Master´s thesis deals with the processing of building part of the project documentation for building construction. The aim of the Master´s thesis is a new building of kindergarten in the village Dolany near Olomouc. The building is designed for 40 preschool children. The building is situated near the centre of the village and is easily accessible from surrounding living areas. The building is partly basement and has two floors. In the basement there are technical equipments and storages. In the floors there are classes for children and areas ensuring the service of kindergarten. This masonry building is insulated with contact thermal insulation system and roofed with a warm flat roof.

[ES] El control de ruido ambiental es una preocupación de primera magnitud para las sociedades avanzadas, debido a los problemas derivados que ocasionan en la salud de los ciudadanos. Una de las soluciones más extendidas para el control del ruido en su fase de transmisión en la utilización de pantallas acústicas. La aparición de nuevos materiales formados por redes de dispersores acústicos aislados, denominados cristales de sonido, está revolucionando el campo del apantallamiento acústico, posibilitando el avance tecnológico de esta área. Así, en los últimos años, las pantallas acústicas basadas en cristales de sonido se han posicionado como una alternativa viable a las pantallas acústicas tradicionales, puesto que ofrecen múltiples ventajas frente a las soluciones actuales. En el presente trabajo se muestra primeramente una recopilación de los avances realizados en el campo del apantallamiento acústico mediante esta tipología de pantallas. No obstante, aún existen líneas de investigación abiertas en esta área, que es necesario abordar para conseguir el objetivo de aplicar esta tecnología como atenuadores de sonido en las infraestructuras de transporte. Durante el periodo de formación de la doctoranda, se ha trabajado en algunas de las líneas de investigación activas en este campo del apantallamiento acústico. Una de estas investigaciones condujo al descubrimiento de interferencias entre los efectos de la resonancia y la dispersión múltiple de los cristales de sonido cuando estos efectos se producen en rangos de frecuencia cercanos. También hemos diseñado un nuevo dispositivo de reducción de ruido basado en cristales de sonido, utilizando herramientas de optimización multiobjetivo, que permitan apantallar y reflejar de forma difusa el ruido. El empleo de esta nueva herramienta de diseño identificó la necesidad de realizar un estudio comparativo de los métodos de simulación más utilizados para estimar el rendimiento de los dispositivos basados en cristales de sonido. Por último, hemos realizado un estudio psicoacústico para determinar la percepción de la reducción de molestia que proporcionan las pantallas acústicas basadas en cristales sonido y las barreras tradicionales, determinando si los parámetros objetivos que evalúan su rendimiento coinciden con la respuesta subjetiva de los usuarios. / [CA] El control de soroll ambiental és una preocupació de primera magnitud per a les societats avançades, a causa dels problemes derivats que ocasionen en la salut dels ciutadans. Una de les solucions més esteses per al control del soroll en la seua fase de transmissió en la utilització de pantalles acústiques. L'aparició de nous materials formats per xarxes de dispersors acústics aïllats, denominats cristals de so, està revolucionant el camp de l'apantallament acústic, possibilitant l'avanç tecnològic d'esta àrea. Així, en els últims anys, les pantalles acústiques basades en cristals de so s'han posicionat com una alternativa viable a les pantalles acústiques tradicionals, ja que oferixen múltiples avantatges enfront de les solucions actuals. En el present treball es mostra primerament una recopilació dels avanços realitzats en el camp de l'apantallament acústic per mitjà d'esta tipologia de pantalles. No obstant això, encara hi ha línies d'investigació obertes en esta àrea, que és necessari abordar per a aconseguir l'objectiu d'aplicar esta tecnologia com a atenuadors de so en les infraestructures de transport. Durant el període de formació de la doctoranda, s'ha treballat en algunes de les línies d'investigació actives en este camp de l'apantallament acústic. Una d'estes investigacions va conduir al descobriment d'interferències entre els efectes de la ressonància i la dispersió múltiple dels cristals de so quan estos efectes es produïxen en rangs de freqüència pròxims. També hem dissenyat un nou dispositiu de reducció de soroll basat en cristals de so, utilitzant ferramentes d'optimització multiobjectiu, que permeten apantallar i reflectir de forma difusa el soroll. L'ús d'esta nova ferramenta de disseny va identificar la necessitat de realitzar un estudi comparatiu dels mètodes de simulació més utilitzats per a estimar el rendiment dels dispositius basats en cristals de so. Finalment, hem realitzat un estudi psicoacústic per a determinar la percepció de la reducció de molèstia que proporcionen les pantalles acústiques basades en cristals so i les barreres tradicionals, determinant si els paràmetres objectius que avaluen el seu rendiment coincidixen amb la resposta subjectiva dels usuaris. / [EN] Control of environmental noise is a major concern for advanced societies because of the resulting problems for citizens' health. One of the most widespread solutions for controlling noise in its transmission phase is the use of acoustic screens. The emergence of new materials made up of arrays of isolated acoustic scatterers, called sonic crystals, is revolutionizing the field of acoustic screening. In recent years, acoustic screens based on sonic crystals have positioned themselves as a viable alternative to traditional acoustic screens, as they offer multiple advantages over current traditional solutions. This Doctoral dissertation compiles the advances in the field of acoustic screening using this type of sonic crystals. However, there is still active research in this area which needs to be addressed and studied in order to apply this technology as noise reduction devices in transport infrastructures. Therefore, during the PhD student's training period, we have researched the acoustic phenomena produced by isolated scatterers in order to better understand the physical phenomena behind the lasts designs of this type of screen. One of these researches led to the discovery of interferences between the effects of resonance and multiple scattering of sonic crystals when occurring in nearby frequency ranges. Also we have designed a new noise reduction device based on sonic crystals, using multi-objective optimization tools, which would block and diffuse the noise. This new designing tool identified the need for a comparative study of the most commonly used simulation methods to estimate the performance of devices based on sonic crystals. Finally, we have carried out a psychoacoustic study that determined the perception of the annoyance reduction provided by acoustic screens based on sonic crystals and traditional barriers, determining whether the objective parameters that evaluate their performance match to the subjective response of the users. / Agradezco al Ministerio de Ciencia e Innovación por la ayuda concedida dentro del programa Doctores Industriales. Asimismo, a mi tutor en empresa Dr. Juan José Martín Pino, por posibilitar la realización de esta investigación dentro de la empresa BECSA. Al Departamento de Física Aplicada de la Universitat Politècnica de València, a la Comisión Académica del Programa de Doctorado de Matemáticas y al Centro de Tecnologías Físicas: Acústica, Materiales y Astrofísica. / Peiró Torres, MDP. (2021). Research of the acoustic phenomenon produced by isolated scatterers and its applicability as a noise reducing device in transport infrastructures. Search for an optimised and sustainable design [Tesis doctoral]. Universitat Politècnica de València. https://doi.org/10.4995/Thesis/10251/164903 / TESIS

This thesis deals with the properties of soundproof partition structures in the low-frequency sound at impact sound insulation and security of acoustic comfort inside buildings. The prediction of impact sound is a simulation laboratory measurements of impact sound. The work is based on the occurrence of frequent complaints of inhabitants of residential homes for subjectively poor impact sound insulation of horizontal dividing structures, whose top layer is formed laminate. Although these structures conform in terms of impact sound insulation in accordance with the requirements of CSN 73 0532: 2010, residents complain about the subjective perception of the sounds of lower frequencies. A noise with a distinctive character of sound at low frequencies has been proved by measuring the spectral analysis and evaluation of sound pressure levels caused by the movement of persons roof construction to the floor. On the measurement and evaluation carried out in accordance with the measurement and evaluation of noise in non-working environment can be related requirement under the Regulation No. 272/2011 Coll. "On the protection of health from the adverse effects of noise and vibration." Occupational noise limits for protected buildings interior space do not apply to noise from ordinary use of the apartment. Under current legislation, the problem is in the Czech Republic at present insoluble. Therefore, this work explores ways evaluation of impact sound and delivery is determined conclusions. With the low-frequency impact sound insulation is also related to the latter part of this dissertation, where the computing program ANSYS (version 14.0) is simulated laboratory measurements of impact sound insulation of the real structure. The paper presents the results of simulation, and the sound pressure level in the receiving room to třetinooktávového band 630 Hz. These results are compared with measured values modeled in the laboratory.

Diploma thesis develops comprehensive documentation of the new building construction of residential house on the level of the implementation of the project construction. Proposal emphasizes layout of linked to ensure the technical design, structural, fire safety, protection against noise, energy saving, safety in use. Work is performed in an electronic format using AutoCAD and Microsoft Word (PDF Creator).

This diploma thesis describes the design and processing of project documentation pension. The proposed facility is located in the village of Železná Ruda- Pamferova Hut. The site is widely used by tourists in winter and summer. This is partly basement building, which has 2 storeys and an attic. The roof is designed as a gabled dormer with a flat roof. The building is based on the footings of plain concrete and under the reinforced concrete pillars are designed shoe. Supporting, peripheral and partition walls are designed from sand-lime bricks SENDWIX. An exception is peripheral walls of the basement, which is in contact with soil, which is designed as a lost formwork. In the dining area, which has an open reinforced concrete columns. Ceiling structure will consist of prestressed ceiling panels SPIROLL. Perimeter walls are insulated using external thermal insulation composite system using insulation from stone wool. The building is functionally divided into three main parts with a common main entrance. The first part is a restaurant with a kitchen, storage and kitchen facilities. This section is designed restaurants with a total capacity of 26 persons, the capacity will be in the summer to expand the possible capacity of the terrace, which belongs to the dining room. It is also proposed sanitary facilities for visitors to the restaurant, kitchen with storage and facilities for staff. The second part is the wellness center, which consists of a gym and rooms with infrared sauna and whirlpool. This section is designed sanitary facilities for visitors separated for men and women. The last part of the pension, which used to accommodate 30 people and the background of the pension. Backgrounds pension means any technical equipment room, storage room for bikes and skis, and not least the individual room house, which also includes a room for personal hygiene. This thesis was created with an emphasis on a correct layout and architectural design, static requirements an

This thesis deals with the design and elaboration process of a project documentation of a sports centre. The designed sports centre building is situated in the southern part of the town of Polička, in the area determined for sports and free time activities complexes and areas. It is a two-floor, non-cellar, flat-roof building. It is based on plain concrete strip foundations and reinforced concrete foundation footing. The bearing, peripheral and partition walls are designed from POROTHERM hollow clay blocks. Reinforced concrete columns are designated in open disposition areas. The ceiling construction is made from SPIROLL pre-stressed concrete floor slabs and point-supported reinforced concrete slabs. The peripheral walls of the first aboveground floor are insulated with external thermal insulation system with a protective gabion facade. The peripheral wall thermal insulation in a bowling restaurant and gym halls extension is designed from a ventilated facade with CEMBRIT METRO facade cladding panels. The building is functionally divided into two main parts with a shared entrance. The sports centre with gyms and other sports facilities form the first part. Three squash courts, a mini-football piste, a special room for spinning and alpinning, a room for group exercising and cloakrooms with sanitary facilities are designed within one part of the sports centre. A restaurant with a bowling area and a kitchen with storerooms and other facilities for employees form the second part. The designed complex is barrier-free. There is aimed to be a car park for fifty cars, four motorbikes and a bus in front of the building. Three parking places are for disabled people.

The project solves a multifunctional Duma building in a vacant lot, contemplated the construction site is located in Carlsbad, in the street Vyhlíce. This is a protected site spa. Part of the project's layout and structural design of the house. It is a six-storey house with an attic and a basement floor. It is designed as a free-standing in the gap as the final house. The layout is divided into two complete units with their own input. There are spaces for business and residential units for permanent housing. Part of the living area are also room house equipment. Inputs to both parts are wheelchair accessible. The house is not wheelchair The house is designed as a brick building of brick masonry Porotherm the module dimensions of 250 (125) mm with reinforced concrete ceilings. Roofed by a hipped roof. The house is located on a private plot of 519 m2 built-up area of 221 m2. The land is gently sloping. The main orientation of the building to the cardinal's east and west. The south wall is adjacent to the neighboring house.