To reduce the emissions from energy use, high demands are set on new buildings. Studies have shown big differences between predicted and actual energy performance. This gap makes it more difficult to reduce the energy use in buildings. The aim of this study is to discover if deviations occur before the building is put into use, and if it does, discuss the reasons for that.  In this study, energy performance for 20 multi-family houses have been compared between the early design stage and the production stage. The result of this study is that there are no major differences in energy use between the different documents. On the other hand, there are big differences in some of the parameters that the energy use is dependent on. The reasons of this are discussed later in this thesis. None of the investigated buildings had the same value of energy performance in the production stage as in the early stage. The parameter that has shown the greatest difference is space heating and hot water recirculation. The biggest correlation was found between the energy required by the fans and the buildings total energy use.

Turbulent and cavitation induced pipe vibration is a large problem in industry often resulting in pipe failures. This thesis provides an experimental investigation on turbulent flow and cavitation induced pipe vibration caused by sharp edged baffle plates. Due to large pressure losses across a baffle plate, cavitation can result. Cavitation can be destructive to pipe flow in the form of induced pipe wall vibration and cavitation inception. Incipient and critical cavitation numbers are design points that are often used in designing baffle plate type geometries. This investigation presents how these design limits vary with the influencing parameters by exploring a range of different baffle plate geometries. The baffle plates explored contained varying hole sizes that ranged from 0.159 cm to 2.54 cm, with the total through area, or openness, of each baffle plate ranging between 11% and 60%. Plate thickness varied from 0.32–0.635 cm. Reynolds numbers ranged from 5 x 10^4 -85 x 104. The results show that the cavitation design limits are function of size scale effects and the loss coefficient only. The results also show that the loss coefficient for a baffle plate varies not only with total through area ratio, but also due with the plate thickness to baffle hole diameter ratio. Pipe wall vibrations were shown to decrease with increased through area ratio and increased thickness to diameter ratios. An investigation was also performed to characterize the attenuation of vibration in the streamwise direction of a baffle plate. It was show that the attenuation was largely effected by the presence of cavitation. Attenuation was shown to be a function of the geometry of the baffle plate. This work resulted in empirical models that can be used for predicting pipe vibration levels, the point of cavitation inception, and the streamwise distance where the attenuation of vibration levels caused by a baffle plate occurs.

The goal of the thesis is firstly to get all the information about the initial state of solved block of flats, which is located on the street Merhautova 76/954 in Brno – Černá pole, in terms of constructions, energy consumption and initial state of heating system. In the second part of the thesis, where are discussed the possibilities of reduction of energy consumption, variant drafts of reduction of energy consumption and their financial costs and the choice of optimal variant. Third part deals with assement of solved block of flats in terms of sustainable built environment by using tool to rate buildings in terms of sustainable built environment - SBToolCZ, evaluation of possibility to use renewables. In the end are written summaries and recommendations.