International Telemetering Conference Proceedings / October 18-21, 2004 / Town & Country Resort, San Diego, California / Multiple-input multiple-output (MIMO) communication systems are attracting attention because their channel capacity can exceed single-input single-output systems, with no increase in bandwidth. While MIMO systems offer substantial capacity improvements, it can be challenging to characterize and verify their channel models. This paper describes a software MIMO channel simulator with a graphical user interface that allows the user to easily investigate a number of MIMO channel characteristics for a channel recently proposed by the 3rd Generation Partnership Project (3GPP).

ITC/USA 2006 Conference Proceedings / The Forty-Second Annual International Telemetering Conference and Technical Exhibition / October 23-26, 2006 / Town and Country Resort & Convention Center, San Diego, California / Wireless communication systems may use training signals for the receiver to learn the fading coefficients of the channel. Obtaining channel state information (CSI) at the receiver is often times necessary for the receiver to correctly detect and demodulate transmitted symbols. The type of training signal, the length of time to spend training, and the frequency of training are all important parameters in these types of systems. In this work, we derive an analytic expression for calculating the optimal training parameters for continuously fading channels. We also provide simulation results showing why this training scheme is considered optimal.

In this thesis new techniques are presented to achieve performance enhancement in wireless cooperative networks. In particular, techniques to improve transmission rate and maximise end-to-end signal-to-noise ratio are described. An offset transmission scheme with full interference cancellation for a wireless cooperative network with frequency flat links and four relays is introduced. This method can asymptotically, as the size of the symbol block increases, achieve maximum transmission rate together with full cooperative diversity provided the destination node has multiple antennas. A novel full inter-relay interference cancellation method that also achieves asymptotically maximum rate and full cooperative diversity is then designed for which the destination node only requires a single antenna. Two- and four-relay selection schemes for wireless cooperative amplify and forward type networks are then studied in order to overcome the degradation of end-to-end bit error rate performance in single-relay selection networks when there are feedback errors in the relay to destination node links. Outage probability analysis for a four-relay selection scheme without interference is undertaken. Outage probability analysis of a full rate distributed transmission scheme with inter-relay interference is also studied for best single- and two-relay selection networks. The advantage of multi-relay selection when no interference occurs and when adjacent cell interference is present at the relay nodes is then shown theoretically. Simulation results for outage probability analysis are included which support the theoretical expressions. Finally, outage probability analysis of a cognitive amplify and forward type relay network with cooperation between certain secondary users, chosen by best single-, two- and four-relay selection is presented. The cognitive amplify and forward relays are assumed to exploit an underlay approach, which requires adherence to an interference constraint on the primary user. The relay selection scheme is performed either with a max-min strategy or one based on maximising exact end-to-end signal-to-noise ratio. The outage probability analyses are again confirmed by numerical evaluations.

The research investigates the influence on the human body on a communication system. To understand this, the effect of hands free kit (HFK) on energy absorption in the body was investigated when operating a smart phone at 2G. Findings on the research are given in the thesis report. Also, the influence of the way in which a phone is held on a phone s received power was investigated. The result was compared to that obtained using a hand phantom acquired from SPEAG. This was to check if the hand phantom best represents the human hand when using it in experiments. The setup for the experiment was in an anechoic chamber at Loughborough University. The mobile phone transmitted in the 2G system. In further experiments carried out on the body, two antennas were attached to the body in six different orientations to receive power from a source creating a Single Input Multiple Output (SIMO) system. The antennas used were monopoles mounted on a circular ground plane. These antennas were designed and constructed with the influence of the body taken into consideration. The use of diversity techniques to improve transmission to an on-body system is investigated with the antennas on the body. For each alignment, the transmission to the on-body was compared with the transmission to the corresponding off-body (free space). Experiments for this work were carried out in three environments.

Optical wireless communications (OWC) has the potential to become a remedy for the shortage of the radio frequency (RF) spectrum. Especially in indoor environments, OWC could enable wireless home networking systems which offload data traffic from existing RF systems. In OWC, data is transmitted by modulating the intensity of light sources, typically incoherent light emitting diodes (LEDs). Thus, OWC systems employ intensity modulation (IM) and direct detection (DD) of the optical carrier. Since off-the-shelf LEDs have a limited modulation capability, the transmission bandwidth of practical OWC systems is restricted. Consequently, the available bandwidth has to be used efficiently. In this thesis, spectrally efficient optical wireless transmission techniques are evaluated. Firstly, multiple transmitter-receiver techniques are investigated. These multiple-input-multiple-output (MIMO) techniques provide high spectral efficiency, and therefore high data rates. Specifically, the MIMO techniques repetition coding (RC), spatial multiplexing (SMP) and spatial modulation (SM) are analysed for indoor OWC. The performance of these techniques is evaluated analytically and by means of computer simulations. It is shown that inducing power imbalance between the multiple optical transmitters can substantially improve the performance of optical MIMO techniques as the power imbalance improves the differentiability of the multiple channels. In addition, it is found that link blockage and the utilisation of transmitters having different optical wavelengths enhance channel differentiability as well. These methods enable the utilisation of optical MIMO techniques under conditions which typically disallow the application of MIMO schemes due to little differences between the multiple links. Secondly, a novel optical wireless transmitter concept is developed. This concept uses discrete power level stepping to generate intensity modulated optical signals, such as orthogonal frequency division multiplexing (OFDM) waveforms. The transmitter consists of several on-off-switchable LED groups which are individually controlled to emit scaled optical intensities. As a result, the digital-to-analogue conversion of the signals to be sent is done in the optical domain. This method enables the implementation of low-complex and power-efficient optical transmitter front-ends – the major shortcoming of conventional optical OFDM transmitters. Thirdly, a novel approach for wireless data transmission within an aircraft cabin is presented. The data is transferred by 2-dimensional visual code sequences. These sequences are displayed on the in-flight entertainment (IFE) screen and are captured by the built-in camera of a user device which acts as receiver. Transmission experiments within an aircraft cabin mock-up demonstrate the functionality of the implemented system under realistic conditions, such as ambient illumination and geometric configuration. Altogether, this thesis has analysed the potential of spectrally efficient optical wireless transmission techniques. It is shown that OWC systems can greatly benefit from these techniques.

ITC/USA 2015 Conference Proceedings / The Fifty-First Annual International Telemetering Conference and Technical Exhibition / October 26-29, 2015 / Bally's Hotel & Convention Center, Las Vegas, NV / Spatial modulation (SM) reduces transceiver complexity and inter-channel interference over traditional multiple input multiple output (MIMO) systems. It has been shown recently in the literature that the use of a precoder in an SM or a generalized spatial modulation (GSM) system can significantly improve error performance. This paper investigates two issues related to precoders: 1) the use of a precoder in Alamouti-GSM systems, and 2) the effects of power constraints on the precoder design. The results in this paper show that Alamouti-GSM can improve system performance by several dB. On power constraint issues, the paper shows that there is a trade-off between limiting antenna power fluctuations and the potential gain due to precoders.

ITC/USA 2005 Conference Proceedings / The Forty-First Annual International Telemetering Conference and Technical Exhibition / October 24-27, 2005 / Riviera Hotel & Convention Center, Las Vegas, Nevada / To correctly demodulate a signal sent through a multiple-input multiple-output (MIMO) channel, a receiver may use training to learn the channel parameters. The choice of training parameters can significantly impact system performance. Training too often yields low throughput while training infrequently produces poor channel estimates and increased transmission errors. Previous work on optimal training parameters has focused on the block fading Rayleigh model. This work examines a more general case; finding the training parameters that maximize throughput for a continuously varying channel. Training parameters that maximize a lower bound on channel capacity are determined via simulation, and general guidelines are presented for selecting optimal training parameters.

published_or_final_version / abstract / Electrical and Electronic Engineering / Doctoral / Doctor of Philosophy

published_or_final_version / abstract / Electrical and Electronic Engineering / Doctoral / Doctor of Philosophy

published_or_final_version / Electrical and Electronic Engineering / Master / Master of Philosophy