Back to search

Virginia Commonwealth University

Evaluation of fit for 3D printed retainers as compared to thermoform retainers

Abstract

dc:description.abstract

ABSTRACT EVALUATION OF FIT FOR 3D PRINTED RETAINERS AS COMPARED TO THERMOFORM RETAINERS By David Cole, D.M.D. A thesis submitted in partial fulfillment of the requirements for the degree of Master of Science in Dentistry at Virginia Commonwealth University Thesis Directors: Eser Tüfekçi, D.D.S., M.S., Ph.D., M.S.H.A. Professor, Department of Orthodontics Sompop Bencharit, D.D.S., M.S., Ph.D. Associate Professor and Director of Digital Dentistry, Department of General Practice Introduction: Despite recent advances in three-dimensional (3D) printing, little information is available on 3D printed retainers Methods: Three reference models were used to fabricate traditional vacuum formed, commercially-available vacuum formed, and 3D printed retainers. For each model, three retainers were made using the three methods (a total of 27 retainers). To determine the trueness, the distances between the intaglio surface of the retainers and the occlusal surface of the reference models were measured using an engineering software. A small difference was indicative of a good fit. Results: Average differences of the traditional vacuum formed retainers ranged from 0.10 to 0.20mm. The commercially-available and 3D printed retainers had a range of 0.10 to 0.30mm and 0.10 to 0.40mm, respectively. Conclusions: The traditional vacuum formed retainers showed the least amount of deviation from the original reference models while the 3D printed retainers showed the greatest deviation.

Degree

thesis:*
Name thesis:degree_name
Master of Science in Dentistry
Level thesis:degree_level
Dissertation
Discipline thesis:degree_discipline
Dentistry

Author and committee

dc:creator, dc:contributor.*
Author dc:creator
  • Cole, David J
Contributors dc:contributor
  • Eser Tufekci
  • Sompop Bencharit
  • Caroline Carrico

Subjects

dc:subject × 8

Rights

dc:rights
Statement dc:rights
  • © The Author

Identifiers

dc:identifier.*

Chain of custody

source
Harvested from
Virginia Commonwealth University
Base URL
scholarscompass.vcu.edu/do/oai/
Last updated
2026-11-19
Source record
OAI-PMH GetRecord
citation

Cole, David J. Evaluation of fit for 3D printed retainers as compared to thermoform retainers. Dissertation thesis, https://doi.org/10.25772/AWRV-2E28