Jet Electrochemical Machining (Jet-ECM) is a manufacturing technique that applies a free electrolyte jet to generate the desired shapes [1]. Since the principle of the technique is the same as other techniques of Electrochemical Machining where the material removal takes place based on the anodic dissolution of workpiece, the working distance, which is the distance between nozzle’s front surface and the workpiece surface, is one important parameter of the process. The working distance affects the current density and consequently the geometry removal. The control of the working distance can be done based on the data gathered before and during machining by surface measurement [2]. This measurement usually is done by using electrostatic probing to detect a limited amount of points of the initial workpiece surface. Since electrostatic probing is comparatively slow, laser triangulation represents an alternative technique to detect a larger amount of points before machining within significantly shorter time [3]. In addition to electrostatic probing and laser triangulation, the actual working distance can be measured during the machining process to realize constant working distance. This can be done by detecting electrical signals like the actual total current. This method can be combined with pre-machining measurement by laser triangulation in order to ensure the prevention of any collision between the nozzle and the workpiece. In this study, on-machine metrology techniques for measuring the working gap as well as current measurements will be compared. Besides, the advantages and disadvantages of these techniques will be systematized. In further studies, the possibility of combining the techniques will be investigated to enhance Jet-ECM with more accurate measurement techniques.

Jet Electrochemical Machining (Jet-ECM) is a manufacturing technique that applies a free electrolyte jet to generate the desired shapes [1]. Since the principle of the technique is the same as other techniques of Electrochemical Machining where the material removal takes place based on the anodic dissolution of workpiece, the working distance, which is the distance between nozzle’s front surface and the workpiece surface, is one important parameter of the process. The working distance affects the current density and consequently the geometry removal. The control of the working distance can be done based on the data gathered before and during machining by surface measurement [2]. This measurement usually is done by using electrostatic probing to detect a limited amount of points of the initial workpiece surface. Since electrostatic probing is comparatively slow, laser triangulation represents an alternative technique to detect a larger amount of points before machining within significantly shorter time [3]. In addition to electrostatic probing and laser triangulation, the actual working distance can be measured during the machining process to realize constant working distance. This can be done by detecting electrical signals like the actual total current. This method can be combined with pre-machining measurement by laser triangulation in order to ensure the prevention of any collision between the nozzle and the workpiece. In this study, on-machine metrology techniques for measuring the working gap as well as current measurements will be compared. Besides, the advantages and disadvantages of these techniques will be systematized. In further studies, the possibility of combining the techniques will be investigated to enhance Jet-ECM with more accurate measurement techniques.