This thesis studies wave energy converters developed at Uppsala University. The wave energy converters are of point absorbing type with direct driven linear generators. The aim has been to study generator design with closed stator slots as well as offshore experimental studies. By closing the stator slots, the harmonic content in the magnetic flux density is reduced and as a result the cogging forces in the generator are reduced as well. By reducing these forces, the noise and vibrations from the generator can be lowered. The studies have shown a significant reduction in the cogging forces in the generator. Moreover, by closing the slots, the magnetic flux finds a short-cut through the closed slots and will lower the magnetic flux linking the windings. The experimental studies have focused on the motion of the translator. The weight of the translator has a significant impact on the power absorption, especially in the downward motion. Two different experiments have been studied with two different translator weights. The results show that with a higher translator weight the power absorption is more evenly produced between the upward and downward motion as was expected from the simulation models. Furthermore, studies on the influence of the changing active area have been conducted which show some benefits with a changing active area during the downward motion. The experimental results also indicate snatch-loads for the wave energy converter with a lower translator weight. Within this thesis results from a comparative study between two WECs with almost identical properties have been presented. The generators electrical properties and the buoy volumes are the same, but with different buoy heights and diameters. Moreover, experimental studies including the conversion from AC to DC have been achieved. The work in this thesis is part of a larger wave power project at Uppsala University. The project studies the whole process from the energy absorption from the waves to the connection to the electrical grid. The project has a test-site at the west coast of Sweden near the town of Lysekil, where wave energy systems have been studied since 2004.

On March 13th, 2006, the Division of Electricity at Uppsala University deployed its first wave energy converter, L1, in the ocean southwest of Lysekil. L1 consisted of a buoy at the surface, connected through a line to a linear generator on the seabed. Since the deployment, continuous investigations of how L1 works in the waves have been conducted, and several additional wave energy converters have been deployed. This thesis is based on ten publications, which focus on different aspects of the interaction between wave, buoy, and generator. In order to evaluate different measurement systems, the motion of the buoy was measured optically and using accelerometers, and compared to measurements of the motion of the movable part of the generator - the translator. These measurements were found to correlate well. Simulations of buoy and translator motion were found to match the measured values. The variation of performance of L1 with changing water levels, wave heights, and spectral shapes was also investigated. Performance is here defined as the ratio of absorbed power to incoming power. It was found that the performance decreases for large wave heights. This is in accordance with the theoretical predictions, since the area for which the stator and the translator overlap decreases for large translator motions. Shifting water levels were predicted to have the same effect, but this could not be seen as clearly. The width of the wave energy spectrum has been proposed by some as a factor that also affects the performance of a wave energy converter, for a set wave height and period. Therefore the relation between performance and several different parameters for spectral width was investigated. It was found that some of the parameters were in fact correlated to performance, but that the correlation was not very strong. As a background on ocean measurements in wave energy, a thorough literature review was conducted. It turns out that the Lysekil project is one of quite few projects that have published descriptions of on-site wave energy measurements.