Back to search

University of North Florida. School of Engineering

Mechanical behavior of additively manufactured TI-6AL-4V ELI parts: Effects of laser parameter selection

Abstract

dc:description.abstract

Additive manufacturing (AM) of TI-6AL‑4V Extra‑Low Interstitial (ELI) enables complex geometries for fatigue‑critical medical device applications, yet fatigue performance remains sensitive to process‑induced defects. This work investigates the effect of laser process parameter selection on the microstructure, mechanical properties, and fatigue behavior of TI- 6AL‑4V ELI fabricated via laser powder bed fusion (L‑PBF) using a Renishaw RenAM system. The influence of laser parameters was isolated by holding powder chemistry, build orientation, scan strategy, sub‑transus annealing, and post‑processing constant between a non‑optimized baseline and an optimized parameter set selected based on tensile performance. Optical microscopy showed the optimized condition exhibited improved microstructural quality, reflected by reduced porosity and less pronounced raster track features, consistent with improved melt pool stability. Tensile testing demonstrated increased ultimate tensile strength and elongation to failure for the optimized condition. Four‑point bending fatigue tests conducted in accordance with ASTM F382 revealed higher mean fatigue life and the occurrence of runout specimens at lower applied stress levels relative to the baseline condition, while higher stress levels produced increased scatter. Fractographic analysis confirmed surface‑initiated fatigue cracking associated with surface‑connected lack‑of‑fusion defects in both conditions, with reduced defect severity observed for optimized specimens. The experimentally observed crack initiation locations were consistent with stress concentration regions identified using finite element analysis of the ASTM F382 test configuration. These results suggest that tensile‑based laser parameter selection may be an effective approach for improving fatigue performance in AM TI-6AL‑4V ELI, while highlighting the importance of surface defect mitigation for fatigue‑critical medical device applications.

Degree

thesis:*
Name thesis:degree_name
Master of Science in Material Science & Engineering (MS)
Discipline thesis:degree_discipline
Engineering
Grantor
University of North Florida. School of Engineering
Date dc:date.issued
Spring

Author and committee

dc:creator, dc:contributor.*
Authors dc:creator
  • Lopez, Samuel
  • Lopez, Samuel, Jr., 1977-
Advisors dc:contributor.advisor
  • Simsiriwong, Jutima
  • de Campos Neto, Nelson Delfino
  • Schonning, Alexandra
  • Mikhaylova, Albina
Contributors dc:contributor
  • Dr. Jutima Simsiriwong
  • Dr. Nelson Delfino de Campos Neto
  • Dr. Alexandra Schonning
  • Dr. Albina Mikhaylova

Subjects

dc:subject × 14

Rights

dc:rights

Identifiers

dc:identifier.*
Repository record dc:identifier
https://digitalcommons.unf.edu/etd/1406

Chain of custody

source
Harvested from
University of North Florida
Base URL
digitalcommons.unf.edu/do/oai/
Last updated
2026-11-18
Source record
OAI-PMH GetRecord
citation

Lopez, Samuel; Lopez, Samuel, Jr., 1977-. Mechanical behavior of additively manufactured TI-6AL-4V ELI parts: Effects of laser parameter selection. University of North Florida. School of Engineering, https://digitalcommons.unf.edu/etd/1406