Coastal anthropogenic infrastructure has significantly modified nearshore environments. Because these structures often have a strong association with shipping as would be found in ports and harbors, they have been identified as invasion hotspots. Due to propagule pressure from shipping and recreational boating and suitable uncolonized substrate that provides a refuge from native predators, a greater number of non-native species have been found on these structures compared to nearby natural substrate. The mechanisms that limit the spread of non-native species from anthropogenic structures to natural substrate have been explored for several taxa at a species-specific level, but less so from an overall community perspective. Predation has been identified as one of the biotic interactions limiting invasion success. In addition to predation, dispersal ability may also prevent the spread of non-native species from anthropogenic structures to natural substrate. This thesis addresses how these two mechanisms interact to limit the spread of non-native species from anthropogenic structures to natural substrate and how that alters overall community composition. I aimed to explore differences between communities inside and outside of a marina and determine the extent to which predator and dispersal limitation were structuring these communities. I used a three-factor design, deploying seven unglazed ceramic tiles per each treatment combination of 1) inside versus outside a marina in Yaquina Bay, Oregon; 2) cage keeping out predators greater than the mesh size, no cage, or partial cage; 3) fixed near the substrata (benthic) versus suspended 1 meter below the surface. I also transplanted caged, suspended tiles of either adults or recruits from inside the marina to benthic and suspended caging treatments outside of the marina. These tiles allowed me to examine predation when dispersal limitation was not a factor for the community inside the marina, i.e. what happens to both recruits and adults if they can get outside of the marina. I found that the communities inside and outside of the marina were different and the data suggest that both predation and dispersal limitation interact to limit the spread of non-native species. Additionally, I found that mesopredators that could fit through the caging may be influencing predation results and community structure. This research addresses gaps in scientific knowledge regarding the mechanisms that prevent or facilitate the spread of non-native species. Future work could include the further exploration of mesopredation as an important factor in limiting the spread of non-native species and exploring dispersal limitation more in depth as well as broadening the geographic scope to see if the same trends hold true across bays and bioregions.

The marine surface-associated bacterium Pseudoaltermonas tunicata, produces a range of compounds that inhibit fouling organisms, including invertebrate larvae, bacteria, algal spores and fungi. In addition to these antifouling compounds P. tunicata cells produce both a yellow and a purple pigment. The aim of this study was to further characterise the antifouling activities, their regulation and relationship with pigmentation, and the ecological significance of P. tunicata and related organisms. It was discovered that the anti-algal compound was extracellular, heat sensitive, polar and between 3 and 10 kDa in size. The anti-fungal compound was found to be the yellow pigment and active against a wide range of fungal and yeast isolates. Chemical analysis suggests that this compound consists of a carbon ring bound to a fatty-acid side chain. Genetic analysis supports the chemical data for the active compound as a mutant in a gene encoding for a long-chain fatty-acid CoA ligase was deficient for anti-fungal activity. To address the regulation of antifouling compounds and their relationship to pigmentation transposon mutagenesis of P. tunicata was performed. Mutants lacking the yellow pigment displayed a reduced ability to inhibit fouling organisms. Further analysis of these mutants identified genes involved with the synthesis and regulation of synthesis of pigment and antifouling compounds. One of these mutants was disrupted in a gene (wmpR) with similarity to the transcriptional regulators ToxR from Vibrio cholerae and CadC from Escherichia coli. Analysis of global protein expression using two-dimensional gel electrophoresis showed that WmpR is essential for the expression of at least fifteen proteins important for the synthesis of fouling inhibitors. The ecological significance of antifouling bacteria was addressed by assessing the antifouling capabilities of a collection of bacteria isolated from different marine surfaces. Overall, isolates from living surfaces displayed more antifouling traits then strains isolated from non-living surfaces. Five dark-pigmented strains originating from the alga Ulva lactuca were further studied. Phylogenetic and phenotypic analysis revealed that they were all members of the genus Pseudoalteromonas and were closely related to P. tunicata. Two strains represented a novel species within the genus and were taxonomically defined as P. ulvae sp. nov.

Particles and macromolecular components, including biopolymers (protein and carbohydrate), are viewed as the main foulants in the complex feed submerged membrane filtration systems such as membrane bioreactor (MBR). This work focused on two aspects of fouling in complex fluids: 1- Assessing fouling propensity and mechanisms for various model solutions. 2- Using of two specific solutions modelling biomass found in MBR for a better understanding of the fouling mechanisms in submerged MBR processes. Filtrations were carried out with 0.22 ??m PVDF hollow fibre membrane. Alginate was used as a model for polysaccharide, bovine serum albumin (BSA) as a model for protein, (un)washed yeast and bentonite were representing suspended solid contents. According to the data obtained during this study the fouling propensity of each model solution was classified as follow in a decreasing order: Alginate &gt unwashed yeast &gt washed yeast &gt BSA &gt bentonite for one-component solutions; and Alginate-washed yeast &gt Alginate-BSA &gt Alginate-bentonite &gt Alginate-unwashed yeast for two-component solutions. Introducing the alginate increased the reversible fouling (except BSA). Passive adsorption had a significant effect on fouling of alginate even before the beginning of the filtration. Washed yeast and a mixture of washed yeast + BSA were then used as model solutions to simulate the activated sludge found in MBR. The concentration of washed yeast and BSA used in this study were calculated in order for the characterisations of the two model solution to match (in terms of biopolymer contents) those of MBR biomasses reported in the literature. By rinsing, backwashing and chemical cleaning of the membrane, three fouling layers of upper, intermediate and lower were defined respectively. Results obtained from the analysis of the biopolymers found in the cleaning solutions allow a better understanding of the fouling mechanisms occurring for the two model solutions used in this study: for washed yeast, the lower layer and for washed yeast + BSA , the upper and intermediate layers were found to have relatively high biopolymeric composition. This was explained by higher concentration of solids on the membrane surface and by higher biopolymer interactions when washed yeast was mixed with BSA.

Particles and macromolecular components, including biopolymers (protein and carbohydrate), are viewed as the main foulants in the complex feed submerged membrane filtration systems such as membrane bioreactor (MBR). This work focused on two aspects of fouling in complex fluids: 1- Assessing fouling propensity and mechanisms for various model solutions. 2- Using of two specific solutions modelling biomass found in MBR for a better understanding of the fouling mechanisms in submerged MBR processes. Filtrations were carried out with 0.22 ??m PVDF hollow fibre membrane. Alginate was used as a model for polysaccharide, bovine serum albumin (BSA) as a model for protein, (un)washed yeast and bentonite were representing suspended solid contents. According to the data obtained during this study the fouling propensity of each model solution was classified as follow in a decreasing order: Alginate &gt unwashed yeast &gt washed yeast &gt BSA &gt bentonite for one-component solutions; and Alginate-washed yeast &gt Alginate-BSA &gt Alginate-bentonite &gt Alginate-unwashed yeast for two-component solutions. Introducing the alginate increased the reversible fouling (except BSA). Passive adsorption had a significant effect on fouling of alginate even before the beginning of the filtration. Washed yeast and a mixture of washed yeast + BSA were then used as model solutions to simulate the activated sludge found in MBR. The concentration of washed yeast and BSA used in this study were calculated in order for the characterisations of the two model solution to match (in terms of biopolymer contents) those of MBR biomasses reported in the literature. By rinsing, backwashing and chemical cleaning of the membrane, three fouling layers of upper, intermediate and lower were defined respectively. Results obtained from the analysis of the biopolymers found in the cleaning solutions allow a better understanding of the fouling mechanisms occurring for the two model solutions used in this study: for washed yeast, the lower layer and for washed yeast + BSA , the upper and intermediate layers were found to have relatively high biopolymeric composition. This was explained by higher concentration of solids on the membrane surface and by higher biopolymer interactions when washed yeast was mixed with BSA.

South Africa, strategically situated at the southern tip of Africa, is edged on three sides by almost 3000 km of coastline surrounded by the Indian Ocean and the Atlantic Ocean (South African Tourism, 2011). This vast ocean expanse is responsible for conveying approximately 96% of South Africa’s exports (Brand South Africa, 2011). Despite the positive economic effects of the shipping industry, translocation of harmful organisms and pathogens via ballast water and sediments inside ballast water tanks has far reaching global environmental (and economic) impacts (Oliviera, 2008:1; David and Gollasch, 2008:1966). Ballast water is the water that is taken on in order to manage the draft of the ship, to help with propulsion, manoeuvrability, trim control, list and stability (Oliviera, 2008:2). The discharge of ballast water into the world’s oceans has resulted in the transfer of ecologically harmful sea-life into non-native environments (IMO, 2011), resulting in major environmental threats to our oceans (Bax, Williamson, Aguero, Gonzalez and Geeves, 2003:313). Various international documents have been developed to deal with the ballast water issue, culminating in the introduction of the International Convention for the Control and Management of Ships’ Ballast Water and Sediments (“the Convention”) in 2004. The Convention aims at achieving a reduction in the transfer and subsequent impacts of aquatic organisms via the ballast water and sediment of ships. On a local level, South Africa does not have direct legislation or regulations dealing with ballast water (Duncan, 2007:34) and relies on the combination of a number of pieces of legislation relating to environmental management, coastal management, biodiversity, alien invasive species control, port control and ship safety (National Environmental Management Act, 1998, National Environmental Management: Biodiversity Act, 2004, National Environmental Management: Integrated Coastal Management Act, 2009, National Ports Act, 2005 and Merchant Shipping Act, 1951). Although the Convention was ratified by South Africa in 2008 (Department of International Relations and Cooperation, 2011) it is still not in force and there still exists no other consolidated legal mechanism through which ballast water is managed. This research has investigated the various roles, responsibilities and mandates of South African competent authorities under the aforementioned legislation in managing ballast water, and has determined that there is definite legislative and institutional fragmentation as well as overlaps. A comparative analysis of management frameworks developed both locally and internationally was conducted in order to develop a management framework for ballast water management in South Africa. Various legislative, institutional and functional aspects were identified and adapted for inclusion in a South African management framework. A co-ordinated approach to ballast water management has been developed in the management framework which is anticipated to result in more definitive roles and responsibilities of the various South African departments involved in the management of ballast water and implementation of the Convention.

published_or_final_version / abstract / Environmental Management / Master / Master of Science in Environmental Management

Marine non-native species threaten economic and environmental health, making it crucial to understand factors that make them successful. Research on these species, therefore, allows for greater preparedness and informed management of biological invasions and increases understanding of elements structuring biological communities. Among the marine non-native species, and particularly the fouling community, non-native ascidians are a taxon of particular concern because they can crowd out native benthic species and smother mariculture products. This thesis addresses management for ascidians and other fouling organisms and includes research on the invasiveness of this taxon in addition to the invasibility of recipient fouling communities. On the West Coast of the U.S., limited efforts have been made to coordinate biofouling management across states, despite the myriad vectors increasing propagule pressure over time along coastal states. Building on recent state and local efforts, I developed a Pacific Regional Biofouling Plan for the states of Oregon and Washington to help start a consensus-driven process by which these states could create a forum for more comprehensive coordination efforts, following California's lead. As states address authority gaps, the biofouling management framework I've written is meant to be used to guide the conversation between managers as various stages of coastal management are realized. To better inform the scope and efficacy of management and regulatory efforts, the study of invasions ecology asks and aims to answer questions regarding recipient community interactions and characteristics of the non-native species themselves. Studies that identify characteristics that make ascidians successful (invasiveness) and determine the influence native communities have on their success (invasibility) are important for assessing overall risk of establishment and spread from non-native ascidians. Therefore, I aimed to: 1) explore the hypothesis that fouling communities on suspended, artificial structures are more invasible than benthic habitats; and 2) identify characteristics influencing predation patterns on the native Distaplia occidentalis versus non-native ascidian species using mensurative and experimental studies in Charleston Marina, Oregon. I conducted a series of feeding assays, surveys, and a caloric content analysis. Feeding assays were conducted with a suite of predators. The flatworm predator (Eurylepta leoparda) was found to be highly selective on the native ascidian Distaplia occidentalis, and only preyed on whole colony samples. Feeding assay data suggest that test (tunic) structure or thickness may be an influential factor affecting nudibranch (Hermissenda crassicornis) predation rates on native versus non-native ascidians, with greater predation on the native ascidian species. Non-native ascidians may escape predation in floating but not benthic environments on the Oregon coast due to their palatability characteristics, likely tunic structure and low caloric content. In this case, this suite of predators may indirectly facilitate the invasion of docks but provide at least partial resistance to the invasion of natural benthic areas. The chapters herein address gaps in management and scientific knowledge regarding non-native species of the marine fouling community. Future work enhanced by my efforts could include the development of the coastal biofouling management plan, coordinated by the Western Regional Panel on Aquatic Invasive Species Coastal Committee, and broadening the geographic and taxonomic scope of my research with a more comprehensive study of predator-prey interactions involving non-native ascidians and a diverse suite of predators. These interactions may be an important factor in explaining the success of ascidians and other fouling organisms on floating structures and lack of success on nearby benthic substrata.