This thesis presents a novel modulation scheme, called feedback dithering modulation, for DC to AC power converters. The feedback dithering modulator consists of a quantizer and a recently reported feedback dithering circuit, performing multilevel modulation with improved linearity and signal quality as opposed to the conventional modulation schemes. By combining the feedback dithering modulation and optimal control, a single-phase DC to AC power converter is built and tested. The resulting total harmonic distortion can be as low as 0.38% for a 25£[ load, or 0.47% when the output is open. Under the various operating conditions with DC voltages source varying from 190 V to 300 V and output powers from 0 to 600 W, the power converter always maintains a total harmonic distortion less than 1%, exhibiting high performance and excellent robustness.

Abstract¡G This thesis mainly implemented an RF transmitter with high efficiency and high linearity. A Cartesian to Polar transformation was implemented by CORDIC algorithm using FPGA. By replacing the envelope detector and limiter in traditional envelope elimination and restoration transmitter, this technique not only achieves more accurate modulation quality, but also becomes more suitable for single chip system. Applying the first order delta-sigma modulation and highly efficient switching-mode DC converter, the envelope signal was amplified highly efficiently. Due to the class-E power amplifier having good linear relation between output voltage and supply voltage, the polar modulation transmitter can achieve high efficiency and high linearity simultaneously. Furthermore, this thesis purposed a new transmitter with two-terminal time-varying modulation. The IQ modulated signal was fed to the input terminal of class-E amplifier, while the envelope signal was used to amplitude modulate the voltage supply terminal. With dynamic input power control, the conversion efficiency and linearity are independent of output power in the purposed architecture. From the experimental results, while transmitting a QPSK-modulated CDMA2000 1x signal with 1.2288 Msps data rate, the transmitter achieve 48 % in drain efficiency, 47 dB in ACPR, and 6 % in EVM at the output power ranging from 10 to 22 dBm.

The continuous phase frequency shift keying (CPFSK) is a modulation method with memory. The memory results from the phase continuity of the transmitted carrier phase from one signal interval to the next. For a specific form of phase, CPFSK becomes a special case of a general class of continuous phase modulation (CPM) signals. In this thesis, we extend the decomposition model of single-h CPM to the multi-h CPM decomposition model. Based on this decomposition model approach the multi-h CPFSK schemes are evaluated by searching the desired multi-h phase codes at a given number of states. Moreover, the trellis coded multi-h CPFSK schemes, which are the combination of the (binary) convolutional codes with the multi-h CPFSK schemes, are searching by optimization procedure via the matched encoding method. To further improve the performance, in terms of the coding gain, the ring convolutional codes are applied to the continuous phase encoder (CPE) of the proposed multi-h CPFSK schemes. Due to the fact that the code structure of the ring convolutional codes is similar to the CPE, this will result in having simple and efficient combination of the convolutional codes with the multi-h CPFSK signaling schemes.

The development of a simple efficient Pulse Width Modulation (PWM) modulator has been a goal for many research workers. In general three techniques have been used, namely; the analogue triangular wave technique; the use of look-up tables, and the use of Analogue to Digital converters together with analogue circuitry. The modulator described in this thesis is based on an iterative numerical algorithm, and is thus fundamentally different from all previous techniques. The algorithm is limited only by the speed and precision of the associated digital circuitry and can achieve higher modulating frequencies with greater accuracy than can be realised using any of the methods that have previously been investigated. The use of high switching frequencies simplifies the design of filters to reduce both unwanted harmonics and acoustic noise. In this thesis, an equation of a multiphase digital oscillator is derived which is simple to implement and will operate over a wide range of frequencies. The conditions for stable oscillation are derived, and two classes of oscillator are developed. It is shown how the frequency and amplitude of oscillations can be independently and continuously varied. The errors in computing the amplitude and frequency are analysed, and are shown to be cyclic. Upper bounds for the amplitude errors are derived. Single and three phase PWM modulators are described and the implementation procedures for their practical realisation are developed. Two specific implementations of the algorithm are investigated and experimental results confirm theoretical analyses. The algorithm can be incorporated in the Space Vector Modulation (SVM) method of PWM, to improve the resolution at low speeds and to enable the SVM technique to be applied at high gear ratios. A 3-phase 16-bit PWM modulator was built and operated satisfactorily with a pulse switching frequency of 20 kHz and an output frequency range of 1000:1. / Thesis (Ph.D.)-University of Natal, Durban, 1989.

Continuous phase modulation~(CPM) is a non-linear, constant-envelope modulation scheme with memory, known for its bandwidth and power efficiency. Multi-h CPM uses multiple modulation indices in successive symbol intervals to improve the error performance as compared to single-h CPM~(basic CPM that utilizes only a single modulation index). One of the major applications of multi-h CPM is in aeronautical telemetry systems. Modern aeronautical devices host an increasing number of sensors, which can transmit flight testing data to the ground station. However, this excess data transfer increases the intersymbol interference, and thus channel equalization is required at the receiver. The objective of our research is to propose low-complexity frqeuency-domain equalization~(FDE) techniques for multi-h CPM waveforms. For a modulation scheme with memory, such as CPM, the cyclic constraint on the FDE block necessitates the use of an extra segment of symbols, called intrafix or tail segment. We have used very simple geometric arguments to derive upper and lower bounds on the length of the intrafix in terms of the parameters of the modulation scheme and the Frobenius number. It is concluded that the length of the intrafix for multi-h CPM schemes is typically shorter than those required for single-h modulation schemes. We propose two receiver architectures; one uses a matched filter front end, while the other utilizes a fractional sampling front end. Various simplifications are proposed for each architecture, and the trade-off between receiver complexity and performance is analyzed and verified through detailed simulation studies.

This thesis studies and mathematically models nonlinear interactions among channels of modern high bit rate (amplitude/) phase modulated optical systems. First, phase modulated analogue systems are studied and a differential receiving method is suggested with experimental validation. The main focus of the rest of the thesis is on digital advanced modulation format systems. Cross-talk due to fiber Kerr nonlinearity in two-format hybrid systems as well as 16-QAM systems is mathematically modelled and verified by simulation for different system parameters. A comparative study of differential receivers and coherent receivers is also given for hybrid systems. The model is based on mathematically proven assumptions and provides an intuitive analytical understanding of nonlinear cross-talk in such systems. / Graduate

Wireless networks become more and more important in modern information systems as the last mile/meter solutions, thanks to the flexibility of mobile access to facilitate Internet access anytime, anywhere. Given the limited resources, e.g., spectrum and energy supplies, to meet the ever increasing demand for wireless data services, new approaches are beckoned to enhance the spectrum and energy efficiency. We investigate this problem from three important aspects, digital modulation, clock synchronization and concurrent transmission scheduling. The contributions of this dissertation are four-fold. First, we employ the cross-layer design to explore the spatial diversity and broadcast nature of wireless links and propose a novel network modulation scheme that can superpose the information bits of different priorities into one symbol. It offers a new dimension to improve the network throughput since we can flexibly configure the transmission according to the channels among transceivers. Moreover, it is compatible with the main-stream hardware and we just need a software upgrade to implement the idea. Second, we propose modulation schemes based on hexagonal tiling, which is known to be the most compact way of two-dimensional regular tiling. In order to fully utilize the advantage of hexagonal constellation, we employ the non-binary error controlcoding since the number of constellation points of hexagonal constellation is not necessarily to be an integer power-of-two. The feasibility of these new modulation schemes is verified by the prototype system based on the software defined radio platform USRP2 and GNU Radio. Third, to facilitate a wide range of wireless communications technologies and protocols, clock synchronization among several wireless devices is a fundamental requirement. We investigated this problem by tracing to the source of clock desynchronization, which is the clock skew. However, as shown by measurement results, the clock skew is not constant and related to the working temperature. We propose a novel clock skew estimation algorithm that can leverage the temperature information to accurately estimate the clock skew. Based on the estimation results, we propose a clock synchronization scheme that can directly remove the clock skew according to the working temperature. Fourth, the traditional time-sharing based scheduling schemes usually schedule one transmission within certain area. The emerging broadband wireless devices can dynamically adjust the transmitted data rate according to the received signal to interference and noise ratio (SINR). Allowing concurrent transmissions may be more efficient, while optimal scheduling problem for concurrent transmissions is an NP-hard problem. We propose simple yet effective heuristic algorithms that can significantly improve the system throughput with moderate computational complexity. / Graduate / 0544 / yangzhe2007@gmail.com

Quadrature amplitude modulation (QAM) is a highly bandwidth efficient transmission technique for digital communications. It makes use of multiple signal phase and amplitude levels to carry multiple bits per symbol. This requires accurate and robust carrier phase and frequency estimation in the receiver. / Thesis (PhDElectronicEngineering)--University of South Australia, 2002.

Quadrature amplitude modulation (QAM) is a highly bandwidth efficient transmission technique for digital communications. It makes use of multiple signal phase and amplitude levels to carry multiple bits per symbol. This requires accurate and robust carrier phase and frequency estimation in the receiver. / Thesis (PhDElectronicEngineering)--University of South Australia, 2002

Thesis (Ph. D.)--University of Canterbury, 2007. / Typescript (photocopy). "March 2007." Includes bibliographical references (p. 161-167). Also available via the World Wide Web.