The aim of this thesis on the topic "Noises on farms for breeding broilers and its spreading to surrounding neighbourhood" was to find out how the noise load influences the surroundings of two farms for breeding broilers. Repeated measures and following analysis of the particular values of the noise load, was used to determine, whether the relevant legislation and other norms are respected. Calculations of equivalent level of acustic pressure were used to compare chosen cases and to final evaluation.

This thesis describes the design chain to indicate the measuring cylinder Stirling engine. It describes the practical problems of measurement methodology and highlights the possible pitfalls of the measuring chain. For measuring the use of pre-existing model of gamma Stirling engine modification. It was carried out systematic measurement and evaluation of measured data. As a mathematical model for comparison with the measured data was used ideal cycle and Schmidt theory.

In the present work, we study the motion of homogeneous, isotropic, incompressible fluid with viscosity depending on the pressure. The motion is studied in a infinite domain under a surface load by a prescribed pressure on one of the boundaries. This so called free boundary is due to the exerted pressure deformed and is also subject of study. After an acceptable simplification and prescribing suitable boundary conditions, the problem is solved at first analytically using the perturbation method, then numerically by means of the spectral methods. The effort is to observe any differences in the motion in comparison to commonly used Newtonian fluid.

A lot of technologically relevant incompressible fluids exhibit a substantial variaton of viscosity with the pressure;a falling cylinder viscometer is frequently used for the measurements, determining the viscosity indirectly from the time it takes the sinker to fall a given distance. The relation between the sinker fall velocity and the fluid viscosity is, however, derived under the constant viscosity assumption. The objective of the present thesis is to perform a numerical simulation of the viscometric experiment, assuming an explicit form of the pressure-viscosity dependence and realistic parameter values and to quantitatively assess the difference in body motion to the Navier- Stokes model. The computational method proposed, handling both the nonlinear constitutive relation and the body motion, was tested on simple problems with analytical solutions. The semianalytical relation for the Navier-Stokes model, also re-derived here, is compared to the computational results.The validity of the assumptions used in the theoretical derivation, based on the results of the numerical simulation, is discussed regarding the geometry of the viscometer. Powered by TCPDF (www.tcpdf.org)

Analysis of care in patiens at risk for arterial hypertension in pharmacy I. Author: Stanislav Gregor1 Tutor: Josef Malý1 Consultant: Stanislav Havlíček2 1 Department of Social and Clinical Pharmacy, Charles University in Prague, Faculty of Pharmacy in Hradec Králové 2 Czech Chamber of Pharmacists, Prague Introduction: Arterial hypertension represents a serious health problem. Despite of the fact that great attention is paid to an early diagnosis and therapy of arterial hypertension, it remains compensated insufficiently in a number of patients. Objectives: The aim of the thesis was to analyse the possibilities of pharmaceutical care provided to patients who are at risk of arterial hypertension. Methodology: Blood pressure was measured from the beginning of October till December 2012 in a public pharmacy in Moravská Třebová. The blood pressure was measured by a pharmacist by means of a validated and calibrated tonometer. Other data were collected from a directed interview with the pharmacy client. The data were evaluated in Microsoft Excel 2007 and processed by means of the frequency analysis. A retrospective analysis of drug problems was further performed in patients who have been using pharmacotherapy or food supplements. Results: The data were obtained from 196 pharmacy clients (31 % of men and...

Analysis of care in patients at risk for arterial hypertension in pharmacy II. Author: Kateřina Panáčková Tutor: PharmDr. Josef Malý, Ph.D.1 Consultant: PharmDr. Stanislav Havlíček2 1 Department of Social and Clinical Pharmacy, Charles University in Prague, Faculty of Pharmacy in Hradec Králové 2 Pharmacy Luna, Plzeň Introduction: Arterial hypertension is one of the most common illnesses in the Czech Republic. Not only this should be the reason for proper health education and early detection of clients endangered by this illness. Objectives: The objective of the thesis was to perform and evaluate consultancy activities in a pharmacy focusing on clients with a risk of arterial hypertension or with already diagnosed arterial hypertension. Methodology: Collection of data took place in a public pharmacy in Česká Lípa between 1 May 2013 and 27 June 2014. Measuring of blood pressure was a part of controlled interview with clients of the pharmacy. Following data was recorded into a form: social-demographic characteristics of the respondend, his/her attitude towards measuring blood pressure in the pharmacy, incidence of risk factors of arterial hypertension, respectively atherosclerosis and other illnesses in the anamnesis, medication including nutrition supplements, results of own measurings and proposed...

Analysis of blood pressure measurement in Czech pharmacies I. Author: Jakub Prouza Tutor: Josef Malý1 1 Department of Social and Clinical Pharmacy, Charles University in Prague, Faculty of Pharmacy in Hradec Králové Introduction: Arterial hypertension is one of the most serious health problems of today and its therapy must be approached comprehensively. In addition to medical care, to the improvement of the health status of the patient significantly contribute properly implemented pharmaceutical care and blood pressure measurement in pharmacy. Objectives: The aim of the thesis was to describe and analyse conditions of blood pressure measurement in a sample of Czech pharmacies. Methods: Data were collected via questionnaire survey in 2012 and 2013 in three districts. The survey was conducted using two questionnaires, which were filled at pharmacies with possible help of trained interviewer. The first questionnaire was completed by the authorized employee representative of the pharmacy and included questions characterizing the pharmacy. Furthermore the question whether they provided blood pressure measurement in the pharmacy. If they did, further questions were on the frequency of measurement, instrumentation and space equipment in pharmacy. The second questionnaire was completed by the pharmacy...

The thesis deals with the indication of combustion pressures of ignition engines. Introduction is devoted to thermodynamics of combustion engines and their diagrams. The following section describes the methods for measuring the combustion pressures of a spark ignition engine. This chapter describes three basic methods of measurement, the most described of which are piezoelectric sensors. The next part is devoted to the design of the measuring chain and to the description of the material used, which was used for the measurement on the engine under test. The main goal of the thesis was to evaluate the results obtained by measuring at the engine testing center of Mendel Uni-versity in Brno. The data were tabulated and graphically evaluated and subsequently described. At the end of the thesis everything is evaluated and the results summarized.

This diploma thesis is dealing with pressure measurement. It describes instruments dedicated to purpose - pressure gauges. Basic of correct pressure measurement is knowledge of behaviour of used pressure gauge. This knowledge is acquired by calibration. With calibration is associated also analysis of errors and uncertainty of measurement and creation of calibration list. Calibration takes place on model workspace pressure measuring in laboratory.

This diploma work takes focus in elastic modulus of unbound granular aggregates, which was determined by repeat load triaxial test and in deformation behaviour of unbound granular aggregates - elastic and plastic deformation. It was examine the propriety of this aggregate for its service as underlying granular material in pavement. Further, there was observed the influence of elastic modulus of unbound granular aggregates on concrete characteristics - compressive and bending strength. Finally, it was observed the influence of individual fractions of aggregates on its elastic modulus and strength of concrete.