Three studies on Cordilleran foreland basin deposits in the western U.S.A. constitute this dissertation. These studies differ in scale, time and discipline. The first two studies include basin analysis, flexural modeling and detailed stratigraphic analysis of Upper Cretaceous depocenters and strata in the western U.S.A. The third study consists of detrital zircon U-Pb analysis (DZ U-Pb) and thermochronology, both zircon (U-Th)/He and apatite fission track (AFT), of Upper Jurassic to Upper Cretaceous foreland-basin conglomerates and sandstones. Five electronic supplementary files are a part of this dissertation and are available online; these include 3 raw data files (Appendix_A_raw_isopach_data.txt, Appendix_C_DZ_Data.xls, Appendix_C_UPb_apatite.xls), 1 oversized stratigraphic cross section (Appendix_B_figure_5.pdf), and 1 figure containing apatite U-Pb concordia plots (Appendix_C_Concordia.pdf). Appendix A. Subsidence in the retroarc foreland of the North American Cordillera in the western U.S.A. has been the focus of a great deal of research, and its transition from a flexural foreland basin, during the Late Jurassic and Early Cretaceous, to a dynamically subsided basin during the Late Cretaceous has been well documented. However, the exact timing of the flexural to dynamic transition is not well constrained, and the mechanism has been consistently debated. In order to address the timing, I produced new isopach maps from ~130 well log data points that cover much of Utah, Colorado, Wyoming and northern New Mexico, producing in the process, the most detailed isopach maps of the area. These isopach maps span the Turonian to mid-Campanian during the Late Cretaceous (~93–76 Ma). In conjunction with the isopach maps I flexurally modeled the Cordilleran foreland basin to identify when flexure can no longer account for the basin geometry and identified the flexural to dynamic transition to have occurred at 81 Ma. In addition, the dynamic subsidence at 81 Ma is compared to the position of the hypothesized Shatsky Oceanic Plateau and other proposed drivers of dynamic subsidence. I concluded that dynamic subsidence is likely caused by convection over the plunging nose of the Shatsky Oceanic Plateau. Appendix B. The second study is a detailed stratigraphic study of the Upper Cretaceous, (Campanian, ~76 Ma) Sego Sandstone Member of the Mesaverde Group in northwestern Colorado, an area where little research has been done on this formation. Its equivalent in the Book Cliffs area in eastern Utah has been rigorously documented and its distal progradation has been contrastingly interpreted as a result of active tectonism and shortening in the Cordilleran orogenic belt ~250 km to the west and to tectonic quiescence, flexural rebound in the thrust belt and reworking of proximal coarse grained deposits. I documented ~17 km of along depositional dip outcrops of the Sego Sandstone Member north of Rangely, Colorado. This documentation includes measured sections, paleocurrent analysis, a stratigraphic cross section, block diagrams outlining the evolution of environments of deposition through time, and paleogeographic maps correlating northwest Colorado with the Book Cliffs, Utah. The sequence stratigraphy of the Sego Sandstone Member in northwest Colorado is similar to that documented in the Book Cliffs area to the south-southwest, sharing three sequence boundaries. However, flood-tidal delta assemblages between fluvio-deltaic deposits that are present north of Rangely, Colorado are absent from the Book Cliffs area. These flood-tidal-delta assemblages are likely caused by a large scale avulsion event in the Rangely area that did not occur or was not preserved in the Book Cliffs area. In regards to tectonic models that explain distal progradation of the 76 Ma Sego Sandstone Member to be caused by tectonic quiescence and flexural rebound in the thrust belt, the first study shows that at 76 Ma, flexural processes were no longer dominant in the Cordilleran foreland, so it is inappropriate to apply models driven by flexure to the Sego Sandstone Member. Dynamic processes dominated the western U.S.A. during the Campanian, and flexural processes were subordinate. Appendix C. In order to test the tectonic vs. anti-tectonic basin-filling models for distal coarse foreland deposits mentioned above, the third study involves estimating lag times of Upper Jurassic to Upper Cretaceous conglomerates and sandstones in the Cordilleran foreland basin. Measuring lag time requires a good understanding of both the stratigraphic age of a deposit and the thermal history of sedimentary basin. To further constrain depositional age, I present twenty-two new detrital zircon U-Pb (DZ U-Pb) sample analyses, spanning Upper Jurassic to Upper Cretaceous stratigraphy in Utah, Colorado, Wyoming and South Dakota. Source exhumation ages can be measured using thermochronology. To identify a thermochronometer that measures source exhumation in the North America Cordillera, both zircon (U-Th)/He, on eleven samples, and apatite fission track (AFT) thermochronology, on eleven samples was performed. Typically, the youngest cooling age population in detrital thermochronologic analyses is considered to be a source exhumation signal; however, whether or not these apatites are exhumed apatites or derived from young magmatic and volcanic sources has been debated. To test this, I double dated the detrital AFT samples, targeting apatites with a young cooling age, using U-Pb thermochronology. Key findings are that the maximum depositional ages using DZ U-Pb match existing biostratigraphic and geochronologic age controls on basin stratigraphy. AFT is an effective thermochronometer for Lower to Upper Cretaceous foreland stratigraphy and indicates that source material was exhumed from >4–5 km depth in the Cordilleran orogenic belt between 118 and 66 Ma, and zircon (U-Th)/He suggests that it was exhumed from <8–9 km depth. Double dating apatites (with AFT and U-Pb) indicate that volcanic contamination is a significant issue; without having UPb dating of the same apatite grains, one cannot exclude the possibility that the youngest detrital AFT population is contaminated with significant amounts of volcanogenic apatite and does not represent source exhumation. AFT lag-times are 0 to 5 Myr with relatively steady-state to slightly increasing exhumation rates. We compare our data to orogenic wedge dynamics and subsidence histories; all data shows active shortening and rapid exhumation throughout the Cretaceous. Our lag-time measurements indicate exhumation rates of ~.9–>>1 km/Myr.

The Cretaceous Mowry Shale is an organic-rich, siliceous marine shale, and as such is a known source rock in the Western United States. Studies have documented that total organic carbon (TOC) in the Wind River Basin, Wyoming increases to the southeast. These studies cover large areas with limited sample sets. In this study, over 250 samples were collected near Lander, Wyoming to address spatial heterogeneity of TOC within the Mowry Shale at a much finer scale than previously examined. Samples were collected along five vertical sections at three localities, and following correlation of the vertical sections, which was strongly aided by the presence of regional bentonite horizons, samples were collected laterally from the same unit at regular 25-foot intervals. These samples were analyzed using pyrolysis and x-ray diffraction techniques. Average TOC values are fairly consistent within the study area (1.65%, with a range of 2.10% to 1.15%). Average Tmax values for vertical and lateral samples is 433 °C with a standard deviation of 7.25 °C suggesting immature to very early oil window thermal maturity. Kerogen types are determined to be dominantly type III, suggesting a dominance of terrestrial input, becoming slightly more mixed type II/III to the southeast. Redox-sensitive trace metals such as uranium, thorium, vanadium, chromium, cobalt, and molybdenum values all suggest a slightly oxygenated sediment water interface during time of deposition. These pyrolysis and trace metal data suggest that the study area was in a prograding proximal marine/prodeltaic depositional environment during Upper Mowry time with influences from higher energy bottom flows. Lateral homogeneity of strata and the low variability in geochemical character across the study area suggest that the local basin in the study area was not segmented by structural or oceanographic conditions. While efforts were made to collect unaltered outcrop samples (digging back into what appeared to be unfractured, unaltered rock), alteration or weathering of organic material is a concern for source rock evaluation of near-surface outcrops. In order to address this concern, a 5-foot-deep trench was dug back into the outcrop at the target horizon in one locality. Samples were taken at regular three-inch intervals from this trench as it was excavated to determine the effect of weathering on TOC in the study area. Based on pyrolysis results, TOC was affected by weathering only along fracture sets (several samples intersected fractures in the shallow subsurface) and did not appreciably increase from the surface to a depth of five feet. Due to the impermeable nature of shale rock, decreases of TOC due to weathering appear to be limited to the immediate surface of samples and along fracture sets.

The Frontier Formation in the Green River Basin of southwestern Wyoming consists of Late Cretaceous (Cenomanian-Turonian) marine and non-marine sandstones, siltstones, mudstones and coals deposited on the western margin of the Cretaceous Interior Seaway. Tight gas reservoirs exist in subsurface fluviodeltaic sandstones in the upper Frontier Formation (Dry Hollow Member) on the north-south trending Moxa Arch within the basin. These strata crop out in hogback ridges of the Utah-Idaho-Wyoming Thrust Belt approximately 40 km west of the crest of the Moxa Arch. Detailed, quantitative outcrop descriptions were constructed using emerging photogrammetric techniques along with field observations and measured sections at five key outcrop localities along the thrust belt. Understanding the architectural style of this low net-to-gross fluvial system allows for improved reservoir prediction in this and other comparable basins. The architectural style of the Dry Hollow Member fluvial deposits varies vertically as the result of a relative shoreline transgression during Dry Hollow deposition. Amalgamated conglomerates and associated fine to coarse sandstones near the base of the section and much thinner, isolated sandstones near the top of the Dry Hollow occur in laterally extensive units that can be identified over tens of kilometers. These units also provide means to relate outcrop and subsurface stratigraphic architecture. Combined with available subsurface data, fully-realized 3D static reservoir models for use as analogs in subsurface reservoir characterization may be constructed. Grain size, reservoir thickness and connectivity of fluvial sandstones is generally greatest near the base of this member and decreases upward overall. Despite relative isolation of some channel bodies, geocellular facies modeling indicates good lateral and vertical connectivity of most channel sandstones. The Kemmerer Coal Zone, with little sandstone, divides lower and upper well-connected sandy units.

The Trail Member of the upper Cretaceous Ericson Sandstone, part of the Mesaverde Group, is exposed along hundreds of square kilometers through Wyoming along the flanks of several Laramide structural uplifts. This presents a unique opportunity to study the detailed architecture based on bed-scale heterogeneity and better assess the reservoir potential of these strata in outcrop exposure on a regional-scale, and to then relate these observations to producing fields nearby. The fluvial-dominated Trail Member formed as sediments traveled from the active Sevier thrust belt to the Cretaceous Interior Seaway, forming a basinward progradational clastic wedge along a relatively high gradient. The high energy, tectonically active setting led to preservation of sand-rich, often compositionally immature fluvial strata. Though there is an abundance of sand-rich strata in the Trail Member, production from this interval has been unpredictable in current and past fields such as the Trail Unit of southwestern Wyoming.Twelve detailed stratigraphic columns were described at three sites along the eastern flank of the Rock Springs Uplift to show facies heterogeneity beyond what is often available through wells, 69 hand samples were collected for determination of porosity and permeability, and photogrammetric characterization was performed at the three sites. Average porosity decreases along strike from north to south along with net-to-gross. The vertical changes in fluvial architecture within the Trail Member reflect changes in available accommodation. While thickness of the Trail Member is highly variable, ranging between 79 to 108 meters across the study area, there is an overall trend of thickening to the south. Although the character of the Trail strata changes appreciably along strike direction, this interval is consistently rich in sand, and grain size does not change drastically along the length of observed outcrops. This study demonstrated that spatial variability in the thickness, local accommodation, porosity, and net-to-gross of the Trail Member, as well as temporal variability in the amount and character of reservoir sands and channel stacking patterns play an important role in the unpredictability of this reservoir. This study will enable reservoir modeling and aid in future exploration projects within the Trail Member and other comparable systems with similar fluvial architecture and internal heterogeneity.