Spelling suggestions: "subject:"accommodation coefficient."" "subject:"ccommodation coefficient.""
1 |
THE THERMAL ACCOMMODATION COEFFICIENT OF HELIUM AND ARGON ON AN AMORPHOUS SILICON-DIOXIDE SURFACEMcFall, Alan Leroy January 1978 (has links)
No description available.
|
2 |
Measurement of thermal accommodation coefficients of inert gas mixtures on a surface of stainless steel /Jun, Byung Soon, January 2001 (has links)
Thesis (Ph. D.)--University of Missouri-Columbia, 2001. / Typescript. Vita. Includes bibliographical references (leaves 80-86). Also available on the Internet.
|
3 |
Measurement of thermal accommodation coefficients of inert gas mixtures on a surface of stainless steelJun, Byung Soon, January 2001 (has links)
Thesis (Ph. D.)--University of Missouri-Columbia, 2001. / Typescript. Vita. Includes bibliographical references (leaves 80-86). Also available on the Internet.
|
4 |
The thermal accommodation of helium and argon on hot tungstenWatts, Michael James January 1977 (has links)
Experiments are described in which the momentum flux of gas atoms, remitted normal to the surface of a hot clean tungsten ribbon immersed in a low pressure of helium or argon, is measured with a torsion balance and the thermal accommodation coefficient deduced. Data are presented in which the tungsten temperature range was 700 to 1900 K for helium and 1100 to 1700 K for argon. If it is assumed that the normal remitted momentum flux is that expected on assumption of the cosine emission relation, accommodation coefficients much larger (and for argon physically impossible) than those found previously by other workers are implied. A model is proposed which assumes that atoms impinging on and remitted from the hot tungsten ribbon conserve momentum in directions parallel to the surface. This results in a remitted flux, in the direction of the normal, greater than the cosine relation would predict. The resulting accommodation coefficients are then of the same order as those found using the total heat loss method. The method here reported is believed to be novel. Its accuracy increases with the temperature of the hot solid. It permits the measurement of translational thermal accommodation without relying on the temperature coefficient of resistance of the solid and hence is applicable to alloys and to non-metals. For metals., which have a normal temperature coefficient of resistance, the method allows translational accommodation to be measured and internal energy accommodation to be deduced.
|
5 |
Thin Film Evaporation Modeling of the Microlayer Region in a Dewetting Water BubbleLakew, Ermiyas January 2022 (has links)
No description available.
|
6 |
Measurement and Control of Slip-Flow Boundary Conditions at Solid-Gas InterfacesSeo, Dongjin 30 October 2014 (has links)
This thesis describes measurements of the gas-solid flow boundary condition at moderate Knudsen number, i.e., where the dimensions of the flow are similar to the mean free path, and thus partial slip is expected. This regime has become more important with increased focus on nano-scale devices, but there is currently no consensus on how the slip length should vary for different solids and gases, or whether it can be controlled. In this thesis, I describe unambiguous measurements showing that partial slip occurs, that the slip length depends both on gas and solid, and that the slip length can be altered in situ. The slip length is determined from analysis of the vibration of a small sphere adjacent to a solid. I also describe applications of these findings both to the separation of gases, and to inhalants.
The effect of water films, gas species, organic films, and electric fields on gas flow was studied. Water films had a large, but complex effect. On bare hydrophobilic glass, the tangential momentum accommodation coefficient (TMAC) for nitrogen on hydroxyl-terminated silica changed from 0.25 to 0.88 when the humidity changed from 0 to 98 %. On hydrophobized glass, TMAC changed from 0.20 to 0.56 in the same range.
The effect of the gas on TMAC was measured for five different gases (helium, nitrogen, argon, carbon dioxide, hexafluoride sulfur) on octadecyltrichlorosilane-coated glass surfaces. A lower
TMAC occurred for greater molar mass, and this trend was explained using a simple model representing both the gas and the monolayer by spheres. The existence of this gas-dependent difference in TMAC suggests that gases can be separated based on their collisions with surfaces.
Methods for controlling the flow boundary condition were also developed by adsorbing monolayers on the solid, and altering the monolayers in situ. Both temperature and electric fields altered the boundary condition, and these changes were attributed to changes in the surface roughness. The effect of roughness was modeled with grooved surfaces. Possible applications of this effect of roughness include changing the flow of aerosol droplets for deeper delivery of therapeutic drugs into the lung. / Ph. D.
|
7 |
The Onsager heat of transport at the liquidvapour interface of p-tert-butyltolueneBiggs, Georgina Aimee January 2007 (has links)
The Onsager heat of transport for p-tert-butyltoluene was measured, as part of a series of preliminary experiments towards the determination of the importance of temperature gradients on the air-sea flux of carbon dioxide. The results presented in this thesis imply that the temperature gradient is a major contributor to the magnitude of the air-sea flux. The heat of transport has been measured for the p-tert-butyltoluene system by measuring stationary-state pressure changes for known temperature differences on the vapour side of the interface. At the pressure ranges used the number of mean free paths was always outside the Knudsen zone, but the values of Q* were approximately 100 % of the latent heat of vaporisation. Departures from linearity of plots of P against ΔT are attributed to temperature jumps at the surface of the dry upper plate. Both the results taken for p-tert-butyltoluene and the earlier results for water from this laboratory fit to a Type III BET isotherm, where the c parameter is not constant. They also reveal the importance of the temperature gradient in determining the value of the thermal accommodation coefficient, and provide a new method of measuring thermal accommodation coefficients for a variety of surfaces and vapours
|
8 |
The Onsager heat of transport at the liquidvapour interface of p-tert-butyltolueneBiggs, Georgina Aimee January 2007 (has links)
The Onsager heat of transport for p-tert-butyltoluene was measured, as part of a series of preliminary experiments towards the determination of the importance of temperature gradients on the air-sea flux of carbon dioxide. The results presented in this thesis imply that the temperature gradient is a major contributor to the magnitude of the air-sea flux. The heat of transport has been measured for the p-tert-butyltoluene system by measuring stationary-state pressure changes for known temperature differences on the vapour side of the interface. At the pressure ranges used the number of mean free paths was always outside the Knudsen zone, but the values of Q* were approximately 100 % of the latent heat of vaporisation. Departures from linearity of plots of P against ΔT are attributed to temperature jumps at the surface of the dry upper plate. Both the results taken for p-tert-butyltoluene and the earlier results for water from this laboratory fit to a Type III BET isotherm, where the c parameter is not constant. They also reveal the importance of the temperature gradient in determining the value of the thermal accommodation coefficient, and provide a new method of measuring thermal accommodation coefficients for a variety of surfaces and vapours
|
9 |
Tangential momentum accommodation coefficient in microchannels with different surface materials (measurements and simulations).Hadj nacer, Mustafa 17 December 2012 (has links)
Cette thèse est consacrée à l'étude des écoulements de gaz raréfiés à travers divers micro-conduits de type circulaire et rectangulaire dans des conditions isotherme et stationnaire. L'objectif de la thèse est de contribuer à l'étude de l'interaction gaz-surface notamment en déterminant le coefficient d'accommodation de la quantité de mouvement pour différent matériaux de surface (Or, Silice, Acier inoxydable et Sulfinert) associés à différents types de gaz (hélium, azote, argon et dioxyde-de-carbone). Afin d'atteindre cet objectif, on adopte un triple point de vue : expérimental, théorique et numérique. L'aspect expérimental est réalisé par des mesures de débit massique à travers les micro-conduits, en utilisant la méthode dite « à volume constant ». L'aspect théorique original est développé à travers une nouvelle approche basée sur la résolution de l'équation de Stokes. Cette approche a permis d'écrire une expression analytique de débit massique en régime de glissement, qui prenne en compte les effets bidimensionnels dans une section de conduit rectangulaire. Cette approche complètement explicite, est conduite au deuxième ordre. Enfin l'aspect numérique permet de calculer le débit massique, en régimes transitionnel et moléculaire libre, en résolvant numériquement l'équation cinétique BGK linéarisée. La comparaison des mesures de débit massique avec l'équation analytique, en régime de glissement, ou avec les calculs numériques, en régimes transitionnel et moléculaire libre, nous a permis de déduire des coefficients de glissement et les coefficients d'accommodation correspondant à chaque couple gaz-surface dans tous les régimes de raréfaction. / This thesis is devoted to the study of rarefied gas flows through micro-channels of various cross sections (circular and rectangular) under isothermal and stationary conditions. The objective of this thesis is to contribute to the study of gas-surface interaction by determining the tangential momentum accommodation coefficient for different surface materials (gold, silica, stainless steel and Sulfinert) and associated to various gases (helium, nitrogen, argon and carbon-dioxide). To achieve this goal three aspects are considered: experimental, theoretical and numerical. The experimental aspect is considered by measuring the mass flow rate through microchannels using the constant volume technique. The theoretical aspect is considered by the development of a new approach based on the Stokes equations. This approach yields to the analytical expression of the mass flow rate in the slip regime, which takes into account the second order effects. The last aspect, numerical, is considered by the numerical simulations of the mass flow rate in the transitional and free molecular flow regimes by solving the linearized BGK kinetic model. The comparison between the measured mass flow rates and the analytically expressions in the slip regime or with the results of numerical simulations in the transitional and free molecular regimes enabled to deduce the tangential momentum accommodation coefficients corresponding to each pair gas-surface in all flow regimes.
|
10 |
Buoyancy-thermocapillary convection of volatile fluids in confined and sealed geometriesQin, Tongran 27 May 2016 (has links)
Convection in a layer of fluid with a free surface due to a combination of thermocapillary stresses and buoyancy is a classic problem of fluid mechanics. It has attracted increasing attentions recently due to its relevance for two-phase cooling. Many of the modern thermal management technologies exploit the large latent heats associated with phase change at the interface of volatile liquids, allowing compact devices to handle very high heat fluxes. To enhance phase change, such cooling devices usually employ a sealed cavity from which almost all noncondensable gases, such as air, have been evacuated. Heating one end of the cavity, and cooling the other, establishes a horizontal temperature gradient that drives the flow of the coolant. Although such flows have been studied extensively at atmospheric conditions, our fundamental understanding of the heat and mass transport for volatile fluids at reduced pressures remains limited. A comprehensive and quantitative numerical model of two-phase buoyancy-thermocapillary convection of confined volatile fluids subject to a horizontal temperature gradient has been developed, implemented, and validated against experiments as a part of this thesis research. Unlike previous simplified models used in the field, this new model incorporates a complete description of the momentum, mass, and heat transport in both the liquid and the gas phase, as well as phase change across the entire liquid-gas interface. Numerical simulations were used to improve our fundamental understanding of the importance of various physical effects (buoyancy, thermocapillary stresses, wetting properties of the liquid, etc.) on confined two-phase flows. In particular, the effect of noncondensables (air) was investigated by varying their average concentration from that corresponding to ambient conditions to zero, in which case the gas phase becomes a pure vapor. It was found that the composition of the gas phase has a crucial impact on heat and mass transport as well as on the flow stability. A simplified theoretical description of the flow and its stability was developed and used to explain many features of the numerical solutions and experimental observations that were not well understood previously. In particular, an analytical solution for the base return flow in the liquid layer was extended to the gas phase, justifying the previous ad-hoc assumption of the linear interfacial temperature profile. Linear stability analysis of this two-layer solution was also performed. It was found that as the concentration of noncondensables decreases, the instability responsible for the emergence of a convective pattern is delayed, which is mainly due to the enhancement of phase change. Finally, a simplified transport model was developed for heat pipes with wicks or microchannels that gives a closed-form analytical prediction for the heat transfer coefficient and the optimal size of the pores of the wick (or the width of the microchannels).
|
Page generated in 0.1264 seconds