Research into renewable energy sources is crucially increasing to counteract the ever more concerning impact of non-renewable sources. Theoretically, Quantum Dot Solar Cells (QDSCs) can achieve much greater efficiencies than current, commercial solar cells, but its expansion is still in its very early stages of scientific study and development. In this project TiO2, one of the most efficient and cost-effective photocatalysts, is coupled with Cadmium Selenide (CdSe) Quantum Dots (QD) in a study of interfacial charge transfers. Thus far, in other studies, CdSe QDs have shown some of the most promising results of QDSCs. EPR spectroscopy has been used here to study charge transfer processes in CdSe quantum dot (QD) sensitised titania. Visible light excitation of QDs directly adsorbed onto titania surfaces causes electron transfer to the titania, producing characteristic EPR signals of trapped electrons in the titania. Under ultraviolet excitation the trapped electron signals seen in titania alone are suppressed in the presence of directly adsorbed quantum dots, as is the formation of superoxide in the presence of oxygen. These observations suggest that reverse electron transfer from the titania to the QDs can also occur. No visible light excited electron transfer occurs in the case of QDs attached to the titania surface via bi-linker molecules, but under ultraviolet excitation a similar suppression of electron trapping in the titania phase is seen. These results show that the nature of the interface between the QDs and the titania phase is crucially important in the electron transfer processes in both directions. The study also looks at the pitfalls of synthesis techniques used for making the CdSe QDs as well as the method of attaching it to the TiO2. Ionic deposition, which generally resulted in the best photocurrents in other studies, was discovered early on this project produced very impure samples. Direct Adsorption produces low titania surface coverage, which can potentially be improved. Whereas the lack of discussion in literature of clear purification methods in synthesis techniques for attaching QDs via a bi-linker molecule, through ligand exchange, causes a significant drawback in the study of such systems.

This thesis summarizes the methods of preparation and optical properties of hybrid assemblies of Au NPs and cadmium selenide (CdSe) QDs. First chap-ter deals with the literature survey and theoretical aspects of plasmonics and discussions on optical excitations of metal (plasmons) and semiconducting QDs (excitons). Variation of energy levels of CdSe QDs and its optical properties i e. absorption and emission properties under strong confinement regime have been discussed with respect to effective mass approximation (EMA) model. This is followed by the discussion on optical properties of Au NPs and rods, describing absorption properties, based on Mie theory. Size and shape depen-dent variation of absorption properties. Theoretical discussions of collective effects in QDs assemblies and plasmonic interactions with the QDs assemblies i.e. plasmonic Dicke effect and metal nanoantenna interaction with CdSe QDs arrays is provided. In the second chapter a discussion on experimental techniques used for the study is provided. It starts with a discussion on the synthesis methods for CdSe QDs and Au NPs/rods with different capping ligands. Different techniques of preparation of CdSe QDs assemblies and their hybrid with metallic nanoparti-cles has been discussed. Further discussion on optical microscopy techniques, confocal, near field scanning microscopy (NSOM), Brewster angle microscopy and electron microscopy techniques i. e transmission electron microscopy and scanning electron microscopy and thermogravimetry analysis of the samples is provided. In the third chapter the details of the different self-assembly methods of preparation of hybrid assemblies of CdSe QDs and Au NPs /rods are given. The different strategies are used for different type of hybrids. In first method of Langmuir-Blodgett (LB) , effect of different capping agents, core size, and number ratios of Au NPs/rods to CdSe QDs, effect of anisotropy of Au NPs on the LB films of CdSe QDs assemblies is discussed. In another method of dip coating several control parameters like dip time, concentration of the solution and dip speed of transferring an aligned GNRs is given. Finally a combination of LB and dip coating methods is described for transferring aligned GNRs over a compact layer of CdSe QDs. At the end, a section is devoted to hit and trials of self-assemblies of hybrid of GNRs and CdSe QDs using LB method, the failures of which resulted in devising a method which uses a combination of LB and dip coating. In fourth chapter effects of plasmons on the collective emission of CdSe QDs assemblies are investigated. A plasmonic tuning of photoluminescence from semiconducting QD assemblies using Au NP in different ratio and different packing density has been discussed. We have described how the emission from a closed pack assemblies, prepared with different packing densities depends on the packing density and extent of spectral overlap between QD photolumi-nescence and the metal nanoparticle absorbance. We have provided possible evidence for plasmon mediated coherent emission enhancement from some of these assemblies from the case of strong spectral overlap between CdSe QDs and Au nanoparticle. In fifth chapter, we have demonstrated non local far field enhancement of PL in QDs assemblies induced by isolated and partially aligned GNRs nano-antenna located on such assemblies. It is shown that the emission is also anisotropic with the maxima being near such GNRs assembly which decays to finite, nonzero and significantly large values even away from the vicinity of any such assemblies. For this novel effect it is shown to have a clear spec-tral dependence. It is shown to be maximum when the longitudinal surface plasmon resonance absorption maxima is resonant with the CdSe QD photolu-minescence maxima and the excitation wavelength and is always non-existent for the off resonant case. We have also shown that finite difference time do-main simulations could model some of the observed near field effects but the far field effects could not be modelled in such simulations.

Over the last few decades, a vast research is going on, to study the optical properties of the nano particles i.e., metal and semiconductors thoroughly. Till date most of the optical studies are based on single particle measurement of a quantum dot (QD) or a chromophore under the influence of an external plasmonic field stimulus. In this the-sis, we tried to address the energy transfer at non local level on a layer of compact, monolayer QD assemblies over micro meter range. The energy transfer occurs in the presence of external field of metal particles or nanorods leads to the enhancement or quenching the emission from a layer of QDs. Chapter 1 is introduction to the basic theoretical aspects of excitons in semiconductor (QDs) and its optical properties under strong confinement regime. The discussion is followed with the optical properties of gold nanoparticles and rods, describing size and shape dependent variation of absorption properties, based on Mie and Mie-Gans theory. Theoretical background of collective effects in QD assemblies based on exciton-plasmonic interactions at single particle level as well as polarization based plasmo-nenhanced fluorescence has been subjected. Experimental techniques are explained in chapter 2 which contains the details of the synthesis of polymer capped nanoparticles with the respective characterization. A discussion on the synthesis methods for cadmium selenide QDs, gold nano particles and the rods with different polymer cap-ping legends and the related capping exchange methods. The thin film preparation of QD monolayers as well as hybrid nano assemblies using several techniques, i.e., Langmuir-Blodgett (LB), dip coat methods are provided. Further the details of surface morphology of the prepared thin films has been studied by different microscopic techniques i.e., atomic force microscopy (AFM), transmission electron microscopy (TEM) and scanning electron microscopy (SEM). The details of the PL emission measurements of these hybrid arrays using confocal, Raman and polarization based near field scanning optical microscope (NSOM) modes followed with the life time measurements. In third chapter, the substantial strong coupling and collective emission regime is engineered in the QD monolayer films embedded with tiny gold nano particles keeping the QD density same. Tuning the photoluminescence (PL) of semiconducting QD assemblies using small Au NPs in different ratio, different packing density and extent of spectral overlap between QD photoluminescence and the metal nanoparticle absorbance has been discussed. We provided possible experimental and theoretical evidence for the plasmon-mediated emergence of collective emission and enhanced quantum efficiency in these QD films with the consolidation of multiple emitters and multiple NPs. The quantum efficiency of these hybrid assemblies is further explored with different material as well as the size effect of metal nano particles. Chapter 4 comprises the experiment results of the self-assembled compact and partially aligned gold nano rod (GNR) arrays on QD monolayer films. We experimentally demonstrated the quantum efficiency of these QD hybrid assemblies is gaining max-imum when the longitudinal surface plasmon resonance (LSPR) absorption maxima of GNR arrays is resonant with the QD monolayer PL maxima and is always non-existent for the off resonant case. Further, we reported the variability in the size and morphology of these GNR domains leads to the maximum achieved enhancement as well as anisotropy value in comparison with isolated rods and the explored conditions to further enhance the efficiency in these QD hybrid assemblies.