Yes / Highly-branched poly(N-isopropyl acrylamide)s in water pass through coil-to-globule transitions. Using calorimetry and the colour change of a solvatochromic dye within the polymer, we show that some compositions have biphasic core–shell morphologies, with globular cores and open coil shells. The two-phase structure is favoured by increased branching and arises because the chain ends penetrate only to a limited degree into the polymer coil.

Doctor of Philosophy / Department of Chemistry / Stefan Bossmann / Tris-homoleptic ruthenium(II)-quaterpyridyl and quaterpyridinium complexes, with +8 and +14 charge were synthesized by utilizing high pressure reaction pathway. These complexes have diameters ranging from 1.82 to 4.55 nm according to the molecular modeling calculations. These ruthenium complexes are highly luminescent and contain long excited state life times. The novel ruthenium(II)-quaterpyridinium complexes exhibit superior reactivity as sensitizer-relay-assemblies (SRA‟s) in sacrificial systems for water and carbon dioxide reductions, while harvesting the ultraviolet- and most of the visible fraction of the incident solar spectrum. Ru(II)-quaterpyridinium complexes and Pd/TiO2 catalysts were successfully used as the catalytic system for the photo catalytic reduction of water and carbon dioxide to hydrogen and methane respectively. Phosphonate-tethered Ru(II)-quaterpyridinium complexes were synthesized from Ru(II)-tris-quaterpyridyl complexes. These complexes form stable adhesive layers on indium tin oxide (ITO) electrodes. A series of differential pulse voltammetry experiments were carried out to measure the ground state and excited state redox potentials of all the Ru(II)quaterpyridinium complexes. The reductive potentials obtained were compared with the reductive potentials of CO2 to CH4 and H2O to H2 reductions. The measurements obtained from the experiments confirmed that it is possible to thermodynamically oxidize water and reduce CO2 by using phosphonate-tethered Ru(II)-quaterpyridinium complexes. These complexes are successfully utilized as prototypes for mycobacterial channel blockers. The Ru(II) complexes show distinct changes in their luminescence spectra when bound to the porin MspA from M. smegmatis, which is a non-pathogenic relative of M. tuberculosis. By using HPLC, we have determined binding constants of the Ru(II)-complexes to MspA in phosphate buffer (0.05 M, pH = 6.8) ranging from 5.2 x 109 M-1 (Ru-C2) to 1.8 x 109 M-1 (Ru-C4). Our findings indicate that channel blocking is a promising treatment strategy for mycobacterial infections. Poly-N-isopropyl-acrylamide/acetic acid copolymers were synthesized and characterized by elemental analysis and gel permeation chromatography. The average composition of the copolymers determined from CHN analysis is in excellent correlation with the feed composition indicating that the radical polymerization process is indeed statistical. Crosslinking of individual polymer chains permitted the generation of ultraflat layers on Mica surfaces by a simple spin-casting procedure, which are able to host the mycobacterial channel protein MspA, while retaining its channel function.

Yes / Corneal ulcers, a leading cause of blindness in the developing world are treated inappropriately without prior microbiology assessment because of issues related to availability or cost of accessing these services. In this work we aimed to develop a device for identifying the presence of Gram-positive or Gram-negative bacteria or fungi that can be used by someone without the need for a microbiology laboratory. Working with branched poly (N-isopropyl acrylamide) (PNIPAM) tagged with Vancomycin, Polymyxin B, or Amphotericin B to bind Gram-positive bacteria, Gram-negative bacteria and fungi respectively, grafted onto a single hydrogel we demonstrated specific binding of the organisms. The limit of detection of the microbes by these polymers was between 10 and 4 organisms per high power field (100X) for bacteria and fungi binding polymers respectively. Using ex vivo and animal cornea infection models infected with bacteria, fungi or both we than demonstrated that the triple functionalised hydrogel could pick up all 3 organisms after being in place for 30 min. To confirm the presence of bacteria and fungi we used conventional microbiology techniques and fluorescently labelled ligands or dyes. While we need to develop an easy-to-use either a colorimetric or an imaging system to detect the fluorescent signals, this study presents for the first time a simple to use hydrogel system, which can be applied to infected eyes and specifically binds different classes of infecting agents within a short space of time. Ultimately this diagnostic system will not require trained microbiologists for its use and will be used at the point-of-care. / We gratefully acknowledge support for this research by the Well- come Trust which provided funding for Shivshetty, Swift and Pinnock (Grant 0998800/B/12/Z).

No description available.

Polymers which are sensitive towards external physical, chemical and electrical stimuli are termed as ‘intelligent materials’ and are widely used in medical and engineering applications. Presently, polymers which can undergo a physical change when heat is applied at a certain temperature (cloud point) in water are well-studied for this property in areas of separation chemistry, gene and drug delivery and as surface modifiers. One example of such a polymer is the poly (N-isopropylacrylamide) PNIPAAM, where it is dissolved well in water below 32 oC, while by increasing the temperature further leads to its precipitation. In this work, an alternative polymer poly (2-(2-methoxy ethoxy)ethyl methacrylate-co- oligo(ethylene glycol) methacrylate) (P(MEO2MA-co-OEGMA)) is studied due to its biocompatibility and the ability to vary its cloud points in water. When a layer of temperature responsive polymer was attached to a single continuous porous piece of silica-based material known as a monolith, the thermoresponsive characteristic was transferred to the column surfaces. The hybrid material was demonstrated to act as a simple temperature ‘switch’ in the separation of a mixture of five steroids under water. Different analytes were observed to be separated under varying column temperatures. Furthermore, more complex biochemical compounds such as proteins were also tested for separation. The importance of this work is attributed to separation processes utilizing environmentally friendly conditions, since harsh chemical environments conventionally used to resolve biocompounds could cause their biological activities to be rendered inactive. / Polymere, welche empfindlich gegenüber externen physikalischen, chemischen und elektrischen Einflüssen sind, werden „intelligente Materialien“ genannt. Diese werden weitverbreitet in medizinischen und technischen Anwendungen eingesetzt. Auf diesem Gebiet ausführlich erforschte Materialien sind Polymere, welche durch Hitze bei einer bestimmten Temperatur (Trübungspunkt) eine physikalische Veränderung eingehen können, genannt thermoresponsive Polymere. Eingesetzt werden diese z.B. in chromatographischen Trennverfahren, in Gen- und Wirkstofftransport Vorgängen und zur Oberflächenmodifikation. Ein Beispiel für so ein Polymer ist das poly(N-isopropylacrylamide) PNIPAAM, welches unter 32 °C in Wasser gelöst vorliegt und mit Erhöhung der Temperatur als Niederschlag ausfällt. In dieser Arbeit wurde ein alternatives Polymer, das poly(2-(2-methoxyethoxy)ethylmethacrylate-co-oligo(ethyleneglycol) methacrylate) (P(MEO2MA-co-OEGMA)), untersucht, in Bezug auf Biokompatibilität und der Änderung des Trübungspunktes in Wasser. Wenn eine Schicht eines temperaturempfindlichen Polymers auf einen Monolithen (einteiliger, poröser und auf Silika-basierendes Material) aufgebracht wird, werden die thermoresponsiven Eigenschaften auf die Oberfläche dieses Monolithen übertragen. Der Monolith dient hier als Säule in einer HPLC-Anlage. Es wurde gezeigt, dass das Hybrid-Material als einfacher „Temperaturschalter“ in der Trennung von fünf verschiedenen Steroiden in Wasser agieren kann. Untersucht wurde die Separation verschiedener Analyten mit dem Variieren der Säulentemperatur. Zusätzlich wurden mehr komplexe biochemische Stoffe, wie Proteine, getestet. Die Bedeutung dieser Arbeit ist zurückzuführen auf Separationsprozesse, welche umweltfreundlichen Bedingungen nutzen, da die rauen chemischen Bedingungen in konventionellen Separationsprozessen die biologische Inaktivität der Verbindungen zur Folge haben können. Der zweite Teil der Arbeit beschäftigte sich mit der Entwicklung eines alternativen Trägermaterials als Ersatz zu den Silika-basierende Trennungssäulen. Kohlenstoffmaterialien sind aufgrund ihrer ausgezeichneten mechanischen Härte und chemischen Stabilität eine vielversprechend Alternative. Die Synthese von Kohlenstoffkugeln als Trägermaterial kann als „grüner“ Prozess in meiner Arbeit angesehen werden, da milde Synthesebedingungen in purem Wasser verwendet wurden. Die Leistungsfähigkeit des Materials wurde mit einer Serie von Separationsreaktionen gezeigt.