Return to search

A Doherty Power Amplifier with Extended Bandwidth and Reconfigurable Back-off Level

Emerging wireless standards are designed to be spectrally efficient to address the high cost of licensing wireless spectra. Unfortunately, the resulting signals have a high peak-to-average ratio that reduces the base station power amplifier efficiency at the back-off power level. The wasted energy is converted to heat that degrades the device reliability and increases the base-station’s carbon footprint and cooling requirements. In addition, these new standards place stringent re- quirements on the amplifier output power, linearity, efficiency, and bandwidth.
To improve the back-off efficiency, a Doherty amplifier, which uses two device in parallel for back-off efficiency enhancement, is deployed in a typical base station. Unfortunately, the conventional Doherty amplifier is narrowband and thus cannot satisfy the bandwidth requirement of the modern base station that needs to support multiple standards and backward compatibility.
In this thesis, we begin by studying the class F/F−1 high efficiency mode of operation. To this end, we designed a narrowband, harmonically-tuned 3.3 GHz, 10 W GaN high efficiency amplifier. Next, we investigate how to simultaneously achieve high efficiency and broad bandwidth by harnessing the simplified real frequency technique for the broadband matching network design. A 2 to 3 GHz, 45 W GaN amplifier and a 650 to 1050 MHz, 45 W LDMOS amplifier were designed. Finally, we analyze the conventional Doherty amplifier to determine the cause of its narrow bandwidth. We find that the narrow bandwidth can be attributed to the band-limited quarter-wave transformer as well as the widely adopted traditional design technique.
As an original contribution to knowledge, we propose a novel Doherty amplifier configuration with intrinsically broadband characteristics by analyzing the load modulation concept and the conventional Doherty amplifier. The proposed amplifier uses asymmetrical drain voltage biases and symmetrical devices and it does not require a complex mixed-signal setup. To demonstrate the proposed concept in practice, we designed a 700 to 1000 MHz, 90 W GaN broadband Doherty amplifier. Moreover, to show that the proposed concept is applicable to high power designs, we designed a 200 W GaN broadband Doherty amplifier in the same band. In addition, to show that the technique is independent of the device technology, we designed a 700 to 900 MHz, 60 W LDMOS broadband Doherty amplifier. Using digital pre-distortion, the three prototypes were shown to be highly linearizable when driven with wideband 20 MHz LTE and WCDMA modulated signals and achieved excellent back-off efficiency.
Lastly, using the insights from the previous analyses, we propose a novel mixed-technology Doherty amplifier with an extended and reconfigurable back-off level as well as an improved power utilization factor. The reconfigurability of the proposed amplifier makes it possible to customize the back-off level to achieve the highest average efficiency for a given modulated signal without redesigning the matching networks. A 790 to 960 MHz, 180 W LDMOS/GaN Doherty amplifier demonstrated the extended bandwidth and reconfigurability of the back-off level. The proposed amplifier addresses the shortcomings of the conventional Doherty amplifier and satisfies the many requirements of a modern base station power amplifier.

Identiferoai:union.ndltd.org:LACETR/oai:collectionscanada.gc.ca:OWTU.10012/7385
Date03 1900
CreatorsWu, Yu-Ting David
Source SetsLibrary and Archives Canada ETDs Repository / Centre d'archives des thèses électroniques de Bibliothèque et Archives Canada
LanguageEnglish
Detected LanguageEnglish
TypeThesis or Dissertation

Page generated in 0.002 seconds