<p>Tractors of today come equipped with a CAN-system. A CAN-system sends information from sensors to electronic control units who process the signals. The sensors measure several interesting parameters such as force, pressure and speed for various components of the tractor. This thesis discuss a force sensor which is placed in the pivot of the tractors three point linkage, the sensor measure the horizontal reaction force from the load that the tractor is exposed to. Signals from this sensor can be used to measure the force from any implement that the tractor is exposed to during an operation. The results from this thesis can be used for research purposes, for example, to compare implements from different manufacturer or to optimize the implement settings during an operation. However, there is a problem that this thesis aimed to solve by developing a method which can be put into practice. When a constant force from an implement is acting on the three point linkage, the reaction force in the pivot of the three point linkage (where the force sensor is attached) is going to vary depending on the angel of the lower lift arm. It is not uncommon that the angel of the lower lift arm is varying, because different implement and soil require different settings on the linkage. This means that the force which is measured by the sensor may vary in size even though the actual force does not vary. To solve this problem, theoretical calculations have been performed and equations to describe the variation of the reaction force depending on the geometry have been created. The theory has also been verified by a finite element analysis and a practical verification test. The conclusions from these three parts correspond to each other. Theoretically that means by knowing the horizontal reaction force (measured by the force sensor) and the angles of the geometry on the three point linkage (can be measured with a position sensor) you can calculate the force an implement influence the tractor with. However, there is a problem which prevents this method from being completely reliable. It is only working when the impact force is completely parallel to the horizontal plane. Since many implements are being pulled to the soil (plow, cultivator, etc.) in practice there are also vertical forces affecting the tractor. This is no problem to solve in theory, but in practice this method does not compensate for the vertical force. This vertical force should be examined more carefully before the method can be used reliably in full scale.</p>
| Identifer | oai:union.ndltd.org:UPSALLA/oai:DiVA.org:uu-126750 |
| Date | January 2010 |
| Creators | Erlandsson, Johan |
| Publisher | Uppsala University, Industrial Technology |
| Source Sets | DiVA Archive at Upsalla University |
| Language | Swedish |
| Detected Language | English |
| Type | Student thesis, text |
Page generated in 0.014 seconds