Cavity ring-down spectroscopy has been used over the last twenty years as a highly sensitive absorption spectroscopic technique to measure light attenuation in gases, liquids, and solid samples. An optical cavity is used as a multi-pass cell, and the decay time of the light intensity in the cavity is measured, thereby rendering the techniques insensitive to light intensity fluctuations. Optical waveguides are used to build the optical cavities presented in this work. The geometries of such waveguides permit the use of very small liquid sample volumes while retaining the advantages of cavity ring-down spectroscopy. In this thesis cavity ring-down measurements are conducted, both, in the time domain and by measuring phase-shifts of sinusoidally modulated light, and the two methods are theoretically connected using a simple mathematical model, which is then experimentally confirmed. A new laser driver, that is compatible with high powered diode lasers, has to be designed to be able to switch from time domain to frequency domain measurements. A sample path length enhancement within the optical cavity is explored with the use of liquid core waveguides. The setup was optimised with respect to the matrix liquid, the geometrical matching of waveguide geometries, and the shape of liquid core waveguide ends. Additionally, a new technique of producing concave lenses at fibre ends has been developed and the output of a general fibre lens is simulated. Finally, liquid core waveguides are incorporated into a fibre-loop ring-down spectroscopy setup to measure the attenuation of two model dyes in a sample volume of <1 µL. The setup is characterized by measuring concentrations of Allura Red AC and Congo Red from 1 µM to a limit of detection of 5 nM. The performance of the setup is compared to other absorption techniques measuring liquid samples. / Thesis (Ph.D, Chemistry) -- Queen's University, 2013-04-23 14:08:16.33

Most developing countries are faced with drinking water problems, with conditions becoming more severe due to water pollution. Meeting the growing demands for clean water in most countries, there are difficult challenges as the availability and supply of drinkable water are diminishing. Due to economic and environmental concerns, development of additional physical means for the removal of organic compounds from wastewater using permanent magnets, electromagnetic coils, electrodes and ultrasonic pretreatment is desirable. Improving the adsorption and separation process, magnetic field exposure method has progressively drawn consideration. Magnetic field exposure method has demonstrated its capacity for increasing the adsorptive elimination of contaminants from water as static magnetization is suitable, simple and cost-effective. The polypyrrole magnetic nanocomposite use for adsorption experiments influenced by exter-nal magnetic field was prepared using the in-situ polymerization method, which was charac-terized using TEM, SEM, EDX, XRD, BET, FTIR, VSM, and ESR spectrophotometers. The magnetic nanocomposite (PPy/Fe3O4) was observed to have an average particle size of 10 nm with the elementary composition of carbon, oxygen, nitrogen, chloride and iron. The magnetic nanocomposite had a crystalline structure of face-centred cubic lattice of Fe3O4, an adsorption-desorption isotherm shape indicating a typical type-IV mesoporous material with a surface area of 28.77 m2/g. Characteristic peaks of Fe3O4 and PPy were also observed using FTIR spectro-photometer. From the VSM and ESR characterization, the synthesized superparamagnetic ma-terial was shown to have a saturation magnetization of 23 emu/g and an effective g-value of 2.25 g which was attributed to Fe3+ spin interaction. An enhanced removal of Cr(VI), fluoride and congo red dye were observed under the influence of magnetic field, with parameters like pH, adsorbent dosage, the initial concentration of ad-sorbate, magnetic field and magnetic exposure time been varied. The enhanced adsorption of contaminants using magnetic field is attributed to the increase in the magnetic field induced on the particles over a magnetic exposure time, resulting in the rotating particles forming aggre-gates due to the increased magnetic force and torque on the particles from the PSV results. This leads to increase in the chain collision and area of particle interaction with the aqueous solution of hexavalent chromium, fluoride and congo red dye. / Physics / Ph. D. (Physics)