Vita. / Digitized by Kansas Correctional Industries

Typescript (photocopy). / Digitized by Kansas Correctional Industries

[Truncated abstract] The demand for offshore wind turbines is increasing in densely populated areas, such as Europe. These constructions are typically founded on a gravity foundation or a large 'mono pile'. Gravity foundations can only be used at locations where strong soils exist and water depths are limited. Costs associated with a 'mono pile' type foundation contribute to a very large percentage of the total investment costs. This research, therefore, focuses upon a different foundation for offshore wind turbines, namely suction caissons beneath a tripod. This foundation can be used in all kinds of soil types and is cheaper than the 'mono pile' foundation, both in the amount of steel used and installation costs. Cheaper foundations can contribute to a more competitive price for offshore wind energy in comparison with other energy resources. To date, there have been relatively few studies to investigate the behaviour of this type of foundation during the installation process and during operational and ultimate loading for seabed conditions comprising dense sand. Two types of investigations were performed during this research to determine the behaviour of suction caissons beneath a tripod. Firstly, an existing computer program was extended to predict the typical loading conditions for a tripod foundation. Secondly, centrifuge tests on small scale suction caissons were performed to investigate the behaviour during the installation and loading phases. The computer program developed helped to quantify the likely ranges of environmental loading on an offshore wind turbine. For a typical 3 MW wind turbine of 90 m height, the vertical load is low at around 7 MN. During storm conditions the horizontal hydrodynamic load can be in the order of 4 MN. During normal working conditions the horizontal aerodynamic loads can reach 0.4 MN, but can increase to 1.2 MN when the pitch system malfunctions and gusts reach 30 m/s. This aerodynamic load will result in a very large contribution to the overturning moment, due to the high action point of this load. When the wind turbine is placed on top of a tripod, these large moments are counteracted by a push-pull system. ... The development of differential pressure was found to depend on the soil permeability, the extraction speed and a consolidation effect. During cyclic loading no obvious signs of a decrease in resistance were observed. During very fast cyclic loading differential pressures developed, which could increase the drained frictional resistance by approximately 40%. All centrifuge tests results were used to develop methods to predict or back calculate the installation process of suction caissons in sand and layered soil, and the behaviour during tensile and cyclic loading. These methods all use the cone resistance as the main input parameter and predict the force (or required suction) as a function of time, for a given rate of pumping or uplift displacement, in addition to the variation of suction with penetration (or force with uplift displacement). These new methods provide a useful tool in designing a reliable foundation for offshore wind turbines consisting of a tripod arrangement of suction caissons embedded in dense sand.

Thesis (MScEng (Civil Engineering))--University of Stellenbosch, 2009. / ENGLISH ABSTRACT: In regions of moderate seismicity it has been shown that a suitable structural system is created when designing the shear wall with a plastic hinge zone at the lower part of the wall, with the shear walls resisting lateral loads and all other structural elements designed to resist gravity loads. A suitably stiff foundation is required for the assumption of plastic hinge zones to hold true. This foundation should have limited rotation and should remain elastic when lateral loads are applied to the structure. Ensuring a foundation with a greater capacity than the shear wall results in excessively large shear wall foundations being required in areas of moderate seismicity for buildings with no basement level. This study aims to investigate the feasibility of reducing the size of shear wall foundations in areas of moderate seismicity for buildings with no basement level. The investigation is aimed at allowing shear wall foundation rocking and taking into account the contribution of structural frames to the lateral stiffness of the structure. An example building was chosen to investigate this possibility. Firstly, lateral force-displacement capacities were determined for a shear wall and an internal reinforced concrete frame of this investigated building. Nonlinear momentrotation behaviour was determined for the wall foundation size that would traditionally be required as well as for six other smaller foundations. The above capacity curves against lateral loads were then used to compile a simplified model of the structural systems assumed to contribute to the lateral stiffness of the building. This simplified model therefore combined the effect of the shear wall, internal frame and wall foundation. Nonlinear time-history analyses were performed on this simplified model to investigate the dynamic response of the structure with different wall foundation sizes. By assessing response results on a global and local scale, it was observed that significantly smaller shear wall foundations are possible when allowing foundation rocking and taking into account the contribution of other structural elements to the lateral stiffness of the building. / AFRIKAANSE OPSOMMING: Daar is reeds getoon dat ʼn voldoende strukturele sisteem verkry word in gebiede van gematigde seismiese risiko indien ʼn skuifmuur ontwerp word met ʼn plastiese skarnier sone naby die ondersteuning van die muur. Skuifmure word dan ontwerp om weerstand te bied teen laterale kragte met alle ander strukturele elemente ontwerp om gravitasie kragte te weerstaan. Vir die aanname van plastiese skarnier sones om geldig te wees word ʼn fondasie met voldoende styfheid benodig. Só ʼn fondasie moet beperkte rotasie toelaat en moet elasties bly wanneer laterale kragte aan die struktuur aangewend word. ʼn Fondasie met ʼn groter kapasiteit as dié van die skuifmuur lei daartoe dat uitermate groot fondasies benodig word in gebiede van gematigde seismiese risiko vir geboue met geen kelder vlak. Hierdie studie is daarop gemik om die moontlikheid van kleiner skuifmuur fondasies te ondersoek vir geboue met geen kelder vlak in gebiede van gematigde seismiese risiko. Die ondersoek het ten doel om skuifmuur fondasie wieg aksie toe te laat en die bydrae van strukturele rame tot die laterale styfheid van die struktuur in ag te neem. Eerstens is die laterale krag-verplasing kapasiteit van ʼn skuifmuur en ʼn interne gewapende beton raam van die gekose gebou bepaal. Nie-lineêre moment-rotasie gedrag is bepaal vir die skuifmuur fondasie grootte wat tradisioneel benodig sou word asook vir ses ander kleiner fondasie grotes. Die bogenoemde kapasiteit kurwes is gebruik om ʼn vereenvoudigde model van die strukturele sisteme wat aanvaar word om laterale styfheid tot die gebou te verleen, op te stel. Hierdie vereenvoudigde model kombineer gevolglik die effek van die skuifmuur, interne raam en skuifmuur fondasie. Nie-lineêre tydgeskiedenis analises is uitgevoer op die vereenvoudigde model ten einde die dinamiese reaksie van die struktuur te ondersoek vir verskillende fondasie grotes. Resultate is beoordeel op ʼn globale en lokale vlak. Daar is waargeneem dat aansienlik kleiner skuifmuur fondasies moontlik is deur wieg aksie van die fondasie toe te laat en die bydrae van ander strukturele elemente tot die laterale styfheid van die gebou in ag te neem.