Back to search

NJIT

Wear of polyethylene and hylamer on cobalt-chromium : a knee simulator study

Abstract

dc:description.abstract

Two tests were conducted to examine the wear characteristics of tibial bearings used in total knee replacement systems. Each test consisted of six A/P Glide Tibial Bearings each having a conical control arm. The plastic portion of the conical bearings were all made of UHMWPe. Each of these bearing systems was mounted onto a Co-Cr alloy tibial platform and Co-Cr alloy LCS (low contact stress) femoral component . These test samples were mounted onto the New Jersey Mark III Knee Simulator System. The simulator was configured to produce flexion and axial rotation to simulates normal gait. Each test ran at 2 Hz with saline being sprayed between articulating surfaces. Simulation I tested six UHMWPe bearings with an off-center load applied to the bearing by the femoral component 25 from the articulating surface segment tangent. Simulation II tested three Hylamer and three UHMWPe bearings without an off-center load. Hylamer 's volumetric loss and wear rate were found to be higher then UHMWPe. Hylamer had a maximum volumetric loss of 12.86 mm^3 and a maximum wear rate of 6.19 mm^3/million cycles while UHMWPe had a maximum volumetric loss of 3.57 mm^3 and a maximum wear rate of 1.67 mm^3/million cycles. Hylamer increase in crystallinity slightly increases its yield strength and ultimate tensile strength. However, by increasing the crystallinity, stiffness is also increased. This increase in stiffness increases the contact stress which in turn increases the wear. Although a slight increase in strength is gained when using Hylamer , wear resistance, an important characteristic for total knee replacement systems, is reduced.

Degree

thesis:*
Name thesis:degree_name
Master of Science in Biomedical Engineering - (M.S.)
Discipline thesis:degree_discipline
Biomedical Engineering Committee

Author and committee

dc:creator, dc:contributor.*
Author dc:creator
  • Canonaco, Alessandro F.
Contributors dc:contributor
  • Clarence W. Mayott
  • Michael Pappas
  • Georghios Makris

Subjects

dc:subject × 8

Identifiers

dc:identifier.*
Repository record dc:identifier
https://digitalcommons.njit.edu/theses/1173

Chain of custody

source
Harvested from
NJIT
Base URL
digitalcommons.njit.edu/do/oai/
Last updated
2026-11-19
Source record
OAI-PMH GetRecord
citation

Canonaco, Alessandro F.. Wear of polyethylene and hylamer on cobalt-chromium : a knee simulator study. https://digitalcommons.njit.edu/theses/1173