The proposed energy harvesting circuit system is designed for indoor solar environment especially for factories where the light energy is abundant and stable. The designed circuits are intended to power wireless sensor nodes (WSNs) or other computing unit such as microcontrollers or DSPs to provide a power solution for Internet of Things (IoTs). The proposed circuit can extract maximum power from the PV panel by utilizing the maximum power point tracking (MPPT) technique. The power stage is a synchronous dual-input dual-output non-inverting buck-boost converter operating in discontinuous conduction mode (DCM) and constant on-time pulse skipping modulation (COT-PSM) to achieve voltage regulation and maximum power delivery to the load. Battery is used as secondary input also as secondary output to achieve a longer lifecycle, a fast load response time and support higher load conditions. The proposed MPPT technique doesn't require any current sensor or computing units. Fully digitalized simple circuits are used to achieve sampling, store, and comparing tasks to save power.
The whole circuits including power stage and control circuits are designed and will fabricate in TSMC BCDMOS 180 nm process. The circuits are verified through schematic level simulations and post-layout simulations. The results are validated to prove the proposed circuit and control scheme work in a manner. / Master of Science / With the growing energy demands, the efficient energy conversion systems caught great attentions. Especially, in the era of Internet of Things, powering those wireless devices can be extremely difficult. Nowadays, lots of devices such as consumer electronics, wireless sensor nodes, computing and mission system etc. are still powered by the batteries. Regular changing the batteries of those devices can be inconvenient or expensive. Energy harvesting provides a good solution to this issue because there are lots of ambient energy source is available. To design an energy efficient energy harvesting circuit system can help extend the device lifecycle per charging cycle. Even with some specific energy source which power scale is high enough, meanwhile the load doesn’t require too much power, the devices can be power-independent or standalone. In this work, the proposed circuit targets for indoor solar energy harvesting via solar panel. The target powering devices are wireless sensor nodes (WSNs). Meanwhile, WSNs can monitor the temperature, humidity, pressure, noise level etc. The proposed circuit design combines the power stage and control circuit on an integrated chip (IC), only few components are off-chip. It provides a very compact, endurable, and economical solution to the current IoT powering issue.
| Identifer | oai:union.ndltd.org:VTETD/oai:vtechworks.lib.vt.edu:10919/94319 |
| Date | 01 October 2019 |
| Creators | Wang, Junjie |
| Contributors | Electrical Engineering, Ha, Dong S., Yi, Yang, Li, Qiang |
| Publisher | Virginia Tech |
| Source Sets | Virginia Tech Theses and Dissertation |
| Detected Language | English |
| Type | Thesis |
| Format | ETD, application/pdf |
| Rights | In Copyright, http://rightsstatements.org/vocab/InC/1.0/ |
Page generated in 0.0139 seconds