Back to search

Michigan Technological University

FATIGUE RESISTANT CAST STEEL RAILCAR COUPLERS PRODUCED BY WIRE-ARC ADDITIVE MANUFACTURING (WAAM)

Abstract

dc:description.abstract

Every year, approximately 90,000 cast steel railcar coupler knuckles are replaced preemptively to avoid fatigue failure. The coupler geometry has been in service since the early 1930s, so geometry changes are restricted to maintain compatibility with the existing fleet. Defects from the casting process, decarburization during heat treatment, and in-service exposure to corrosive environments combine to promote fatigue crack nucleation in high-stress regions of the knuckle. Wire-arc additive manufacturing (WAAM), which uses traditional welding techniques to build material to near-net shapes, was employed to deposit higher-strength materials in critical regions. By replacing the cast steel in the high-stress region of the coupler knuckle with WAAM deposits resistant to corrosion and fatigue, the knuckle's service life can be improved while retaining the original geometry. WAAM deposition before heat treatment enables post-weld microstructure uniformity and residual stress relief. A Dynasty 280 gas-tungsten arc welder (GTAW) was coupled with a computer-numerical control (CNC) Cartesian system to produce repeatable WAAM deposits. Material selection focused on alloying to promote finer microstructure and corrosion resistance while mitigating decarburization. Rapid solidification during WAAM produced a finer microstructure with less porosity and improved fatigue resistance than the baseline cast steel as observed with optical microscopy. Tensile properties of the ER120s-1 WAAM deposits meet or exceed the coupler knuckle material specifications after post-weld heat treatment. The corrosive susceptibility of both the cast coupler 5 knuckle steel and WAAM deposits were found to be similar via potentiodynamic polarization. Rotary bend fatigue S-N curves were used to compare the weld material to cast steel in ambient and corrosive salt-fog environments. Corrosive environments degraded the WAAM materials that were initially superior fatigue life to almost equivalent to that of the cast steel knuckle. Flexural fatigue was used to assess weld interactions at the heat-affected zone and fusion zone compared to the cast steel substrates. After positive results in specimen fatigue analysis, finite element analysis was used to map the high-stress regions within the knuckle for reinforcement via WAAM.

Degree

thesis:*
Name thesis:degree_name
Master of Science in Materials Science and Engineering (MS)
Level thesis:degree_level
Open Access Master's Thesis
Discipline thesis:degree_discipline
Department of Materials Science and Engineering

Author and committee

dc:creator, dc:contributor.*
Author dc:creator
  • Vellequette, Samuel
Committee members dc:contributor.committeemember
  • Stephen Kampe
  • Daniel Seguin
  • Joshua Mueller
Contributors dc:contributor
  • Paul Sanders

Subjects

dc:subject × 8

Rights

Identifiers

dc:identifier.*

Chain of custody

source
Harvested from
Michigan Technological University
Base URL
digitalcommons.mtu.edu/do/oai/
Last updated
2026-11-19
Source record
OAI-PMH GetRecord
citation

Vellequette, Samuel. FATIGUE RESISTANT CAST STEEL RAILCAR COUPLERS PRODUCED BY WIRE-ARC ADDITIVE MANUFACTURING (WAAM). Open Access Master's Thesis thesis, https://doi.org/10.37099/mtu.dc.etdr/1874