There has been very little research into the bioanalytical application of Microemulsion High Performance Liquid Chromatography (MELC), a recently established technique for separating an active pharmaceutical ingredient from its related substances and for determining the quantity of active drug in a dose. Also, the technique is not good at separating hydrophilic drugs of very similar chemical structures. Different phase diagrams of oil (octane or ethyl acetate), co-surfactant (butanol), surfactant (sodium dodecyl sulphate (SDS) or Brij-35) and buffer (Phosphate pH 3) were developed and several nanoemulsion mobile phases identified. Nanoemulsion mobile phase that is, prepared with SDS, octane, butanol and a phosphate buffer, failed to separate hydrophilic compounds with a very close chemical structure, such as terbutaline and salbutamol. A nanoemulsion mobile phase containing a non-ionic surfactant (Brij-35) with ethyl acetate, butanol and a phosphate buffer, was, however, successful in achieving a base line separation, and the method was validated for simultaneous determination of terbutaline and salbutamol in aqueous and urine samples. An oil-in-water (O/W) NELC method was developed and validated for the determination of formoterol in an Oxis® Turbuhaler® using pre-column fluorescence derivatisation. Although the same mobile phase was extended for separation of formoterol in urine, the formoterol peak's overlap with endogenous peaks meant that fluorescence detection could not determine formoterol in urine samples. Solid phase extraction, concentrating the final analyte 40 times, enabled determination of a low concentration of formoterol in urine samples by UV detection. The method was validated and an acceptable assay precision %CV <4.89 inter-day and %CV <2.33 intra-day was achieved. Then after the application of O/W nanoemulsion mobile phase for HPLC was extended for the separation of lipophilic drugs. The nanoemulsion liquid chromatography (NELC) method was optimised for the determination of salmeterol and fluticasone propionate in good validation data was achieved. This thesis shows that, in general, the performance of O/W NELC is superior to that of conventional High Performance Liquid Chromatography (HPLC) for the analysis of both hydrophilic and lipophilic drugs in inhaled dosage formulations and urine samples. It has been shown that NELC uses cheaper solvents and that analysis time is faster for aqueous and urine samples. This considerable saving in both cost and time will potentially improve efficiency within quality control.

There has been very little research into the bioanalytical application of Microemulsion High Performance Liquid Chromatography (MELC), a recently established technique for separating an active pharmaceutical ingredient from its related substances and for determining the quantity of active drug in a dose. Also, the technique is not good at separating hydrophilic drugs of very similar chemical structures. Different phase diagrams of oil (octane or ethyl acetate), co-surfactant (butanol), surfactant (sodium dodecyl sulphate (SDS) or Brij-35) and buffer (Phosphate pH 3) were developed and several nanoemulsion mobile phases identified. Nanoemulsion mobile phase that is, prepared with SDS, octane, butanol and a phosphate buffer, failed to separate hydrophilic compounds with a very close chemical structure, such as terbutaline and salbutamol. A nanoemulsion mobile phase containing a non-ionic surfactant (Brij-35) with ethyl acetate, butanol and a phosphate buffer, was, however, successful in achieving a base line separation, and the method was validated for simultaneous determination of terbutaline and salbutamol in aqueous and urine samples. An oil-in-water (O/W) NELC method was developed and validated for the determination of formoterol in an Oxis® Turbuhaler® using pre-column fluorescence derivatisation. Although the same mobile phase was extended for separation of formoterol in urine, the formoterol peak¿s overlap with endogenous peaks meant that fluorescence detection could not determine formoterol in urine samples. Solid phase extraction, concentrating the final analyte 40 times, enabled determination of a low concentration of formoterol in urine samples by UV detection. The method was validated and an acceptable assay precision %CV <4.89 inter-day and %CV <2.33 intra-day was achieved. Then after the application of O/W nanoemulsion mobile phase for HPLC was extended for the separation of lipophilic drugs. The nanoemulsion liquid chromatography (NELC) method was optimised for the determination of salmeterol and fluticasone propionate in good validation data was achieved. This thesis shows that, in general, the performance of O/W NELC is superior to that of conventional High Performance Liquid Chromatography (HPLC) for the analysis of both hydrophilic and lipophilic drugs in inhaled dosage formulations and urine samples. It has been shown that NELC uses cheaper solvents and that analysis time is faster for aqueous and urine samples. This considerable saving in both cost and time will potentially improve efficiency within quality control.

This thesis is based around examination of three mainstream inhaled drugs Formoterol, Budesonide and Beclomethasone for treatment of asthma and COPD. The areas investigated are these which have been raised in reports and studies, where there are concern, for drug use and assessment of their use. In reporting this work the literature study sets out a brief summary of the background and anatomy and physiology of the respiratory system and then discuses the mechanism of drug deposition in the lung, as well as the methods of studying deposition and pulmonary delivery devices. This section includes the basis of asthma and COPD and its treatment. In addition, a short section is presented on the role of the pharmacist in improving asthma and COPD patient's care. Therefore the thesis is divided into 3 parts based around formoterol, budesonide and beclomethasone. In the first case the research determines the in-vitro performance of formoterol and budesonide in combination therapy. In the initial stage a new rapid, robust and sensitive HPLC method was developed and validated for the simultaneous assay of formoterol and the two epimers of budesonide which are pharmacologically active. In the second section, the purpose was to evaluate the aerodynamic characteristics for a combination of formoterol and the two epimers of budesonide at inhalation flow rates of 28.3 and 60 L/min. The aerodynamic characteristics of the emitted dose were measured by an Anderson cascade impactor (ACI) and the next generation cascade impactor (NGI). In all aerodynamic characterisations, the differences between flow rates 28.3 and 60 were statistically significant in formoterol, budesonide R and budesonide S, while the differences between ACI and NGI at 60 were not statistically significant. Spacers are commonly used especially for paediatric and elderly patients. However, there is considerable discussion about their use and operation. In addition, the introduction of the HFAs propellants has led to many changes in the drug formulation characteristics. The purpose of the last section is to examine t h e performance of different types of spacers with different beclomethasone pMDIs. Also, it was to examine the hypothesis of whether the result of a specific spacer with a given drug/ brand name can be extrapolated to other pMDIs or brand names for the same drug. The results show that there are different effects on aerodynamic characterisation and there are significant differences in the amount of drug available for inhalation when different spacers are used as inhalation aids. Thus, the study shows that the result from experiments with a combination of a spacer and a device cannot be extrapolated to other combination.

This thesis is based around examination of three mainstream inhaled drugs Formoterol, Budesonide and Beclomethasone for treatment of asthma and COPD. The areas investigated are these which have been raised in reports and studies, where there are concern, for drug use and assessment of their use. In reporting this work the literature study sets out a brief summary of the background and anatomy and physiology of the respiratory system and then discuses the mechanism of drug deposition in the lung, as well as the methods of studying deposition and pulmonary delivery devices. This section includes the basis of asthma and COPD and its treatment. In addition, a short section is presented on the role of the pharmacist in improving asthma and COPD patient¿s care. Therefore the thesis is divided into 3 parts based around formoterol, budesonide and beclomethasone. In the first case the research determines the in-vitro performance of formoterol and budesonide in combination therapy. In the initial stage a new rapid, robust and sensitive HPLC method was developed and validated for the simultaneous assay of formoterol and the two epimers of budesonide which are pharmacologically active. In the second section, the purpose was to evaluate the aerodynamic characteristics for a combination of formoterol and the two epimers of budesonide at inhalation flow rates of 28.3 and 60 L/min. The aerodynamic characteristics of the emitted dose were measured by an Anderson cascade impactor (ACI) and the next generation cascade impactor (NGI). In all aerodynamic characterisations, the differences between flow rates 28.3 and 60 were statistically significant in formoterol, budesonide R and budesonide S, while the differences between ACI and NGI at 60 were not statistically significant. Spacers are commonly used especially for paediatric and elderly patients. However, there is considerable discussion about their use and operation. In addition, the introduction of the HFAs propellants has led to many changes in the drug formulation characteristics. The purpose of the last section is to examine t h e performance of different types of spacers with different beclomethasone pMDIs. Also, it was to examine the hypothesis of whether the result of a specific spacer with a given drug/ brand name can be extrapolated to other pMDIs or brand names for the same drug. The results show that there are different effects on aerodynamic characterisation and there are significant differences in the amount of drug available for inhalation when different spacers are used as inhalation aids. Thus, the study shows that the result from experiments with a combination of a spacer and a device cannot be extrapolated to other combination.