Mining and construction industry is a major environmental disturbance creating habitats with extremely coarse material: gravel, cobbles and boulders. Simultaneously, there is an increasing interest in using spontaneous succession during restoration processes on those areas. This leads to a question if vegetation can establish on such coarse substrates. This project assessed the vegetation establishment on substrates with different grain size as well as the hydrological limitations of those substrates. The aim of this study was to find substrate moisture characteristics supporting vegetation establishment. Four herb species (Koeleria macrantha, Epilobium angustifolium, Artemisia campestris var. campestris and Poa nemoralis) typically occurring on xerothermic basalt rocks were sowed on basalt construction aggregates (0-4, 2-4, 4-8, 8-16, 11-22 and 32-63 mm). There were also made mixtures of coarse aggregates (4-8, 8-16 and 11-22 mm) as a base with 10% or 50% additive of fine aggregates (0-4 mm). The final number of individuals, aboveground and belowground dry biomass were measured and subsequently specific leaf area (SLA) was calculated. They were also measured substrate moisture characteristics: field capacity (PVK) and wilting point (BV) from which available water content (ODV) was obtained as...

This is a master’s thesis performed at the Department of Shipping and Marine Technology research group in Hydrodynamics at Chalmers University of Technology and is written for the Center for Naval Architecture at the Royal Institute of Technology, KTH.In order to meet increased requirements on efficient ship propulsions with low noise level, it is important to consider the complete system with both the hull and the propeller in the simulation.OpenFOAM (Open Field Operation and Manipulation) provides different techniques to simulate a rotating propeller with different physical and computational properties. MRF (The Multiple Reference Frame Model) is, perhaps, the easiest way but is a computationally efficient technique to model a rotating frame of reference. The sliding grid techniques provide the more complex way to simulate the propeller and its surrounding region, rotating and interpolate on interface for transient effects. AMI, Arbitrary Mesh Interface, is a sliding grid implementation which is available in the recent versions of OpenFOAM, introduced in the official releases after v2.1.0.In this study, the main objective is to compare these two techniques, MRF and AMI, to perform the open water characteristics of the propeller with the Reynolds-Averaged Navier-Stokes equation computations (RANS) and study the accuracy in parallel performance and the benefits of each approach.More specifically, a self-propelled ship is simulated to study the interaction between the hull and propeller. In order to simplify and decrease the computational complexity the free surface is not considered. The ship under investigation is a 7000 DWT chemical tanker which is subject of a collaborative R&D project called STREAMLINE, strategic research for innovative marine propulsion concepts. In self-propelled condition, the transient forces on the propeller shall be evaluated. This study investigates the results of the experimental work with advanced CFD for accurate analysis and design of the propulsion. In this thesis, all simulations are conducted by using parallel computing. Therefore, a scalability analysis is studied to find out how to affect the average computational time by using different number of nodes.

<p>This study tested a dynamic modelling approach based on salt application, meteorological data and generic descriptions of hydrogeological environments for describing the spread of deicing salt to the surroundings and the corresponding increase in chloride storage in soil. Both the amount of chloride storage and the annual variation pattern were significantly altered due to deicing salt application and spread to the roadside environment. Data from field investigations comprising different hydrogeological environments and different methods of measurement were used to examine the variability of the salt deposition pattern in the vicinity of the road, and to test the performance of the model with respect to different soils and vegetation types. The use of typical hydrogeological environments to represent inputs to the model was shown to be useful to demonstrate the importance of soils, vegetation type and groundwater conditions for modelling the impact of deicing salt on soil water and the response to environmental changes in the vadose zone. However, the use of hydrogeological environment could also be misleading in view of the high degree of variability at the field scale. The different methods of measurements and simulations represented different spatial and temporal scales that were shown to be complementary useful to quantify the different pathways of deicing salt in the roadside environment. Continuous simulations complemented with selected field monitoring should therefore be promoted.</p> / QC 20100526

Mosquito-borne diseases like malaria, dengue fever, yellow fever and West Nile virus are serious problems in many parts of the world, especially in Africa, and partially in Ethiopia. Millions of people become infected and several hundred thousand people die worldwide from these diseases every year. The most conventional methods for mosquito vector control target female adult mosquitoes in a reactive way using insecticides. However, it is possible to perform proactive vector control through source reduction. The main focus of this study was to investigate if there are any associations between characteristics of managed still water bodies and the presence of mosquito larvae in Bahir Dar, Ethiopia. This was done by measuring twelve variables, both abiotic and biotic; pH, conductivity, dissolved oxygen, turbidity, biochemical oxygen demand, nitrate, phosphate, sulphate, carbonate, depth and presence of algae as well as collecting and counting mosquito larvae in ten different sites, during a time series of five weeks. The most common managed waters believed to serve as efficient breeding habitat for mosquitoes were ponds and ditches used for irrigation, drainage or cultivation. A total of 204 mosquito larvae were collected, where 95% were found in four of the ten sites, three of them were managed waters and the last one was unmanaged. Statistical analyses were performed in order to examine potential correlations and differences among the sites. Wilcoxon test was performed to investigate differences between managed and unmanaged waters. Simple linear regression analyses were performed to identify driving variables for the presence of mosquito larvae. The main results from the group tests were significant differences in mosquito larvae density between managed and unmanaged sites. Significant differences between mosquito sites and zero-sites for dissolved oxygen and sulphate were found. Simple linear regression revealed pH and dissolved oxygen as driving variables for mosquito larvae presence. It was concluded that resources should be put on treatment or manipulation of ponds, which were considered the preferred mosquito breeding habitats. However, if conflicts arise among interests concerning food production, measures must be planned and performed thoughtfully or focus should be put on less controversial breeding habitats. Among the driving variables, dissolved oxygen was the suggested variable to manipulate in order to reduce mosquito larvae populations. / Myggburna sjukdomar som malaria, denguefeber, gula febern och West Nile viruset orsakar allvarliga problem i många delar av världen, särskilt i Afrika, och till viss del Etiopien. Miljontals människor världen över blir smittade och flera hundratusen dör varje år till följd av dessa sjukdomar. De konventionella metoderna för att kontrollera och minska spridningen av myggburna sjukdomar handlar om att kontrollera vuxna myggor med insektsmedel. Det är dock möjligt att utföra en mer förebyggande vektorkontroll genom att minska populationen. Fokus för denna studie var att undersöka om det fanns några samband mellan mygglarvsförekomst och egenskaperna hos mänskligt reglerade eller oreglerade vatten i och kring Bahir Dar i Etiopien. Detta gjordes genom att mäta tolv variabler, både abiotiska och biotiska såsom; pH, konduktivitet, löst syre, turbiditet, biokemisk syreförbrukning, nitrat, fosfat, sulfat, karbonat, djup och algförekomst, samtidigt som mygglarver samlades in och räknades, vilket utfördes på tio olika platser under fem veckor. Den vanligaste typen av reglerade vatten som potentiellt skulle kunna utgöra effektiva mygglarvshabitat ansågs vara dammar och diken som används för bevattning, dränering eller odling. Totalt samlades 204 mygglarver in och 95 % av dem fanns i enbart fyra av de tio etablerade mätplatserna, där tre var reglerade och den sista var oreglerad. Statistiska analyser utfördes för att undersöka potentiella samband och skillnader i mygglarvsförekomst och uppmätta variabler bland de tio mätplatserna. Wilcoxons metod användes för att undersöka om det fanns skillnader mellan reglerade och oreglerade ytvattensamlingars larvförekomst och egenskaper. Enkel linjär regressionsanalys utfördes för att hitta eventuella drivvariabler som därmed anses styra mygglarvsförekomsten. De huvudsakliga resultaten i studien var att det förekom en signifikant skillnad i mygglarvsdensitet mellan reglerade och oreglerade ytvattensamlingar. Signifikanta skillnader i löst syre och sulfat förekom även mellan myggsiter och nollsiter. Enkel linjär regression visade på att pH och löst syre var de mest drivande variablerna för mygglarvsförekomsten i denna studie. Slutsatsen var att dammar utgjorde de mest tilltalande habitaten i samband med mygghonors äggläggning och därför borde prioriteras med avseende på resursfördelning vid planering och utförande av vektorkontroll. Om det skulle uppstå konflikter mellan olika intressen som kan äventyra matproduktionen bör insatser planeras och genomföras med försiktighet eller istället göras i andra mindre kontroversiella mygglarvshabitat. Den drivvariabel som ansågs vara den mest lämpliga att manipulera var löst syre.

This study tested a dynamic modelling approach based on salt application, meteorological data and generic descriptions of hydrogeological environments for describing the spread of deicing salt to the surroundings and the corresponding increase in chloride storage in soil. Both the amount of chloride storage and the annual variation pattern were significantly altered due to deicing salt application and spread to the roadside environment. Data from field investigations comprising different hydrogeological environments and different methods of measurement were used to examine the variability of the salt deposition pattern in the vicinity of the road, and to test the performance of the model with respect to different soils and vegetation types. The use of typical hydrogeological environments to represent inputs to the model was shown to be useful to demonstrate the importance of soils, vegetation type and groundwater conditions for modelling the impact of deicing salt on soil water and the response to environmental changes in the vadose zone. However, the use of hydrogeological environment could also be misleading in view of the high degree of variability at the field scale. The different methods of measurements and simulations represented different spatial and temporal scales that were shown to be complementary useful to quantify the different pathways of deicing salt in the roadside environment. Continuous simulations complemented with selected field monitoring should therefore be promoted. / QC 20100526