<p>At the Skoghall pappermill, sulphatepaper pulp is produced in a continuous digester originally from 1969. To be able to maintain a high level of production there is a need for a process with few disturbances. Variations in how well the wooden chips are packed in the digester is one form of disturbance. Today there are no available measurements on how well the chips are packed. Instead this is regarded as being constant. </p><p>The variation in the so called bulk density of the chips is mainly due to variations in the percentage with small dimensions. Chips are classified in relation to their size and one of the smallest classes is referred to as pin chips. These are believed to have a big impact on the bulk density. The amount of pin chips fluctuate more then the other classes, there by causing disturbances. </p><p>The Skoghall pappermill has invested in a ScanChip. This is an instrument that measures the dimensions of the chips optically. ScanChip presents figures on chip quality, including a measurement of the bulk density. However, it has been shown that this measurement is not valid for the Skoghall pappermill. By using data from ScanChip a model that predicts how well the chips are packed has been devised. This value is the bulk density divided by the basic density. The model has proved to yield good results, despite a relatively small amount of data. </p><p>A theoretical value of the amount of produced pulp has been computed based on the revolutions of the production screw that feeds chips into the digester. This value takes in consideration how well the chips are packed. The value has shown great similarities with the empirical measurements that are used today. A simulation during one month has shown that differences in the mixture of chips have effected the measurement of produced pulp with up to 7 ton/h. </p><p>Chips are stored in open pile storages before they are being used in the process of transforming them into pulp. Four screws are used to move chips from the piles to conveyer belts. It has been shown in work done previously, that the movement of the screws contributes to variations in the amount of pin chips measured by ScanChip. </p><p>During the work with this master’s thesis I have found that there are variations in the piles that make it difficult to predict the amount of pin chips accordingly. However by filtering the measurements of pin chips to remove these variations, the results are improved. A new way of controlling the movements of the screws was operational on the 10 of March and this improved the results. </p><p>The direction in which the screws are moving influence the speed of the screws, mainly in the pile with the so called sawmill chips. By changing the amount of chips that each screw puts out, the differences in speed have been reduced. The mixtures found in the two piles are not completely homogenous. There are a greater amount of pin chips in the northern parts compared with the southern parts. This could be an effect of the wind direction, and will still cause variations.</p>
| Identifer | oai:union.ndltd.org:UPSALLA/oai:DiVA.org:liu-2941 |
| Date | January 2005 |
| Creators | Ohlsson, Staffan |
| Publisher | Linköping University, Department of Electrical Engineering, Institutionen för systemteknik |
| Source Sets | DiVA Archive at Upsalla University |
| Language | Swedish |
| Detected Language | English |
| Type | Student thesis, text |
Page generated in 0.0012 seconds