The research objectives for this project were to explicitly define the anchor bolt corrosion problem in the state of Georgia and recommend action to the Georgia Department of Transportation. The bearing assembly of concern is the plate bearing assembly, in which carbon steel and/or bronze plates are anchored by either carbon steel or stainless steel anchor bolts. Inspection report data revealed that anchor bolt corrosion was ubiquitous for all environments in Georgia; the problem was reported for 27% of the steel girder bridges throughout the state. Based on a synthesis of the field investigations, bolt failure analyses, laboratory experimental testing, and review of GDOT inspection report surveys, the corrosion of carbon steel anchor bolts is caused universally by concentration cell corrosion. Other corrosion mechanisms of concern are galvanic and crevice corrosion, which are both enhanced by the current bearing design. Corrosion protection provided through zinc galvanization cannot sufficiently protect the carbon steel bolt for its entire service life. Corrosion potential and cyclic polarization data confirmed that ASTM Type 304, Type 316, Type 2101, and Type 2205 were protected from concentration cell and localized corrosion in the simulated bearing environment. Therefore, it is recommended that the stainless steel anchor bolts of these types be use in future designs and that the bolts should be electrically separated from all dissimilar metals using a Nylon or Teflon washer to prevent preferential corrosion of carbon steel. It is further recommended that the bronze lube plate should be eliminated entirely and that the bearing type should be a reinforced elastomeric bearing. Maintenance of existing sliding plate bearings should include regular cleaning by brushing away debris from the bearing surfaces, and bridges with carbon steel anchor bolts should be retrofitted to provide additional lateral restraint according to current maintenance procedures.

This thesis examines the marginal cost of congested travel to a variety of businesses by observing time spent in congestion and estimating excess labor costs based upon the relevant value of time. The fleets in the scoping study represented commercial deliveries of goods and services, government agencies, and transit systems. Observations on limited-access expressways within the 13-county Atlanta metropolitan region were used in the analysis. Vehicles were monitored by using a passive GPS assembly that transmitted speed and location data in real-time to an off-site location. Installation and operation during the observation period required no interaction from the driver. Over 217 hours of good freeway movement during 354 vehicle-days was recorded. Rates of delay, expressed as a unit of lost minutes per mile traveled, were calculated by taking the difference in speeds observed during congestion from an optimal free-flow speed of 45 mph and dividing that by the distance traveled per segment. The difference between the 50th and 95th percentile delay rates was used as the measure for travel unreliability. Daily average values of extra time needed per fleet vehicle to ensure on-time arrivals were derived, and the median buffer across all fleets was 1.65 hours of added time per vehicle. Weekly marginal costs per fleet vehicle were estimated by factoring in the corresponding driver wages or hourly operation costs (for transit fleets). Equivalent toll rates were calculated by multiplying the 95th percentile delay rate by the hourly costs. The equivalent toll per mile traveled was representative of an equal relationship between the marginal costs of congestion experienced and a hypothetical state of free-flow travel (under first-best rules of marginal cost pricing). The median equivalent toll rates across all fleets was $0.43 per mile for weekday mornings, $0.13 per mile for midday weekdays, $0.53 per mile for afternoon weekdays and $0.01 per mile for weekday nights and weekends.