Spelling suggestions: "subject:"aydrogen passivation"" "subject:"bydrogen passivation""
1 |
Post???deposition processing of polycrystalline silicon thin???film solar cells on low???temperature glass superstratesTerry, Mason L, Photovoltaic & Renewable Energy Engineering, UNSW January 2007 (has links)
In polycrystalline silicon (pc-Si) thin-film solar cells, defect passivation is critical to device performance. Isoelectronic or covalently bonded impurities, hydrogenic, extended defects and defects with localized levels in the bandgap (deep level defects) are typically introduced during the fabrication of, and/or are inherent to, pc-Si thin-film solar cells. These defects dramatically affect minority carrier lifetimes. Removing and/or passivating these defects is required to maximize minority carrier lifetimes and is typically done through thermal annealing and passivation techniques. For pc-Si thin-film solar cells on low temperature glass superstrates, rapid thermal annealing (RTA) and hydrogen plasma passivation (hydrogenation) are powerful techniques to achieve effective removal and passivation of these defects. In this thesis, three silicon thin-film solar cells structures on low-temperature glass are subjected to variations in RTA high-temperature plateaus, RTA plateau times, and hydrogen plasma passivation parameters. These solar cells are referred to as ALICIA, EVA and PLASMA. By varying the RTA plateau temperature and time at plateau, the trade-off between extensive dopant diffusion and maximum defect removal is optimized. To reduce the density of point defects and to electrically activate the majority of dopants, an RTA process is shown to be essential. For all three of the thin-film solar cell structures investigated in this thesis, a shorter, higher-temperature RTA process provides the best open-circuit voltage (Voc). Extensive RTA plateau times cause excessive dopant smearing, increasing n = 2 recombination and shunt resistance losses. Hydrogenation is shown to be an essential step to achieve maximum device performance by `healing' the defects inherent to pc-Si thin-film solar cells. If the hydrogen concentration is about 1-2 times the density of oxygen in the cells as measured by secondary ion mass spectroscopy (SIMS), the cells seem to respond best to hydrogenation, with good resultant Voc and short-circuit for all cells investigated in this thesis. The effect of hydrogen passivation on the Voc is spectacular, typically increasing it by a factor of 2 to 3.5. Hydrogen de-bonding from repeated thermal treatments at increasing temperature provides a deeper understanding of what defects exist and the nature of the defects that limit the cell voltage. The variation in RTA and hydrogenation process parameters produces significant empirical insight into the effectiveness of RTA processes for point defect removal, dopant activation, point defect and grain boundary passivation, and impurity passivation. SIMS measurements are used to determine the impurities present in the cells' bulk and the amount of hydrogen available to passivate defects. From the results presented it appears that pc-Si thin-film solar cells on low-temperature glass are a promising, and potentially lower-cost, alternative to Si wafer based cells.
|
2 |
The Optical Properties of Silicon Nanocrystals and the Role of Hydrogen PassivationWilkinson, Andrew Richard, arw109@rsphysse.anu.edu.au January 2006 (has links)
This thesis examines the optical properties of nanoscale silicon and the sensitization of Er with Si. In this context, it predominantly investigates the role of defects in limiting the luminescence of Si nanocrystals, and the removal of these defects by hydrogen passivation. The kinetics of the defect passivation process, for both molecular and atomic hydrogen, are studied in detail. Moreover, the optical absorption of Si nanocrystals and the effect of annealing environment (during nanocrystal synthesis) on the luminescence are investigated. The effect of annealing temperature and hydrogen passivation on the coupling (energy transfer) of Si nanocrystals to optically active centres (Er) is also examined.¶
The electronic structure of silicon-implanted silica slides is investigated through optical absorption measurements. Before and after annealing to form Si nanocrystals, optical absorption spectra from these samples show considerable structure that is characteristic of the particular implant fluence. This structure is shown to correlate with the transmittance of the samples as calculated from the modified refractive index profile for each implant. Due to the high absorption coefficient of Si at short wavelengths, extinction at these wavelengths is found to be dominated by absorption. As such, scattering losses are surprisingly insignificant.
To eliminate interference effects, photothermal deflection spectroscopy is used to obtain data on the band structure of Si in these samples. This data shows little variance from bulk Si
structure and thus little effect of quantum confinement. This is attributed to the dominance of
large nanocrystals in the absorption measurements.¶
The effect of annealing environment on the photoluminescence (PL) from silicon nanocrystals synthesized in fused silica by ion implantation and thermal annealing is studied as a function of annealing temperature and time. Interestingly, the choice of annealing environment (Ar, N2, or 5 % H2 in N2) is found to affect the shape and intensity of luminescence emission
spectra, an effect that is attributed both to variations in nanocrystal size and the density of defect states at the nanocrystal/oxide interface.¶
The passivation kinetics of luminescence-quenching defects, associated with Si nanocrystals in SiO2, during isothermal and isochronal annealing in molecular hydrogen are studied by time-resolved PL. The passivation of these defects is modeled using the Generalized Simple
Thermal model of simultaneous passivation and desorption, proposed by Stesmans. Values for the reaction-rate parameters are determined for the first time and found to be in excellent
agreement with values previously determined for paramagnetic Si dangling-bond defects (Pb type centers) found at planar Si/SiO2 interfaces; supporting the view that non-radiative recombination in Si nanocrystals is dominated by such defects.¶
The passivation kinetics of luminescence-quenching defects during isothermal and isochronal annealing in atomic hydrogen are studied by continuous and time-resolved PL. The kinetics are compared to those for standard passivation in molecular hydrogen and found to be
significantly different. Atomic hydrogen is generated using the alneal process, through reactions between a deposited Al layer and H2O or OH radicals in the SiO2. The passivation and desorption kinetics are shown to be consistent with the existence of two classes of nonradiative defects: one that reacts with both atomic and molecular hydrogen, and the other that reacts only with atomic hydrogen. A model incorporating a Gaussian spread in activation energies is presented that adequately describes the kinetics of atomic hydrogen passivation and dissociation for the samples.¶
The effect of annealing temperature and hydrogen passivation on the excitation cross-section and PL of erbium in silicon-rich silica is studied. Samples are prepared by co-implantation of Si and Er into SiO2 followed by a single thermal anneal at temperatures ranging from 800 to
1100 degrees C, and with or without hydrogen passivation performed at 500 degrees C. Using time-resolved PL, the effective erbium excitation cross-section is shown to increase by a factor of 3, while the number of optically active erbium ions decreases by a factor of 4 with increasing annealing temperature. Hydrogen passivation is shown to increase the luminescence intensity
and to shorten the luminescence lifetime at 1.54 micron only in the presence of Si nanocrystals. The implications of these results for realizing a silicon-based optical amplifier are also discussed.
|
3 |
Understanding and Implementation of Hydrogen Passivation of Defects in String Ribbon Silicon for High-Efficiency, Manufacturable, Silicon Solar CellsYelundur, Vijay Nag 22 November 2003 (has links)
Photovoltaics offers a unique solution to energy and environmental problems simultaneously. However, widespread application of photovoltaics will not be realized until costs are reduced by about a factor of four without sacrificing performance. Silicon crystallization and wafering account for about 55% of the photovoltaic module manufacturing cost, but can be reduced significantly if a ribbon silicon material, such as String Ribbon Si, is used as an alternative to cast Si. However, the growth of String Ribbon leads to a high density of electrically active bulk defects that limit the minority carrier lifetime and solar cell performance. The research tasks of this thesis focus on the understanding, development, and implementation of defect passivation techniques to increase the bulk carrier lifetime in String Ribbon Si in order to enhance solar cell efficiency. Hydrogen passivation of defects in Si can be performed during solar cell processing by utilizing the hydrogen available during plasma-enhanced chemical vapor deposition (PECVD) of SiNx:H films. It is shown in this thesis that hydrogen passivation of defects during the simultaneous anneal of a screen-printed Al layer on the back and a PECVD SiNx:H film increases the bulk lifetime in String Ribbon by more than 30 ?A three step physical model is proposed to explain the hydrogen defect passivation. Appropriate implementation of the Al-enhanced defect passivation treatment leads to String Ribbon solar cell efficiencies as high as 14.7%. Further enhancement of bulk lifetime up to 92 ?s achieved through in-situ NH3 plasma pretreatment and low-frequency (LF) plasma excitation during SiNx:H deposition followed by a rapid thermal anneal (RTA). Development of an optimized two-step RTA firing cycle for hydrogen passivation, the formation of an Al-doped back surface field, and screen-printed contact firing results in solar cell efficiencies as high as 15.6%. In the final task of this thesis, a rapid thermal treatment performed in a conveyer belt furnace is developed to achieve a peak efficiency of 15.9% with a bulk lifetime of 140 ?Simulations of further solar cell efficiency enhancement up to 17-18% are presented to provide guidance for future research.
|
4 |
Post???deposition processing of polycrystalline silicon thin???film solar cells on low???temperature glass superstratesTerry, Mason L, Photovoltaic & Renewable Energy Engineering, UNSW January 2007 (has links)
In polycrystalline silicon (pc-Si) thin-film solar cells, defect passivation is critical to device performance. Isoelectronic or covalently bonded impurities, hydrogenic, extended defects and defects with localized levels in the bandgap (deep level defects) are typically introduced during the fabrication of, and/or are inherent to, pc-Si thin-film solar cells. These defects dramatically affect minority carrier lifetimes. Removing and/or passivating these defects is required to maximize minority carrier lifetimes and is typically done through thermal annealing and passivation techniques. For pc-Si thin-film solar cells on low temperature glass superstrates, rapid thermal annealing (RTA) and hydrogen plasma passivation (hydrogenation) are powerful techniques to achieve effective removal and passivation of these defects. In this thesis, three silicon thin-film solar cells structures on low-temperature glass are subjected to variations in RTA high-temperature plateaus, RTA plateau times, and hydrogen plasma passivation parameters. These solar cells are referred to as ALICIA, EVA and PLASMA. By varying the RTA plateau temperature and time at plateau, the trade-off between extensive dopant diffusion and maximum defect removal is optimized. To reduce the density of point defects and to electrically activate the majority of dopants, an RTA process is shown to be essential. For all three of the thin-film solar cell structures investigated in this thesis, a shorter, higher-temperature RTA process provides the best open-circuit voltage (Voc). Extensive RTA plateau times cause excessive dopant smearing, increasing n = 2 recombination and shunt resistance losses. Hydrogenation is shown to be an essential step to achieve maximum device performance by `healing' the defects inherent to pc-Si thin-film solar cells. If the hydrogen concentration is about 1-2 times the density of oxygen in the cells as measured by secondary ion mass spectroscopy (SIMS), the cells seem to respond best to hydrogenation, with good resultant Voc and short-circuit for all cells investigated in this thesis. The effect of hydrogen passivation on the Voc is spectacular, typically increasing it by a factor of 2 to 3.5. Hydrogen de-bonding from repeated thermal treatments at increasing temperature provides a deeper understanding of what defects exist and the nature of the defects that limit the cell voltage. The variation in RTA and hydrogenation process parameters produces significant empirical insight into the effectiveness of RTA processes for point defect removal, dopant activation, point defect and grain boundary passivation, and impurity passivation. SIMS measurements are used to determine the impurities present in the cells' bulk and the amount of hydrogen available to passivate defects. From the results presented it appears that pc-Si thin-film solar cells on low-temperature glass are a promising, and potentially lower-cost, alternative to Si wafer based cells.
|
5 |
Poly Silicon on Oxide Contact Silicon Solar CellsKang, Jingxuan 17 April 2019 (has links)
Silicon photovoltaic (PV) is a promising solution for energy shortage and environmental pollution. We are experiencing an era when PV is exponentially increasing. Global cumulative installation had reached 380 GW in 2017. Among which, silicon-based PV productions share more than 90% market. Performance of the first two-generation commercial popular silicon solar cells - Al-BSF and PERC - are limited by metal/Si contacts, where interface defects significantly reduce the open-circuit voltage. In this context, full-area passivation concepts are proposed for c-Si solar cells, with expectation to enhance the efficiency via reducing carrier recombination loss at the contact regions. In this thesis, poly silicon on oxide (POLO) passivating contact is developed for high efficiency c-Si solar cells. We unveiled the working mechanisms of POLO cells and then optimized the device performance based on our conclusion.
We use boiling nitric acid to oxidize c-Si surface, which is of significance to determine the POLO working mechanisms. Phosphorus and boron doped silicon films are deposited by plasma enhanced vapor deposition (PECVD) or low-pressure vapor deposition (LPCVD) followed by high temperature (>800°C) annealing. SiOx structural evolution process under different annealing temperature was observed and the corresponding effects on passivation have been elucidated. The carrier transport mechanisms in the POLO contact annealed at high temperature, e.g. 800°C 900°C, were explored. We unveil that carrier transport in POLO structure is a combination of tunneling and pinhole transport, but dominant at varied temperature regions.
Phosphorus-doped n-type POLO contact is optimized by several parameters, such as doping concentration, film thickness, annealing temperature, film deposition temperature, film relaxation time during annealing process, etc. We successfully obtained minority carrier lifetime over 10ms and contact resistivity lower than 30 mΩ·cm2. Boron-doped p-type POLO contact is also optimized by changing the doping concentration and annealing temperature. Finally, further hydrogen passivation is applied to enhance p-type POLO contact passivation, achieving an iVoc>690 mV, J0 <5 fA/cm2 and contact resistivity 1.3 mΩ·cm2. With the optimized n-type and p-type POLO contacts, an efficiency over 18% is achieved on n-type c-Si solar cells with a flat front surface.
|
6 |
Low-Frequency Noise in Si-Based High-Speed Bipolar TransistorsSandén, Martin January 2001 (has links)
No description available.
|
7 |
Low-Frequency Noise in Si-Based High-Speed Bipolar TransistorsSandén, Martin January 2001 (has links)
No description available.
|
Page generated in 0.102 seconds