Return to search

Behavior of polygonal semi-closed thin-walled cross-section : A study based on finite strip analysis

The acceptance and the use of cold-formed steel sections has significantly increased in recent years due to advantages such as consistency and accuracy of profile, ease of fabrication, high strength and stiffness to the lightness in the weight. For thin-walled columns, made by folding a plane plate into a section, it is possible that when they are subjected to compression loads they may buckle either locally, if the member is very short, or globally if the member is very long. In addition to local and global buckling, a thin-walled member of an open cross section may also show buckling involving a “distortion” of the cross section. Compared to local and global buckling, distortional buckling is not very familiar and has been discovered only in thin-walled members of open cross sections such as cold-formed steel section columns. The objective of this study is to investigate the behavior of polygonal semi-closed cross-section with pure compression. The study comprise to only elastic buckling and the methodology is consisted by using CUFSM analysis. In order to execute CUFSM of polygonal profiles, the scripts have created which match the Matlab script files (m-files) downloaded from CUFSM 4 open source. The distortional buckling mode is governing as a buckling failure, which occur and dominate in the cases where spring values are 100 kN or higher. However, the contrary result reveals by a decreasing of the spring values. The behavior of the cross-section is dependent on how the interaction of different buckling modes prevails at the corresponding critical half-wavelength. Considering the predomination of distortional buckling mode indicates that the most of polygonal cross-section do not behave as rigid, i.e. as whole cross-section. A reducing of distortional mode and increasing of local mode as well as global mode gives indication that the behavior of the cross-section has changed and turned significantly into more rigid and thus is expected to behave more as whole cross-section.  The more spring values decrease, the higher global mode arises and dominates for the lower slenderness range. The critical half-wavelength for each profile illustrates the needed density between bolts on the longitudinal part of the member. In the interest of eliminating distortional buckling failure, due the fact that distortional buckling is unpredictable, the bolt-density should be lower than the corresponding half-wavelength for the profile where the distortional mode is predominating.

Identiferoai:union.ndltd.org:UPSALLA1/oai:DiVA.org:ltu-62257
Date January 2017
CreatorsJimmy, Adamo, Hamse, Abdi
PublisherLuleå tekniska universitet, Institutionen för samhällsbyggnad och naturresurser, Luleå tekniska universitet, Institutionen för samhällsbyggnad och naturresurser
Source SetsDiVA Archive at Upsalla University
LanguageEnglish
Detected LanguageEnglish
TypeStudent thesis, info:eu-repo/semantics/bachelorThesis, text
Formatapplication/pdf
Rightsinfo:eu-repo/semantics/openAccess

Page generated in 0.0024 seconds