International Telemetering Conference Proceedings / October 23-26, 2000 / Town & Country Hotel and Conference Center, San Diego, California / Bit error rate (BER) and bandwidth efficiency of several variations of enhanced Feher patented quadrature phase shift keying (FQPSK) [1] are described. An enhanced FQPSK increases the channel packing density of that of the IRIG 106-00 standardized FQPSK-B by approximately 50% in adjacent channel interference (ACI) environment. As the bandwidth efficiency of FQPSK-B DOUBLES (2×) that of pulse code modulation/Frequency modulation (PCM/FM) [5], the enhanced FQPSK, with a simpler transceiver than FQPSK-B, has a channel packing density of TRIPLE (3×) that of PCM/FM. One of the other enhanced FQPSK prototypes has an end to end system loss of only 0.4 dB at BER=1x10^(-3) and 0.5 dB at BER=1x10^(-4) from ideal linearly amplified QPSK theory. The enhanced FQPSK has a simple architecture, thus is inexpensive and has small size, for ultra high bit rate implementation. With low redundancy forward error correction (FEC) coding which expands the spectrum by approximately 10%, further improvement of about 3-4.5dB E N b o is attained with NLA FQPSK-B and enhanced FQPSK at BER=1x10^(-5) .

One would like to evaluate and compare complex digital communication systems based upon their overall bit error rate. Unfortunately, analytical expressions for bit error rate for even simple communication systems are notoriously difficult to evaluate accurately. Therefore, communication engineers often resort to simulation techniques to evaluate these error probabilities. In this thesis importance sampling techniques (variations of standard Monte Carlo methods) are studied in relation to both linear and non-linear detectors. Quick simulation, an importance sampling method based upon the asymptotics of the error estimator, is studied in detail. The simulated error probabilities are compared to values obtained by numerically inverting Laplace Transform expressions for these quantities.

A diminuição no tamanho dos transistores vem aumentando cada vez mais o número de funções que os dispositivos eletrônicos podem realizar. Apesar da diminuição do tamanho mínimo dos transistores, a velocidade máxima dos circuitos não consegue seguir a mesma taxa de aumento. Um dos grandes culpados apontados pelos pesquisadores são as interconexões entre os transistores e também entre os componentes. O aumento no número de interconexões dos circuitos traz consigo um significativo aumento do cosumo de energia, aumento do atraso de propagação dos sinais, além de um aumento da complexidade e custo do projeto dos circuitos integrados. Como uma possível solução a este problema é proposta a utilização de lógica multivalorada, mais especificamente, a lógica quaternária. Os dispositivos FPGAs são caracterizados principalmente pela grande flexibilidade que oferecem aos projetistas de sistemas digitais. Entretanto, com o avanço nas tecnologias de fabricação de circuitos integrados e diminuição das dimensões de fabricação, os problemas relacionados ao grande número de interconexões são uma preocupação para as próximas tecnologias de FPGAs. As tecnologias menores que 90nm possuem um grande aumento na taxa de erros dos circuitos, na lógica combinacional e sequencial. Apesar de algumas potenciais soluções começara a ser investigadas pela comunidade, a busca por circuitos tolerantes a erros induzidos por radiação, sem penalidades no desempenho, área ou potência, ainda é um assunto de pesquisa em aberto. Este trabalho propõe o uso de circuitos quaternários com modificações para tolerar falhas provenientes de eventos transientes. Como principal contribuição deste trabalho destaca-se o desenvolvimento de uma CLB (do inglês Configurable Logic Block) quaternária capaz de suportar eventos transientes e, na possibilidade de um erro, evitá-lo ou corrigi-lo. / The decrease in transistor size is increasing the number of functions that can be performed by the electronic devices. Despite this reduction in the transistors minimum size, the circuit’s speed does not follow the same rate. One of the major reasons pointed out by researchers are the interconnections between the transistors and between the components. The increase in the number of circuit interconnections brings a significant increase in energy consumption, propagation delay of signals, and an increase in the complexity and cost of new technologies IC designs. As a possible solution to this problem the use of multivalued logic is being proposed, more specifically, the quaternary logic. FPGA devices are characterized mainly by offering greater flexibility to designers of digital systems. However, with the advance in IC manufacturing technologies and the reduced size of the minimum fabricated dimensions, the problems related to the large number of interconnections are a concern for future technologies of FPGAs. The sub 90nm technologies have a large increase in the error rate of its functions for the combinational and sequential logic. Although potential solutions are being investigated by the community, the search for circuits tolerant to radiation induced errors, without performance, area, or power penalties, is still an open research issue. This work proposes the use of quaternary circuits with modifications to tolerate faults from transient events. The main contribution of this work is the development of a quaternary CLB (Configurable Logic Block) able to withstand transient events and the occurrence of soft errors.

<p>This thesis work started with an extensive literature study in several areas, ZigBee, instruments and measuring methods. The knowledge was implemented in use with the ZigBee modules from the two manufacturers ITN and Chipcon along with ZigBee Software Stack. Measuring methods were developed and software in ZigBee software Stack was developed to use in the ZigBee modules for the measurements. Developing measurement methods and performing measurements was an iterative process for the different measurements. The aim was to characterize the ZigBee modules in the most important areas during the extent of this master thesis work.</p>

<p>The society expects a global interconected digital communication system offering multimedia services, information on demand and interchange of information with a high data rates and low cost. </p><p>All this can not be realized with the terrestrial nets used nowadays cause it is necessary a high economic inversion to get a competitive capacity to interchange information between server and user. The next generation of satellite must have characteristics which improve the current generation, one important requirement is that the same satellite could make a treatment of the different input signals. With this we can avoid a spent of lots of money and time because we do not need terrestrial stations which modify the signals before the information is sent to the satellite.</p><p>For all this, we need an on board treatment of the information in the satellite. We design a frequency bank reallocation (FBR) network by using a filter bank system. This is the first step of the thesis. After we get FBR we introduce some different input signals and analyze the output, using parameters like symbol error rate and variance.</p><p>One important part in the thesis is the QAM signals used to test our system. For this, we design a modulator and a demodulator of QAM4, 16 and 64, paying more attention in the QAM64, cause is the modulation where more errors can appear due to we have got more possible chances which means more precision in the recovery of the signal.</p>

The society expects a global interconected digital communication system offering multimedia services, information on demand and interchange of information with a high data rates and low cost. All this can not be realized with the terrestrial nets used nowadays cause it is necessary a high economic inversion to get a competitive capacity to interchange information between server and user. The next generation of satellite must have characteristics which improve the current generation, one important requirement is that the same satellite could make a treatment of the different input signals. With this we can avoid a spent of lots of money and time because we do not need terrestrial stations which modify the signals before the information is sent to the satellite. For all this, we need an on board treatment of the information in the satellite. We design a frequency bank reallocation (FBR) network by using a filter bank system. This is the first step of the thesis. After we get FBR we introduce some different input signals and analyze the output, using parameters like symbol error rate and variance. One important part in the thesis is the QAM signals used to test our system. For this, we design a modulator and a demodulator of QAM4, 16 and 64, paying more attention in the QAM64, cause is the modulation where more errors can appear due to we have got more possible chances which means more precision in the recovery of the signal.

This thesis work started with an extensive literature study in several areas, ZigBee, instruments and measuring methods. The knowledge was implemented in use with the ZigBee modules from the two manufacturers ITN and Chipcon along with ZigBee Software Stack. Measuring methods were developed and software in ZigBee software Stack was developed to use in the ZigBee modules for the measurements. Developing measurement methods and performing measurements was an iterative process for the different measurements. The aim was to characterize the ZigBee modules in the most important areas during the extent of this master thesis work.

For channel estimation without data-induced interference in data-dependent superimposed training (DDST) scheme, the data sequence is shifted by subtracting a data-dependent sequence before added to training sequence at transmitter. The distorted term causes the data identification problem (DIP) at the receiver. In this thesis, we propose two precoding schemes based on previous work. To maintain low peak-to-average power ratio (PAPR), the precoding matrix is restricted to a diagonal matrix. The first scheme is proposed to enlarge the minimum distance between the closest codewords, termed as efficient diagonal scheme. Conditions to make sure the precoding matrix is efficient for M-ary phase shift keying (MPSK) and M-ary quadrature amplitude modulation (MQAM) modulation are listed in this paper. The second scheme pursues a lowest complexity at receiver which means the amount of searching set is reduced. It is a trade-off between the better bit error rate (BER) performance and a lower complexity at receiver. The simulation results show that PAPR have been improved and the DIP is solved in both schemes.

The main topic of this thesis is based on multiple-input multiple-output (MIMO) wireless communications, which is a novel technology that has attracted great interest in the last twenty years. Conventional MIMO systems using up to eight antennas play a vital role in the urban cellular network, where the deployment of multiple antennas have significantly enhanced the throughput without taking extra spectrum or power resources. The massive MIMO systems “scales” up the benefits that offered by the conventional MIMO systems. Using sixty four or more antennas at the BS not only improves the spectrum efficiency significantly, but also provides additional link robustness. It is considered as a key technology in the fifth generation of mobile communication technology standards network, and the design of new algorithms for these two systems is the basis of the research in this thesis. Firstly, at the receiver side of the conventional MIMO systems, a general framework of bit error rate (BER) approximation for the detection algorithms is proposed, which aims to support an adaptive modulation scheme. The main idea is to utilize a simplified BER approximation scheme, which is based on the union bound of the maximum-likelihood detector (MLD), whereby the bit error rate (BER) performance of the detector for the varying channel qualities can be efficiently predicted. The K-best detector is utilized in the thesis because its quasi- MLD performance and the parallel computational structure. The simulation results have clearly shown the adaptive K-best algorithm, by applying the simplified approximation method, has much reduced computational complexity while still maintaining a promising BER performance. Secondly, in terms of the uplink channel estimation for the massive MIMO systems with the time-division-duplex operation, the performance of the Grassmannian line packing (GLP) based uplink pilot codebook design is investigated. It aims to eliminate the pilot contamination effect in order to increase the downlink achievable rate. In the case of a limited channel coherence interval, the uplink codebook design can be treated as a line packing problem in a Grassmannian manifold. The closed-form analytical expressions of downlink achievable rate for both the single-cell and multi-cell systems are proposed, which are intended for performance analysis and optimization. The numerical results validate the proposed analytical expressions and the rate gains by using the GLP-based uplink codebook design. Finally, the study is extended to the energy efficiency (EE) of the massive MIMO system, as the reduction carbon emissions from the information and communication technology is a long-term target for the researchers. An effective framework of maximizing the EE for the massive MIMO systems is proposed in this thesis. The optimization starts from the maximization of the minimum user rate, which is aiming to increase the quality-of-service and provide a feasible constraint for the EE maximization problem. Secondly, the EE problem is a non-concave problem and can not be solved directly, so the combination of fractional programming and the successive concave approximation based algorithm are proposed to find a good suboptimal solution. It has been shown that the proposed optimization algorithm provides a significant EE improvement compared to a baseline case.

[pt] Os sistemas de comunicações ópticas no espaço livre (Free Space Optics - FSO) tem sido desenvolvidos nos últimos anos no Brasil, contudo ha poucas referencias de estudos realizadas em território nacional. Neste tipo de sistema, um feixe de laser pode carregar informação de um ponto para outro através de uma distância curta (3-4 km), evitando-se o uso das fibras ópticas. Por tanto, FSO tornou-se uma alternativa rápida e muito econômica, principalmente nas áreas urbanas. Este trabalho apresenta um procedimento para a análise, modelamento, e um teste experimental do Free-Space Optics (FSO) é apresentado; sendo realizado dentro do perímetro urbano da cidade do Rio de Janeiro, em 2002. Inicialmente, as características do transmissor e do receptor foram consideradas. Adicionam-se três parâmetros: a perda atmosférica, a perda geométrica e a cintilação. Subseqüentemente, todas as perdas, incluindo outros parâmetros que tratam das perdas adicionais foram expressas em dB e inseridas em uma equação de balanço de potência. A disponibilidade do sistema de FSO é exibida, usando os dados de visibilidade de dois aeroportos, e conduzindo a uma predição sistemática da disponibilidade. Uma atenção especial é focalizada no parâmetro da taxa de erro de bits (BER), que está relacionada com a Recomendação ITU- T G.826. Dentro esta última recomendação, é possível realizar uma análise do FSO com relação à variação climática. A experiência abrangeu períodos curtos em que o Rio de Janeiro apresentou uma névoa forte da manhã. Mostra-se, finalmente, que FSO é uma tecnologia competitiva e confiável na transmissão, desde que seja usada de forma correta e apropriada. / [en] Very few works had been developed in Brazil, dealing with Free-Space Optics (FSO). In this arrangement, a laser beam carries information for a short range (up to 3-4 km), avoiding the use of optical fiber. FSO is a rapidly-improved solution and very economical, specifically in urban areas. In this work a FSO system operating in Rio is described. This work presents a procedure for the analysis, modeling, and a practical trial of a Free-Space Optics (FSO) system is presented. The procedure has been conducted in the urban area of Rio de Janeiro, in 2002. Firstly, the transmitter and receiver characteristics are considered. Next, three additional parameters are introduced: atmospheric loss, geometric loss and scintillation. In this last parameter, a few ways how scintillation might be expressed in dB and translated into a power balance equation, it presents. Other fixed parameters, dealing with additional losses, are subsequently inserted. The FSO system availability is exhibited, using airports visibility data, leading to a prediction of the systemic availability. Attention is then focused on the Bit Error Rate, BER, which relates with the Recommendation ITU- T G.826. Within this last Recommendation, it shows how to perform a FSO analysis with respect to the climatic variation. The experiment has encompassed some short periods in which this city presents a strong morning fog. It is finally shown that FSO is a competitive and reliable transmission technology, provided proper and correct use.