Back to search

University of South Florida

Analysis of Flow in a 3D Chamber and a 2D Spray Nozzle to Approximate the Exiting Jet Free Surface

Abstract

dc:description

The purpose of this investigation is to analyze the flow pattern of cooling fluids in the 3D "twister-effect" mixing chamber and to approximate the free surface behaviors exiting the 2D spray nozzle. The cone angle and free surface height located at the end of the free surface are two significant factors to determine the spraying area on a heated plane. This process is a reasonable representation of many industrial cooling application. The whole system consists of 4 inlet tubes connected to the top of the mixing chamber, and the spray nozzle is located under the chamber. Four different refrigerants, like FC-72, FC-77, FC-87 and methanol were used for the turbulent flow simulations. According to different fluid properties, the cone angle, free surface, pressure drop and Reynolds number can be investigated at different flow rates. First, at a certain volumetric flow rates, the velocities in x, y, z directions were found on the positive x-axis (0 degree), y-axis (90 degrees), negative x-axis (180 degrees) and y-axis (270 degrees) at 8.0 x 10-4m below the top of chamber. After the transformations, the interpolated and averaged radial, circumferential and axial velocities were used in the 2D nozzle simulations. Finally, the cone angle, the radial locations of the free surface and the pressure drop were obtained in each scenario. As the results, higher volumetric flow rate produced higher free surface height and cone angle. Also, FC-87 created the highest free surface height and cone angle among all four working fluids in both volumetric flow rates. It means that FC-87 can produce the largest spraying area on the heated surface. Fluctuation, spinning and eddy circulation can be found in the velocity plot because of the turbulent flow syndromes. When comparing two different nozzle designs, it was found that the nozzle without mixing chamber gave a larger cone angle and free surface height. Alternatively, the design in this investigation produced a relatively narrow jet concentrated to the stagnation zone.

Degree

thesis:*
Level thesis:degree_level
Thesis
Discipline thesis:degree_discipline
Mechanical Engineering
Grantor
University of South Florida
Year dc:date
2004

Author and committee

dc:creator, dc:contributor.*
Author dc:creator
  • Hong, Chin Tung
Contributors dc:contributor
  • Muhammad M. Rahman, Ph.D.
  • Thomas Eason, Ph.D.
  • Autar K. Kaw, Ph.D.

Subjects

dc:subject × 7

Rights

Language dc:language
EN-US

Identifiers

dc:identifier.*
Repository record dc:identifier
https://digitalcommons.usf.edu/etd/1083

Chain of custody

source
Harvested from
University of South Florida
Base URL
digitalcommons.usf.edu/do/oai/
Last updated
2026-11-19
Source record
OAI-PMH GetRecord
citation

Hong, Chin Tung. Analysis of Flow in a 3D Chamber and a 2D Spray Nozzle to Approximate the Exiting Jet Free Surface. Thesis thesis, University of South Florida, 2004. https://digitalcommons.usf.edu/etd/1083