<p>This project deals with the potential of membrane stratified solar ponds which consist of two water layers, where one is a salt solution here, and a separating translucent membrane. An experimental pond was set up to study the thermal behaviour of such collector systems. The input is mainly solar radiation, sometimes when the ambient temperatures are higher than the pond temperatures also heat from the environment is transferred into the pond.</p><p>The measured temperatures of the pond, the ambient temperature, the global radiation and wind speed were the basis data for thermal calculations which showed that the pond was working well as a solar collector and thermal storage system all in one. Heat was not extracted from the pond however, only the losses to the environment were studied.</p><p>It was found out that the pond temperatures were higher than the ambient temperature over the whole measurement period of 12 days, and insulation and pollution problems as well as future prospects and suggestions for further studies are discussed at the end of this paper.</p>

This project deals with the potential of membrane stratified solar ponds which consist of two water layers, where one is a salt solution here, and a separating translucent membrane. An experimental pond was set up to study the thermal behaviour of such collector systems. The input is mainly solar radiation, sometimes when the ambient temperatures are higher than the pond temperatures also heat from the environment is transferred into the pond. The measured temperatures of the pond, the ambient temperature, the global radiation and wind speed were the basis data for thermal calculations which showed that the pond was working well as a solar collector and thermal storage system all in one. Heat was not extracted from the pond however, only the losses to the environment were studied. It was found out that the pond temperatures were higher than the ambient temperature over the whole measurement period of 12 days, and insulation and pollution problems as well as future prospects and suggestions for further studies are discussed at the end of this paper.

This research studies the performance of a salinity gradient solar pond driving an absorption cooling system, as an alternative to a conventional electrically powered cooling system, to provide cool air for a modern single family house in the hot dry climate of Baghdad, Iraq. The system comprises a salinity gradient solar pond, a hot-water-fired absorption water chiller, a chilled-water cooling coil which cools the air in the house, and a cooling tower which rejects heat to the ambient air. Hot brine from the pond circulates through a heat exchanger, where it heats water that is then pumped to the chiller. This arrangement protects the chiller from the corrosive brine. The system is controlled on-off by a room thermostat in the house. The system performance is modelled by dynamic thermal simulation using TMY2 hourly typical weather data. TRNSYS software is used for the main simulation, coupled to a MATLAB model of heat and mass transfer in the pond and the ground beneath it. The model of the pond and the ground is one-dimensional (only vertical transfers are considered). Radiation, convection, conduction, evaporation and diffusion are considered; the ground water at some depth below the pond is treated as being at a fixed temperature. All input data and parameter values in the simulation are based on published, standard or manufacturer's data. Temperature profiles in the pond were calculated and found to be in good agreement with published experimental results. It was found that a pond area of approximately 400 m2 was required to provide satisfactory cooling for a non-insulated house of approximately 125 m2 floor area. It was found that varying the pond area, ground conditions and pond layer thicknesses affected the system performance. The optimum site is one that has soil with low thermal conductivity, low moisture content and a deep water table. It is concluded that Iraq's climate has a potential for solar-pond-powered thermal cooling systems. It is feasible to use a solar-pond-powered cooling system to meet the space cooling load for a single family house in the summer season. Improving the thermal performance of the house by insulation could reduce the required solar pond area.