Kesterite Cu2ZnSnS4 (CZTS) is interesting as a sustainable photovoltaic technology due to its earth-abundant elements and suitable semiconducting properties. To date, a record efficiency of 12.6% has been achieved but further improvements are required to reach high efficiency for industrial implementation. Among the limiting issues is the understanding of the annealing process, which is crucial in promoting high material quality. In particular, the knowledge of the effects of segregated secondary compounds on solar cell performance is lacking. In contrast to formation of ZnS particles throughout CZTS film, it is notable that SnS forms and usually segregates on the CZTS top and rear surfaces. The influence of SnS on CZTS solar cells was studied by electron beam induced current measurements. It is found that SnS presence on the CZTS surfacecan introduce “dead area”, whereas it seems beneficial for solar cell current when accumulates on the CZTS rear. For SnS passivation and from investigation of the passivation effect from an Al2O3 thin layer at the CZTS rear, improvement in overall device performance could not be demonstrated, due to either poor CZTS bulk or non-optimal device structure. The limitation in CZTS bulk quality was shown from a thickness study where carrier collection saturated already about 700-1000 nm CZTS thickness. Formation of SnS alongside CZTS implies the anneal is limited by a deficient sulfur partial pressure (PS2). By looking into Sn-S phase transformations in SnS2 films after annealing, we find that PS2 drops rapidly over the annealing time, which could be well-correlated to a series of changes in CZTS material quality including secondary phase formations and defect modifications. It is shown that annealing CZTS under sufficiently high PS2 is critical for CZTS solar cells with high open circuit voltage (upto 783mV was reached), possibly due to the defect modification. Besides SnS, it is observed that NaxS compounds are also readily formed on CZTS surfaces, due to Na diffusion from the glass substrate during annealing. NaxS negatively affects the formation of the CdS/CZTS interface during chemical bath deposition. It can be removed by an oxidation process or wet chemical etching.
Identifer | oai:union.ndltd.org:UPSALLA1/oai:DiVA.org:uu-314975 |
Date | January 2017 |
Creators | Ren, Yi |
Publisher | Uppsala universitet, Fasta tillståndets elektronik, Uppsala |
Source Sets | DiVA Archive at Upsalla University |
Language | English |
Detected Language | English |
Type | Doctoral thesis, comprehensive summary, info:eu-repo/semantics/doctoralThesis, text |
Format | application/pdf |
Rights | info:eu-repo/semantics/openAccess |
Relation | Digital Comprehensive Summaries of Uppsala Dissertations from the Faculty of Science and Technology, 1651-6214 ; 1476 |
Page generated in 0.0016 seconds