1 |
BEHAVIOUR AND DESIGN OF REINFORCED CONCRETE PIPESMacDougall, Katrina 24 June 2014 (has links)
The overall objectives of this thesis are to determine if Indirect and Direct Design methods currently used for reinforced concrete pipe are able to accurately predict the capacity of the pipe, to identify discrepancies between the two methods, and to provide potential modifications to the methods to reduce inconsistencies. As part of this investigation, two 0.6 m pipes (nominal strength classes 100-D and a 140-D) and two 1.2 m pipes (a 65-D with Wall B and a 65-D with Wall C) were tested under single wheel pair loading at burial depths of 1.2, 0.6 and 0.3 m. The test pipes did not crack at the applied service load of 110 kN and did not pass the crack width limit until between 2.5 and 4 times the service load. A 0.6 m 100-D pipe was also tested under simulated deep burial and it was found that the calculated test D-Load is 1.9 times greater than the designated D-Load of the test pipe. It was found that both methods were conservative and that the Direct Design method should be modified to more closely align with the Indirect Design. An investigation of the Direct Design parameters found that by considering thick ring theory and the Modified Compression Field Theory with two layers of reinforcement, the required amount of steel from Direct Design could be made to align very closely with the Indirect Design. An additional test was completed to further assess the Direct Design method on a 0.6 m 140-D pipe to measure the pressure around the circumference of the pipe and compare this measured pressure to the commonly used pressure distribution for Direct Design. The results show that at the minimum cover (0.3 m) the test pressure is higher than predicted at the crown, lower than predicted at the invert, and nearly zero at the shoulder, springline, and haunch, which is inconsistent with most of the predicted results at these locations. / Thesis (Master, Civil Engineering) -- Queen's University, 2014-06-20 16:29:39.037
|
2 |
Pohyb tekutiny s tlakově závislými materiálovými koeficienty při povrchovém zatížení / The motion of a fluid with pressure dependent material moduli under a surface loadJanečka, Adam January 2012 (has links)
In the present work, we study the motion of homogeneous, isotropic, incompressible fluid with viscosity depending on the pressure. The motion is studied in a infinite domain under a surface load by a prescribed pressure on one of the boundaries. This so called free boundary is due to the exerted pressure deformed and is also subject of study. After an acceptable simplification and prescribing suitable boundary conditions, the problem is solved at first analytically using the perturbation method, then numerically by means of the spectral methods. The effort is to observe any differences in the motion in comparison to commonly used Newtonian fluid.
|
3 |
Crustal stress changes induced by seasonal hydrological load variations in correlation with seismicity rate changes in the Malawi Rift SystemCarr, Steve Asamoah Boamah 15 September 2021 (has links)
No description available.
|
4 |
The Development of Semi-Analytical Solutions for 3-D Contact ProblemsLI, JUNSHAN 06 October 2004 (has links)
No description available.
|
Page generated in 0.055 seconds