Spelling suggestions: "subject:"qual pontoon"" "subject:"cual pontoon""
1 |
Study on the dynamics of a moored floating dual pontoonChen, Wei-Ming 05 September 2008 (has links)
This paper is to study the scattering problem and radiation problem between incident wave and a moored dual pontoon platform by using both a fully nonlinear numerical wave tank (NWT) and a physical tank. The nonlinear numerical wave tank is developed based on the velocity potential function and the boundary element method (BEM). In addition, a moored dual floating pontoon physical model is tested in an experimental wave tank to validate the numerical model for simulation of wave and structure interaction including mooring tension, structure translation and rotation. The phenomena of wave reflection and transmission due to a floating platform are also considered in the study.
The experimential results indicate that the platform surge-RAO decays as the wave frequency increases. Similarly, the platform heave-RAO decays first until at the vicinity of the resonance frequency happening where the vertical amplitude rises up and then decays again. The tension-RAO has two resonance frequencies, the lower resonance is resulted by the surge montion, while the higer resonance is caused by the heave motion. Both wave reflection and transmission coefficients decrease near the heave resonance frequency. This indicates that the platform has the best performance in wave shelter effect at heave resonance to protect costal zone.
In general, the comparisons of the numerical simulations and experimental results indicate the numerical horizontal motion have a good agreement, but for the vertical motion, the numerical predictions are larger than experiments especially near the heave resonance frequency. This may be due to the structure vertical velocity increases dramatically causing flow separation occurred below the structure sharp corner, thus the fluid viscous damping effect may play an important role in heave motion.
|
2 |
Dynamic analysis of a floating barge with a liquid containerFeng, Chih-ting 27 May 2010 (has links)
This study is to develop a 2D fully nonlinear numerical wave tank used to investigate the wave-induced dynamic properties of a dual pontoon floating structure (DPFS) with a liquid container on the top. The nonlinear numerical wave tank, developed based on the velocity potential function and the boundary element method (BEM), is to simulate dynamic properties including sway, heave, roll, and tension response. In addition, a physical model of the dual floating pontoon is tested in a hydrodynamic wave tank to validate the numerical model for simulation of wave and structure interaction.
In the numerical model, a boundary integral equation method (BIEM) with linear element scheme is applied to establish a 2D fully nonlinear numerical wave tank (NWT). The nonlinear free surface condition is treated by combining the Mixed Eulerian and Lagrangian method (MEL), the fourth-order Runge-Kutta method (RK4) and a cubic spline scheme. The second-order Stokes wave theory is used to generate the velocity flux on the input boundary. Numerical damping zones are deployed at both ends of the NWT to dissipate or absorb the transmitted and reflected waves. Acceleration potential method and modal decomposition method are adopted to solve the unsteady potential functions £X1,t and £X2,t, while the system of motion equation is established according to Newton's 2nd law. Finally, the RK4 is applied to predict the motion of the platform, and the variation of free surface. As for the hydrodynamic laboratory model test, an image process scheme is applied to trace the floating structure motion and the variation of water surface inside the sloshing tank, while the mooring tension is measured by a load cell and stored in a data logger.
The comparisons of numerical simulations and experimental data indicate that the numerical predictions are larger than measurements especially near the resonance frequency. This discrepancy is probably due to the fluid viscous effect. To overcome this problem and maintain the calculation efficiency, an uncoupled damping coefficient obtained through a damping ratio (£a=C/Ccr=0.02) is incorporated into the vibration system. Results reveal that responses of body motion near the resonant frequencies of each mode have significantly reduced and close to the measurements. Therefore, the suitable value of the damping ratio for the floating platform is £a=0.02.
Then the numerical model with a damping ratio is applied to investigate the dynamic properties of the floating platform for different arrangements, including different mooring angle, spring constant, spacing, and the liquid container. Results demonstrate that the resonant frequency of each mode, responses of body motion and mooring tensions change along with the settings. As a whole, the platform with smaller mooring angle, longer spacing between the pontoons, higher water depth and wider width of the liquid container has relatively stable body motions and less mooring tension.
Finally, the comparisons of the effects of random and regular waves on the floating structure illustrate that the variation of water surface in the liquid container is much severe in random waves than in regular waves such that the interaction between liquid and floating structure is more chaotic and thus reduces the amplitude of each response mode. As a result, the mooring tensions for random waves become much gentler than the regular waves.
Key words: Boundary integral equation method; fully nonlinear numerical wave tank; dual pontoon floating structure
|
Page generated in 0.0515 seconds