Li-ion batteries are widely used in electronics and automotives. Despite their success, improvements in cost, safety, cycle life, and energy density are necessary. One way to enhance the energy density is to find advanced cathodes such as Li-rich layered oxides, which are similar to the commonly layered oxide cathodes (e.g., LiCoO2), except there are additional Li ions in the transition-metal layer, due to their higher charge-storage capacity. Another way of advancing is to design new battery chemistries, such as those involving multivalent-ion systems (e.g., Mg2+ and Zn2+) as they could offer higher charge-storage capacities and/or cost advantages. Li-rich layered oxides have a complex first charge-discharge cycle, which affects their other electrochemical properties. Ru doping was expected to improve the performance of Li-rich layered oxides due to its electroactivity and overlap of the Ru4+/5+:4d band with the O2-:2p band, but it unexpectedly decreased the capacity due to the reduction in oxygen loss behavior. Preliminary evidence points to the formation of Ru-Ru dimers, which raises the Ru4+/5+:4d band, as the cause of this behavior. Li-rich layered oxides suffer from declining operating voltage during cycling, and it is a huge challenge to employ them in practical cells. Raising the Ni oxidation state was found to reduce the voltage decay and improve the cyclability; however, it also decreased the discharge capacity. Increasing the Ni oxidation state minimized the formation of Mn3+ ions during discharge and Mn dissolution, which led to the improvements in voltage decay and cyclability. Extraction of lithium from spinel oxides such as LiMn2O4 with acid was found to follow a Mn3+ disproportionation mechanism and depend on the Mn3+ content. Other common dopants like Cr3+, Fe3+, Co3+, or Ni2+/3+ did not disproportionate, and no ion-exchange of Li+ with H+ occurred in the tetrahedral sites of the spinel oxides. Extraction with acid of Mg and Zn from spinel oxides, such as MgMn2O4 and ZnMn2O4, were also found to follow the same mechanism as Li-spinels. The Mg-spinels, however, do experience ion exchange when Mg ions are in the octahedral sites. Chemical extraction of Mg or Zn with an oxidizing agent NO2BF4 in acetonitrile medium, however, failed due to the electrostatic repulsion felt by the migrating divalent ions. In contrast, extraction with acid was successful as Mn dissolution from the lattice opened up favorable pathways for extraction. / text

Les mécanismes mis en jeu lors du cyclage de batteries au Lithium Li//Li1.20Mn0.54Co0.13Ni0.13O2 ont été étudiés avec l'objectif de déterminer l'origine des capacités très élevées délivrées par les oxydes lamellaires " (1-x)LiMO2.xLi2MnO3 ". La caractérisation par diffraction des RX et des neutrons montre que la structure est maintenue et l'existence de fluctuations de composition qui peuvent être assimilées à l'existence de deux phases de compositions voisines. Les résultats des tests électrochimiques et les analyses menées au cours du cyclage en spectroscopie d'absorption des rayons X ont suggéré la participation de l'oxygène aux processus redox. Celle-ci a été confirmée par la préparation et la caractérisation de matériaux désintercalés et réintercalés chimiquement en lithium. Les analyses en microscopie électronique à transmission (HAADF-STEM) et en nanodiffraction, montrent qu'une densification associée à un dégagement d'oxygène a lieu à la périphérie des particules

Les mécanismes mis en jeu lors du cyclage de batteries au Lithium Li//Li1.20Mn0.54Co0.13Ni0.13O2 ont été étudiés avec l’objectif de déterminer l’origine des capacités très élevées délivrées par les oxydes lamellaires « (1-x)LiMO2.xLi2MnO3 ». La caractérisation par diffraction des RX et des neutrons montre que la structure est maintenue et l’existence de fluctuations de composition qui peuvent être assimilées à l’existence de deux phases de compositions voisines. Les résultats des tests électrochimiques et les analyses menées au cours du cyclage en spectroscopie d’absorption des rayons X ont suggéré la participation de l’oxygène aux processus redox. Celle-ci a été confirmée par la préparation et la caractérisation de matériaux désintercalés et réintercalés chimiquement en lithium. Les analyses en microscopie électronique à transmission (HAADF-STEM) et en nanodiffraction, montrent qu’une densification associée à un dégagement d’oxygène a lieu à la périphérie des particules / The charge and discharge mechanism of Li1.20Mn0.54Co0.13Ni0.13O2 was studied using several characterization tools in order to determine the origin of the high capacity observed for the system (1-x)LiMO2.xLi2MnO3 used as positive electrode for Li-ion batteries. The electrochemical results and in operando XAS analyses performed during the 1st cycle of Li//Li1.20Mn0.54Co0.13Ni0.13O2 cells suggested the possible participation of oxygen anion to the redox processes. It was supported by the in-depth analysis of materials prepared by chemical Li deintercalation and reinsertion. The results of XRD, HAADF-STEM and nanodiffraction analyses, combined with electrochemical experiments performed in different conditions (rate, temperature …), revealed that different types of reactions occur in the particles during the 1st cycle. Within the bulk Ni, Co and O are involved in the redox processes, whereas Mn is not: oxygen ions are oxidized in charge and reduced during the next discharge reversibly. At the surface, the same oxidation processes occur during the first charge, but with the release of oxygen gaz and a densification of the lattice. During the next discharge and subsequent cycles, the redox reaction occurring near the surface after the 1st charge involves thus Co, Ni and Mn.