Return to search

Truck transport emissions model

In the past, transportation related economic analysis has considered agency related costs only. However, transportation managers are moving towards more holistic economic analysis including road user and environmental costs and benefits. In particular, transportation air pollution is causing increasing harm to health and the environment. Transport managers are now considering related emissions in transport economical analyses, and have established strategies to help meet Kyoto Protocol targets, which specified a fifteen percent reduction in Canada's emissions related to 1990 levels within 2008-2012.<p>The objectives of this research are to model heavy vehicle emissions using a emissions computer model which is able to assess various transport applications, and help improve holistic economic transport modeling. Two case studies were evaluated with the model developed.<p>Firstly, the environmental benefits of deploying weigh-in-motion systems at weigh stations to pre-sort heavy vehicles and reduce delays were assessed. The second case study evaluates alternative truck sizes and road upgrades within short heavy oilfield haul in Western Canada. <p>The model developed herein employed a deterministic framework from a sensitivity analysis across independent variables, which identified the most sensitive variables to primary field state conditions. The variables found to be significant included idling time for the weigh-in-motion case study, road stiffness and road grades for the short heavy haul oilfield case study.<p>According to this research, employing WIM at weigh stations would reduce annual Canadian transportation CO<sub>2</sub> emissions by nearly 228 kilo tonnes, or 1.04 percent of the Canadian Kyoto Protocol targets. Regarding direct fuel savings, WIM would save from 90 to 190 million litres of fuel annually, or between $59 and $190 million of direct operating costs.<p>Regarding the short heavy oil haul case study, increasing allowable heavy vehicle sizes while upgrading roads could decrease the annual emissions, the fuel consumption, and their associated costs by an average of 68 percent. Therefore, this could reduce each rural Saskatchewan municipality's annual CO<sub>2</sub> emissions from 13 to 26.7-kilo tonnes, which translates to 0.06 and 0.12 percent of the Canadian Kyoto Protocol targets or between $544,000 and $ 1.1 million annually. <p>Based on these results, the model demonstrates its functionality, and was successfully applied to two typical transportation field state applications. The model generated emissions savings results that appear to be realistic, in terms of potential Kyoto targets, as well as users cost reductions and fuel savings.

Identiferoai:union.ndltd.org:USASK/oai:usask.ca:etd-09072007-101348
Date17 September 2007
CreatorsCouraud, Amelie
ContributorsSparks, Gordon A., Pufahl, Dennis E., Hertz, P. Barry, Berthelot, Curtis
PublisherUniversity of Saskatchewan
Source SetsUniversity of Saskatchewan Library
LanguageEnglish
Detected LanguageEnglish
Typetext
Formatapplication/pdf
Sourcehttp://library.usask.ca/theses/available/etd-09072007-101348/
Rightsrestricted, I hereby certify that, if appropriate, I have obtained and attached hereto a written permission statement from the owner(s) of each third party copyrighted matter to be included in my thesis, dissertation, or project report, allowing distribution as specified below. I certify that the version I submitted is the same as that approved by my advisory committee. I hereby grant to University of Saskatchewan or its agents the non-exclusive license to archive and make accessible, under the conditions specified below, my thesis, dissertation, or project report in whole or in part in all forms of media, now or hereafter known. I retain all other ownership rights to the copyright of the thesis, dissertation or project report. I also retain the right to use in future works (such as articles or books) all or part of this thesis, dissertation, or project report.

Page generated in 0.0021 seconds