No description available.

No description available.

Hand transmitted vibration (HTV) is one of the most common hazards faced by workers in the construction industry. A major source of HTV is hand held percussion tools, such as pneumatically driven chipping hammers and rock drills. This thesis presents a new approach to measuring the vibration from these tools using an experimental hand arm model to which the tools are attached. The experimental hand-arm model has been designed to have similar dynamic characteristics to that of a human hand-arm system. This approach addresses the issue of repeatability as HTV measurements suffer from variability between cases. The measured acceleration of the hand-arm system is in range or close to range of the measured accelerations of the test subjects with superior repeatability. Further, the thesis presents a nonlinear numerical model of a pneumatic impact hammer. Fundamentally, the numerical model was made up of two different sub-models, 1) a fluid flow model and 2) a structural dynamic model. The fluid flow model was based on the equations for mass flow rate of air though a bleed orifice assuming an isentropic process. The second sub-model deals with modeling the structural components of the impact hammer consisting of the major hammer like the center body, handle, piston and chisel as well as the human hand and the ground. Time domain simulations of the hammer were carried out by using a state space formulation to get displacements, velocities and accelerations of the each component as well as the exhaust jet velocities. Experiments were carried out to measure the handle response and exhaust jet velocities as well as pressure profiles. The results obtained from the numerical model were then validated using these experimental results. Finally, a parametric study using the numerical model was carried out to explore different vibration control techniques. / Master of Science

In many occupations, exposure to hand-transmitted vibration (HTV) over a prolonged period causes various disorders involving the vascular, neural and musculoskeletal systems, collectively known as the hand-arm vibration syndrome (HAVS). It is a complex and potentially disabling chronic disorder of the upper extremities, especially of the hands. Numbness, tingling, reduced tactile discrimination, and impaired manipulative dexterity are often reported by workers exposed to HTV. The precise pathophysiological mechanism responsible for vascular injuries in HAVS has not yet been fully clarified; it seems to be multifactorial and highly complex. Interaction of neural signals, hormones, mediators and changes in the blood vessel itself appear to contribute to the development of such vascular injuries. This study aims to assess the risk of the hand-transmitted vibration exposure during pneumatic impact wrench operation in a rock drill repair and maintenance workshop at a South African platinum mine. A total of 8 workers working on a day to day basis with impact wrenches were available for this study. For each of the workers a control (not exposed to vibration) was selected on the basis of gender, ethnic group, smoking habits, age and body mass index (BMI). Grip force, dexterity and hand-eye co-ordination were tested on the workers and control group before and after work. Finger systolic blood pressure (FSBP) was also measured after cold provocation of the worker and control groups. Results have shown astatistically significant difference between the two groups with respect coordination, dexterity and FSBP after cold provocation. Vibration measurements shows three workers had values above the suggested ELV of 5 m/s² for an eight hour A (8) workday. With regards to dexterity, workers were capable to manipulate small objects better with their dominant right (vibration exposed) hand after work than before work. In contrast, it seems that the number of pegs correctly inserted by the controls is not uniformly affected by their 8 hour workday. The worker group showed a greater grip force than that of the control group, both before and after work.There was a statistically significant difference between the control and worker group with respect to the number of mistakes during the mirror trace and the time to complete this test only for the right hand. The difference in FSBP after cold provocation between the control and worker group observed is of medium importance when compared with effect sizes, however, there was no statistical significant difference. In this study, it was very difficult to make valid conclusions due to the limitations of a small sample size. A longitudinal study should be conducted preferably using newly appointed workers with no prior exposure to vibration and a sufficient control group to eliminate the effect other confounding variables such as general working conditions. / Thesis (MSc (Occupational Hygiene))--North-West University, Potchefstroom Campus, 2013.

In many occupations, exposure to hand-transmitted vibration (HTV) over a prolonged period causes various disorders involving the vascular, neural and musculoskeletal systems, collectively known as the hand-arm vibration syndrome (HAVS). It is a complex and potentially disabling chronic disorder of the upper extremities, especially of the hands. Numbness, tingling, reduced tactile discrimination, and impaired manipulative dexterity are often reported by workers exposed to HTV. The precise pathophysiological mechanism responsible for vascular injuries in HAVS has not yet been fully clarified; it seems to be multifactorial and highly complex. Interaction of neural signals, hormones, mediators and changes in the blood vessel itself appear to contribute to the development of such vascular injuries. This study aims to assess the risk of the hand-transmitted vibration exposure during pneumatic impact wrench operation in a rock drill repair and maintenance workshop at a South African platinum mine. A total of 8 workers working on a day to day basis with impact wrenches were available for this study. For each of the workers a control (not exposed to vibration) was selected on the basis of gender, ethnic group, smoking habits, age and body mass index (BMI). Grip force, dexterity and hand-eye co-ordination were tested on the workers and control group before and after work. Finger systolic blood pressure (FSBP) was also measured after cold provocation of the worker and control groups. Results have shown astatistically significant difference between the two groups with respect coordination, dexterity and FSBP after cold provocation. Vibration measurements shows three workers had values above the suggested ELV of 5 m/s² for an eight hour A (8) workday. With regards to dexterity, workers were capable to manipulate small objects better with their dominant right (vibration exposed) hand after work than before work. In contrast, it seems that the number of pegs correctly inserted by the controls is not uniformly affected by their 8 hour workday. The worker group showed a greater grip force than that of the control group, both before and after work.There was a statistically significant difference between the control and worker group with respect to the number of mistakes during the mirror trace and the time to complete this test only for the right hand. The difference in FSBP after cold provocation between the control and worker group observed is of medium importance when compared with effect sizes, however, there was no statistical significant difference. In this study, it was very difficult to make valid conclusions due to the limitations of a small sample size. A longitudinal study should be conducted preferably using newly appointed workers with no prior exposure to vibration and a sufficient control group to eliminate the effect other confounding variables such as general working conditions. / Thesis (MSc (Occupational Hygiene))--North-West University, Potchefstroom Campus, 2013.