This work outlines a series of developments and discoveries related to surface chemistry of controlled near-surface architectures. Through a combination of various X-ray spectroscopy techniques and innovative electrochemical fabrication techniques, valuable knowledge has been added to the fields of electrochemical fabrication, electrocatalysis, and fundamental surface chemistry. Described here is a specific new development in the technique of surface limited redox replacement (SLRR). This work, along with an accompanying journal publication1, reports the first-ever use of nickel as an intermediary for SLRR. In addition, this work identifies specific deviations from the nominal reaction stoichiometry for SLRR-grown films. This led to the proposal of a new reaction mechanism for the initial stages of the SLRR process, which will assist future fabrication attempts in this field. This work also discovered fundamental changes in Pt overlayer systems as the thickness of the overlayer on a gold support is increased from less than a single atomic monolayer to multilayer thicknesses. It was found that Pt overlayers below a certain threshold thickness exhibited increased affinity for hydroxyl groups, along with an increased propensity for formation of oxide and chloride species. These films were also studied for methanol, carbon monoxide, and ethylene glycol electro-oxidation. Finally, this work reports controlled surface architectures of Pt and Cu deposits on application-oriented TiO₂ nanotube arrays and Au-carbon supports.

Philosophiae Doctor - PhD / The depletion of fossil fuel resources such as coal and the concern of climatic change arising from the emission of greenhouse gases (GHG) and global warming [1] lead to the identification of the 'hydrogen economy' as one of the renewable energy sources and possible futuristic energy conversion solution. Sources of hydrogen as fuel such as water through electrolysis and liquid organic fuel (Hydrogen carriers) have been found as potential game-changers and received increased attention, due to its low-carbon emission.

A pair of studies investigating the deposition and surface chemical properties of ultrathin metal films were pursued: (i) Pt-Co alloys on Mo(110); and (ii) Pd on Pt(111). Experimental measurement was based on a combination of electron spectroscopy (low energy ion scattering spectroscopy, X-ray photoelectron spectroscopy, Auger electron spectroscopy, and low energy electron diffraction) and electrochemistry (voltage efficiency, voltammetry, and coulometry). Mixed-metal preparation of Pt-Co films by thermal vapor deposition (TVD) resulted in a thin-film binary alloy. Careful analysis revealed a substantial divergence between the composition at the interface and that in the interior. This outcome was observed for all compositions and allowed for the construction of a ?surface phase diagram?. The proclivities of the alloys of pre-selected compositions towards enhanced catalysis of the oxygen-reduction reaction were assessed in terms of their voltage efficiencies, as manifested by the open-circuit potential (OCP) in O2-saturated dilute sulfuric acid electrolyte. The particular alloy surface, Pt3Co (XPt=3,XCo=1), whether from the thin film or a bulk single crystal, exhibited the highest OCP, a significant improvement over pure Pt but still appreciably lower than the thermodynamic limit. Under test conditions, the degradation of thusly-prepared films was primarily due to Co corrosion. Ultrathin Pd films on well-defined Pt(111) surfaces, with coverages from 0.5 to 8 monolayers (ML), were prepared by surface-limited redox replacement reaction (galvanic exchange) of underpotentially deposited Cu. Spectroscopic data revealed that films prepared in this manner are elementally pure, pseudomorphic to the substrate, and stable, independent of the surface coverage (?) of palladium. Analysis of the voltammetric profiles in the hydrogen evolution region revealed unique properties of hydrogen adsorption unseen in bulk electrodes. Notably, at 1 ML coverage, a step-free film was produced that did not exhibit hydrogen absorption. At higher coverages, digital (layer-by-layer) deposition gave way to 3D islands in a Stranski- Krastanov growth mode; under these conditions, onset of bulk-like behavior was observed. This method makes possible the synthesis of well-ordered noble-metal films in the absence of high-temperature treatment

No description available.