Return to search

CMOS-MEMS Probe Arrays for Tip-Based Nanofabrication

Scanning probe microscopy (SPM) tip-based nanofabrication (TBN) is a technique that directly creates a variety of nanostructures on a substrate using the nanoscale probe tips. SPM TBN possesses superior resolution and flexibility: nanostructures with feature size under 5 nm have been achieved via SPM TBN, which is beyond what the state-of-the art optical-based lithography technique can provide. However, the inherent serial nature of SPM TBN makes it a low throughput process. Multi-probe SPM systems have therefore been developed to increase the nanofabrication efficiency. Atomic force microscopy (AFM) and scanning tunneling microscopy (STM) are two most commonly used SPM TBN techniques. Most of prior work has focused on contact-mode AFM-based TBN. This work, using CMOS MEMS technology as the design and fabrication platform, develops an active conductive probe array that aims to perform parallel surface imaging and nanofabrication in non-contact STM mode. The CMOS-MEMS process provides a monolithic integration of MEMS devices with CMOS electronics that can facilitate future automation and parallel probe operation. The CMOS-MEMS probe adopts a micro-cantilever structure and applies bimorph electrothermal actuation to control the vertical displacement of the probe tips. The cantilever is designed to be stiff, with a spring constant of 36 N/m that is larger than the force gradient of the cantilever tip-sample interaction forces in the working distance regime of STM in order to avoid the tip-to-sample “snap-in” and ensure the stability of the STM feedback system. A modified Spindt tip process, compatible with post-CMOS MEMS processing, is developed to batch fabricate Ni/Pt composite tips on CMOS-MEMS probe arrays that are used as STM end-effectors. The integrated Ni/Pt tips on the MEMS probes have a tip radius down to 50 vii nm. The Spindt tip demonstrates the capability of both imaging and nanowire fabrication in STM mode. A hierarchical dual-servo STM system is constructed for the parallel STM imaging using two CMOS-MEMS probes. The system consists of a piezoelectric actuator-driven servo and an electrothermal actuator-driven servo to control the vertical displacement of two probe tips and maintain a constant current between the tips and the sample. Both servos use a proportionalintegral controller. The dual-servo STM system is capable of parallel STM image acquisition using CMOS MEMS probe arrays. An on-chip electrothermal proximity sensor pair and probes with embedded microgoniometers are designed to assist the alignment between the CMOS-MEMS probe array and the examined sample surface. The electrothermal proximity sensor pair is used to measure the separation and the non-parallelism between the probe chip and the sample. The electrothermal proximity sensor has a positioning accuracy of around 1 μm. An electrothermal microgoniometer platform is developed to hold a one-dimensional array of active CMOS-MEMS probes and serves to provide the in situ fine adjustment of relative height among these probes. The micro-goniometer has a maximum tilt of 1.2°, which is sufficient to compensate the probe chip-sample misalignment and the possible height difference among array probes introduced by process variations.

Identiferoai:union.ndltd.org:cmu.edu/oai:repository.cmu.edu:dissertations-1451
Date01 August 2014
CreatorsZhang, Yang
PublisherResearch Showcase @ CMU
Source SetsCarnegie Mellon University
Detected LanguageEnglish
Typetext
Formatapplication/pdf
SourceDissertations

Page generated in 0.0021 seconds