Thesis (M.S.)--University of Michigan, 1982.

Thesis (M.S.)--University of Michigan, 1982.

Thesis (M.S.)--Brigham Young University. Dept. of Audiology and Speech-Language Pathology, 2005. / Includes bibliographical references (p. 60-63).

The analysis of white latex paint is a problem for forensic laboratories because of difficulty in differentiation between samples. Current methods provide limited information that is not suitable for discrimination. Elemental analysis of white latex paints has resulted in 99% discriminating power when using LA-ICP-MS; however, mass spectrometers can be prohibitively expensive and require a skilled operator. A quick, inexpensive, effective method is needed for the differentiation of white latex paints. In this study, LIBS is used to analyze 24 white latex paint samples. LIBS is fast, easy to operate, and has a low cost. Results show that 98.1% of variation can be accounted for via principle component analysis, while Tukey pairwise comparisons differentiated 95.6% with potassium as the elemental ratio, showing that the discrimination capabilities of LIBS are comparable to those of LA-ICP-MS. Due to the many advantages of LIBS, this instrument should be considered a necessity for forensic laboratories.

In this dissertation, I use Fourier transform ion cyclotron resonance mass spectrometry (FTICR-MS) to study the structure and energetics of gas phase ions. Infrared multiphoton dissociation spectroscopy (IRMPD) is a technique for measuring the IR spectrum of gas phase ions in a Penning trap. I use this technique to investigate the conformation of cucurbituril complexes, terminal diamines, and protonated amino acids. Cross sectional areas by Fourier transform ion cyclotron resonance mass spectrometry (CRAFTI) is a technique developed by the Dearden lab to measure the cross section of gas phase ions. In this work, I further develop a fundamental understanding of this technique. I investigate the role that dissociation plays in this and other FTICR-MS techniques. I also show that the principles of the CRAFTI technique can be used to measure the pressure inside the cell of an FTICR-MS. This technique, linewidth pressure measurement (LIPS), allows for a quantitative measurement and comparison of CRAFTI cross sections. To demonstrate the improvements to the technique, I measure the CRAFTI cross sections for the 20 standard amino acids and compare these to literature values measured by ion mobility measurements.

Introduction: This dissertation aims to explore, in a clinical setting, the effectiveness of pursed lips breathing (PLB), in the management of dyspnoea in stable COPD. Methodology: A mixed methodology that comprised a randomised controlled trial (RCT), a predominantly qualitative follow-up (FU) study and two measurement studies was used. The RCT intervention group was taught PLB at home over 8 weeks. Primary outcome measures were the Self Report Chronic Respiratory Disease Questionnaire (CRQ-SR) dyspnoea and mastery domains and Endurance Shuttle Walk Test (ESWT). The FU study investigated the long-term experience of PLB in a subset of RCT participants through telephone interview, focus group and observation of PLB technique at home visit. Prior to the RCT a study using limits of agreement (LoA) methodology was conducted to investigate reliability of hand-held spirometric measurement of inspiratory capacity (IC) with a view to using it as an outcome measure. Following the RCT a retrospective analysis of data collected from the ESWT was performed comparing a 1-walk protocol with the published 2-walk protocol. Results: Forty-one patients with COPD were recruited to the RCT (PLB n = 22, control n =19); mean age 68 years (SD 11), mean FEV1% predicted 47% (SD 15.80) and 13 were approached to participate in the FU; 11 of 13 agreed to telephone interview, 5 to attend the focus group and 6 to home visit. The median time since learning PLB was 17 months (6 - 23). The RCT found no statistically significant difference between groups in the primary outcome measures and in retrospect was insufficiently powered. Post hoc analysis found effect sizes for primary outcome measures were: CRQ-SR dyspnoea 0.05, CRQ-SR mastery 0.48 and ESWT 0.44. For secondary outcome measures the PLB group showed a significant (p = 0.02) improvement in oxygen saturation on ESWT. Long-term follow-up found 9 of 11 still used PLB, 8 reported definite benefit. Those using PLB used it for breathlessness with four themes identified: use of PLB with physical activity (8/11), to increase confidence and reduce panic (4/11), as an exercise (3/11), at night (3/11). Discontinuation of PLB (2/11) was due to no benefit. Hand-held spirometric measurement of IC found LoA for same-day IC measurement in healthy volunteers (n = 20) ± 0.630L (95%CI ± 0.255) and over 3 weeks (n = 11) ± 0.560L (95%CI ± 0.326). In COPD, same day LoA (n = 26) were ± 0.582L (95%CI ± 0.169) and over 6 weeks (n = 8) ± 0.486L (95%CI ± 0.302). Retrospective analysis of ESWT data identified that completion rates improved by 17% for the 1-walk protocol but that the ceiling-effect was 12.2% compared to 7.3% for the 2-walk protocol. LoA between protocols when measuring change over time (n = 31) was ±80% (95%CI 25.56); less than the difference described as "somewhat better" (113%) following pulmonary rehabilitation (PR) but greater than the m.c.i.d. of 68%. Conclusions: LoA for IC exceeded the clinically significant reported 0.3L; the protocol tested here was not sufficiently reliable for use as an outcome measure. Analysis of ESWT data showed the 1-walk protocol was adequate for identify change in clinical practice but, for research purposes the 2-walk protocol should be retained. From the RCT learning PLB resulted in reduced physiological stress with respect to oxygen desaturation when performing ESWT compared to the control group. Long-term follow-up showed that, in severe COPD perceived benefits persisted in 62% of patients.

The precise nature of the motion of the lips of the musician is critically important to the sound of the brass wind instrument. The player must match the oscillation of the lips to the acoustical properties of the instrument and it can take many years of practice to master the techniques involved. Visualisation techniques for capturing the motion of the lips during performance are described and the behaviour of the lips quantitatively analysed using digital image analysis. The concept of an artificial mouth for the sounding of brass wind instruments is discussed and the motion of the artificial lips is compared to that of human musicians. When a brass instrument is played loudly the energy of the higher harmonics increases, creating a distinctive ‘brassy’ timbre. It has been suggested that saturation or constraint of the lips of the musician during extremely loud playing is responsible for this change in sound. Measurements of the motion of the lips of a number of different musicians on different instruments suggest that the lips are not significantly constrained at any playing dynamic, and that it is the phenomena of nonlinear propagation and shockwave generation that is responsible for the increase in energy of the higher harmonics. It is widely accepted that the starting transient of a musical instrument is of great importance to both listener and musician. Previous studies of brass instruments have focused on the steady-state behaviour of the lip-instrument interaction. Measurements of the motion of the lips have been synchronised with the pressure in the mouthpiece of the instrument and the sound radiated from the bell in order to investigate the transient behaviour of the system during both the starting transient and slurs between notes. Thiswork has been extended to include measurements of the pressure in the mouth of the player during the starting transient, and this information used to recreate realistic transients using an artificial mouth. The transient behaviour of the system is clearly affected by the time delay between the start of the note and the acoustical feedback from the instrument beginning. The information obtained can be used to aid in the creation of accurate computational and physical models of brass wind instruments.

No description available.

Thesis (M.D.S.)--University of Adelaide, Dept. of Dentistry, 1985. / Some mounted ill. Includes bibliographical references (v. 1, leaves 206-227).

Thesis (M.S.)--University of Michigan, 1944.