The usage of welding in the process of manufacturing has become very widespread, mainly due to its low cost, versatility and the possibility of its automation. With its expansion comes higher demand for the possibilities of weld evaluation during the phase of design. Nowadays its possible to use tools based on finite element method for such evaluation. But the most commonly used tools are often very expensive. Therefore, the possibility of using Open-Source tool such as Salome-Meca to simulate the welding process as an alternative to commercial software was investigated. The first part of the work deals with the welding process and a description of the formation of residual stresses and deformations. It also deals with the description of the Salome-Meca software environment and the Code-Aster solver. In the next part the capabilities of the software in relation to problem of welding simulation are discussed. Furthermore, the goemetry of solved weldment, welding conditions, material properties and boundary conditions of the calculation are described. And finally, the individual solutions, their results and disadvantages of used approaches.

Presented diploma thesis was created in cooperation with Siemens s.r.o., and deals with the analysis of the bending of aluminium sheets which are later used as a conductors of high voltage electrical energy. These parts are completed into assemblies which serves as connectors of particular segments of an electrical network. The problem occurs as a result of incorrect bend, because it is impossible to join these sections properly. The customer would like to verify if the defined tolerances of semi-finished products are sufficient for proper bend and in case they are not, the tolerances should be modified. Due to the requirement for running numerical simulation in one of the open source software, the Salome-Meca program environment was used.

Le résumé contient des caractères spéciaux