulfonate, Quebracho, o-phenylenediamine (OPD), and humic acid were evaluated by the calculation of the work of adhesion in the liquid sulfur-sulfide mineral-aqueous solution systems. It was found that the sulfide mineral surface is sulfophobic at pH from 4.1 to 4.5 due to the hydrolysis of nickel (II) ions to nickel hydroxide and the deposition of nickel hydroxide on the mineral surface. These findings apply to four different sulfide mineral systems, including pentlandite, nickeliferous pyrrhotite, pyrrhotite, and chalcopyrite. Lignosulfonate, Quebracho, and humic acid were found to significantly reduce the work of adhesion indicating they should be effective SDAs. OPD is ineffective in changing the work of adhesion of sulfur on the mineral sulfides indicating that it is not a good candidate for sulfur dispersion. The adsorption behavior of SDAs, including lignosulfonate, Quebracho, OPD, and humic acid on elemental sulfur and on nickel sulfide concentrate was investigated. Lignosulfonate, Quebracho, and humic acid were characterized by their infrared spectra. The charge changes on elemental sulfur surface were characterized by the measurement of the electrokinetic sonic amplitude (ESA) in the absence or presence of SDAs. The adsorption of lignosulfonate on molten sulfur surface was calculated by the Gibbs Equation. The adsorption of lignosulfonate, Quebracho, and humic acid on the nickel concentrate was investigated at ambient temperature. The adsorption of lignosulfonate, Quebracho, and humic acid on the nickel concentrate was found to be monolayer adsorption, which was fitted to the Langmuir adsorption isotherm. Electrostatic interaction and ion-binding are the possible mechanisms for the adsorption of lignosulfonate and humic acid on the nickel concentrate. Quebracho is adsorbed on the nickel concentrate through hydroxyl and sulfonate groups. OPD cannot adsorb on the molten sulfur surface. OPD undergoes chemical change in aqueous solution in the presence of ferric at ambient temperature. Oxygen pressure leaching experiments were performed at 140 or 150ºC under 690 kPa oxygen overpressure. The particle size of the nickel concentrate was found to be an important factor in leaching. During the leaching of nickel concentrate with P₈₀ of 48 µm, the SDAs were believed to be fully degraded before nickel was fully extracted. At most 66% nickel was extracted in the presence of 20 kg/t OPD. Fine grinding (P₈₀ of 10 µm) was sufficient for 99% nickel recovery at low pulp density while at high pulp density, the nickel extraction increased from 95% to 99% with addition of SDAs. Based on the leaching results on a nickel concentrate sample (-44 µm), OPD had the effect of increasing the nickel extraction to about 99%, followed by Quebracho (83%), lignosulfonate (72%), and humic acid (61%). It is suggested that the oxidation product of OPD is effective in solving the sulfur wetting problem in leaching. 97% nickel was recovered in the presence of 5 g/L chloride ion. Chloride ion has an effect to enhance the performance of lignosulfonate under leaching conditions.

With the rapid development of portable electronics, hybrid-electric and electric cars, there is great interest in utilization of sulfur as cathodes for rechargeable lithium batteries. Lithium/sulfur batteries implement inexpensive, the earth-abundant elements at the cathode while offering up to a five-fold increase in energy density compared with the present Li-ion batteries. However, electrically insulating character of sulfur and solubility of intermediate polysulfides in organic liquid electrolytes, which causes rapid capacity loss upon repeated cycling, restrict the practical application of Li/S batteries. In this thesis, the gel polymer and solid polymer electrolytes were synthesized and applied in Li/S batteries. A gel polymer electrolyte (GPE) was formed by trapping 1 M lithium bistrifluoromethane-sulfonamide (LiTFSI) in tetraethylene glycol dimethyl ether (TEGDME) electrolyte in a poly(vinylidenefluoride-co-hexafluoropropylene) (PVDF-HFP) /poly(methylmethacrylate) (PMMA) polymer matrix. The electrochemical properties of the resulting GPE were investigated in lithium/sulfur battery. The gel polymer battery exhibited a high specific capacity of 753.8 mAh gˉ¹ at the initial cycle, stable reversible cycling and a capacity retention about 80% over 40 cycles along with a high Coulombic efficiency. Comparative studies conducted with the 1 M LiTFSI liquid electrolyte cell demonstrated that a cell with liquid electrolyte has remarkably low capacity retention and Coulombic efficiency compared with the GPE cell. In the further studies, a solid polymer electrolyte (SPE) based on poly- (ethylene-oxide)/nanoclay composite was prepared and used to assemble an all-solid-state lithium/sulfur battery. The ionic conductivity of the optimized electrolyte has achieved about 3.22×10ˉ¹ mS cmˉ¹ at 60 °C. The Li/S cell with this SPE delivered an initial discharge capacity of 998 mAh gˉ¹ when operated at 60 °C, and retained a reversible capacity of 634 mAh gˉ¹ after 100 cycles. These studies has revealed that the electrochemical performance of lithium/sulfur cells, including charge-discharge cyclability and Coulombic efficiency, can be significantly improved by replacing liquid electrolytes with solid polymer and gel polymer electrolytes, which reduce the polysulfide shuttle effect and could protect the lithium anode from the deposition of the electrochemical reaction, leading to higher sulfur utilization in the cell.

No description available.

No description available.

The complexes Cp(,2)M(SH)(,2), where M = Ti and Zr, have been prepared and treated with S(,8) and >N-S(,x)-NN = benzimidazolyl, phthalimidyl and x = 1, 2, to give the metallacyclohexasulfanes Cp(,2)MS(,5). Reaction of Cp(,2)TI(SH)(,2) with >N-SR, where >N = phthalimidyl, succinimidyl, gave the complexes Cp(,2)Ti(S(,2)R)(,2) (R = CHMe(,2)) and Cp(,2)Ti(SR)(S(,3)R) (R = Ph, 4-C(,6)H(,4)Me). The thiolates Cp(,2)Ti(Cl)SR and Cp(,2)Ti(SR)(,2) (R = CHMe(,2), CMe(,3), Ph, 4-C(,6)H(,4)Me) were prepared for comparison. Treatment of the complexes Cp(,2)MCl(,2) with anhydrous solutions of Li(,2)E(,x) gave the complexes Cp(,2)ME(,5), where M = Ti, Zr, Hf and E = S, Se. The compounds (RCp)(,2)TiS(,5) (R = Me, SiMe(,3)),CH(,2)Cp(,2)TiS(,5), and (Me(,5)Cp)CpTiS(,5) were prepared similarly. Reaction of Li(,2)S(,x) with (Me(,5)Cp)(,2)MCl(,2) gave the metallacyclotetrasulfanes (Me(,5)Cp)(,2)MS(,3). The complex Cp(,2)Ti{S(CH(,2))(,3)S} was synthesized. Variable temperature ('1)H NMR studies established the barriers ((DELTA)G('(NOT=))) for ME(,x) and TiS(,2)C(,3) ring reversal in the above complexes. The crystal structures of Cp(,2)Ti(SPh)(S(,3)Ph), Cp(,2)MS(,5), and (Me(,5)Cp)(,2)TiS(,3) are discussed.

This thesis was devised as a fundamental study of the Li-S system by the use of 7Li Magic Angle Spinning (MAS) Nuclear Magnetic Resonance (NMR), X-ray Absorption Near- Edge Structure (XANES), and Non-Resonant Inelastic X-ray Scattering (NRIXS). The first part of this thesis reports the first evidence of a stable solid-phase intermediate between elemental sulfur (α-S8) and Li2S, Li2S6, which can be used to understand deeper Li-S battery. The second part of this thesis is based on operando XANES measurements made in the Argonne Photon Source (APS).Linear combination fit (LCF) analyses are performed to interpret the data; and, noticeably, the distinction between short-chain and long-chain polysulfides can be made due to the use of proper reference materials. The results reveal the first detailed observation of typical sulfur redox chemistry upon cycling, showing how sulfur fraction (under-utilization) and sulfide precipitation impact capacity. It also gives new insights into the differences between the charge and discharge mechanisms, resulting in the hysteresis of the cycling profile. Operando XANEs were also performed on het-treated material, which exhibits a particular electrochemical signature, which has never explained. After a preliminary electrochemical study by potentiodynamic cycling with galvanostatic acceleration (PCGA), operando XANES measurements at the sulfur K-edge are performed on heat-treated PCNS. Noticeably, the difference in the XANES signatures of the pristine and the recharged state shows the irreversible process that occurs during the first discharges. At last, electrolytes are investigated by the compilation of quantitative physico-chemical parameters – viscosity, ionic conductivity, and solubility of Li2S and Li2S6 – on novel class of solvents that are glymes with non-polar groups and acetonitrile (ACN) complexed with LiTFSI. 1,1,2,2-Tetrafluoroethyl 2,2,3,3-tetrafluoropropyl ether (HFE) is chosen to decrease their viscosities. (ACN)2:LiTFSI attracts particular attention because of the particularly low Li2Sn solubility and. Its good electrochemical performance when mixed with 50 vol% HFE. Operando XANES proves the formation of polysulfides in this electrolyte, although constrains imposed by this novel electrolyte to the XANES experiment complicate the data analysis. The low energy feature evolution shows a more progressive mechanism involved in this electrolyte, which could be linked to the particularly low Li2Sn solubility