Spelling suggestions: "subject:"St. lawrence flatform"" "subject:"St. lawrence elatform""
1 |
Tracking Low Temperature Tectonism of the St. Lawrence Platform and Humber Zone, Southern Quebec Appalachians through Apatite and Zircon (U-Th)/He ThermochronologyEmberley, Justin January 2016 (has links)
The St. Lawrence Platform (SLP) and Humber Zone (HZ) of the southern Quebec Appalachians has historically been explored as a potential hydrocarbon reservoir. Extensive vitrinite reflectance studies on the basin resolved the degree of thermal maturation yet the timing of the thermal maximum is not well undertood. Determining the timing of such low temperature events can allow for a better understanding of the shallow crustal processes that may have allowed for the generation and entrapment of oil and gas. We have employed apatite (AHe) and zircon (ZHe) (U-Th)/He thermochronmetry across a network of late Cambrian to late Ordovician siliciclastic and Grenvillian basement samples in order to resolve the history within the ~210-35°C window. Single crustal dates from individual samples show age dispersion by as much as 300 m.y. with a strong positive to negative correlation with increasing eU concentration. A similar positive correlation can be observed when significant intra-sample grain size variation is present. AHe and ZHe data in the southwestern portion of the basin, near Montreal, allow for thermal maxima of up to 200°C to occur either during the late Ordovician, as a result of the Taconic orogeny, or from the continued sedimentation into the Devonian as a result of the Acadian orogeny. Regional burial trends deduced from these thermal maxima along with local paleo-geothermal gradients indicate that if sedimentation continued after the late Ordovician there was no significant increase in burial in southwestern portion of the SLP as previously suggested. Maximum heating is followed by a protracted cooling through the ZHe partial retention zone (PRZ) into the late Jurassic and early Cretaceous where the cooling rate increases by an order of magnitude through the AHe PRZ until ca. 100 Ma. The timing of this accelerated cooling is coeval with the passage of the Great Meteor Hot Spot across the area; the cooling may be a result of increased erosion from thermal uplift. Within the HZ, both the external and internal sections experienced rapid cooling through the Silurian after the Taconic thermal maximum. The timing of relatively rapid cooling coincides with documented normal faulting and back-thrusting in the orogen, which is the likely cause of exhumation. The HZ witnessed protracted cooling through the late Jurassic, when there is a one order of magnitude increase in cooling rate until surface conditions are attained. Increased recognition of these low temperature events has augmented our understanding of the evolution of accretionary orogens and consequently reduces the risks associated with oil and gas exploration.
|
2 |
The Mineralogical Composition of House Dust in Ontario, CanadaWoldemichael, Michael Haile 01 February 2012 (has links)
Despite increasing concern about the presence of heavy metals, pesticides and other toxins in indoor environments, very little is known about the physical and chemical composition of ordinary household dust. This study represents the first systematic investigation of the mineralogical composition of indoor dust in residential housing in Canada.
Specimens of dust were obtained from homes in six geographically separate cities in the Province of Ontario: two located on the metamorphic and igneous rocks of the Precambrian Canadian Shield (Thunder Bay and Sudbury), the other four located on Palaeozoic limestone and shale dominated bedrock (Barrie, Burlington, Cambridge, and Hamilton). Forty samples of household vacuum dust were obtained. The coarse fraction (80 – 300 µm) of this dust was subjected to flotation (using water) to separate the organic components (e.g. insect fragments, dander), natural and synthetic materials (e.g. fibres, plastics) from the mineral residue. The mineral fraction was then analyzed using quantitative point counting, polarizing light microscopy, powder X-ray diffraction and scanning electron microscopy methods.
Despite the great distances between the sampling localities and the distinct differences in bedrock geology, the mineral fraction of dust from all six cities is remarkably similar and dominated by quartz and feldspar, followed by lithic fragments, calcite, and amphibole. Some evidence of the influence of local geology can nevertheless be found. For example, a relatively higher proportion of sulphide minerals is observed in the two cities on the Canadian Shield where these minerals are clearly more abundant in the bedrock. Specimens from Sudbury, Canada’s largest mining centre located atop a nickel-sulphide mineral deposit, showed the highest sulphide contents. Quartz is the dominant mineral in all cities. All quartz grains have internal strain features and fluid inclusions that are indicative of a metamorphic-igneous provenance.
In all cities, sand is used on the streets as an abrasive for traction during the icy winter season. This sand is obtained in all cases from local glaciofluvial deposits that were ultimately derived principally from the rocks of the Canadian Shield in the last Pleistocene glaciations that affected all of Ontario. Thus, tracking in sand is the most plausible mechanism by which quartz was introduced into these homes since sampling was done, in all cases, in the winter season.
The results indicate that glacial deposits dominate the mineral composition of indoor dust in Ontario cities and that nature of the bedrock immediately underlying the sampling sites is relatively of minor importance.
|
3 |
The Mineralogical Composition of House Dust in Ontario, CanadaWoldemichael, Michael Haile 01 February 2012 (has links)
Despite increasing concern about the presence of heavy metals, pesticides and other toxins in indoor environments, very little is known about the physical and chemical composition of ordinary household dust. This study represents the first systematic investigation of the mineralogical composition of indoor dust in residential housing in Canada.
Specimens of dust were obtained from homes in six geographically separate cities in the Province of Ontario: two located on the metamorphic and igneous rocks of the Precambrian Canadian Shield (Thunder Bay and Sudbury), the other four located on Palaeozoic limestone and shale dominated bedrock (Barrie, Burlington, Cambridge, and Hamilton). Forty samples of household vacuum dust were obtained. The coarse fraction (80 – 300 µm) of this dust was subjected to flotation (using water) to separate the organic components (e.g. insect fragments, dander), natural and synthetic materials (e.g. fibres, plastics) from the mineral residue. The mineral fraction was then analyzed using quantitative point counting, polarizing light microscopy, powder X-ray diffraction and scanning electron microscopy methods.
Despite the great distances between the sampling localities and the distinct differences in bedrock geology, the mineral fraction of dust from all six cities is remarkably similar and dominated by quartz and feldspar, followed by lithic fragments, calcite, and amphibole. Some evidence of the influence of local geology can nevertheless be found. For example, a relatively higher proportion of sulphide minerals is observed in the two cities on the Canadian Shield where these minerals are clearly more abundant in the bedrock. Specimens from Sudbury, Canada’s largest mining centre located atop a nickel-sulphide mineral deposit, showed the highest sulphide contents. Quartz is the dominant mineral in all cities. All quartz grains have internal strain features and fluid inclusions that are indicative of a metamorphic-igneous provenance.
In all cities, sand is used on the streets as an abrasive for traction during the icy winter season. This sand is obtained in all cases from local glaciofluvial deposits that were ultimately derived principally from the rocks of the Canadian Shield in the last Pleistocene glaciations that affected all of Ontario. Thus, tracking in sand is the most plausible mechanism by which quartz was introduced into these homes since sampling was done, in all cases, in the winter season.
The results indicate that glacial deposits dominate the mineral composition of indoor dust in Ontario cities and that nature of the bedrock immediately underlying the sampling sites is relatively of minor importance.
|
4 |
The Mineralogical Composition of House Dust in Ontario, CanadaWoldemichael, Michael Haile 01 February 2012 (has links)
Despite increasing concern about the presence of heavy metals, pesticides and other toxins in indoor environments, very little is known about the physical and chemical composition of ordinary household dust. This study represents the first systematic investigation of the mineralogical composition of indoor dust in residential housing in Canada.
Specimens of dust were obtained from homes in six geographically separate cities in the Province of Ontario: two located on the metamorphic and igneous rocks of the Precambrian Canadian Shield (Thunder Bay and Sudbury), the other four located on Palaeozoic limestone and shale dominated bedrock (Barrie, Burlington, Cambridge, and Hamilton). Forty samples of household vacuum dust were obtained. The coarse fraction (80 – 300 µm) of this dust was subjected to flotation (using water) to separate the organic components (e.g. insect fragments, dander), natural and synthetic materials (e.g. fibres, plastics) from the mineral residue. The mineral fraction was then analyzed using quantitative point counting, polarizing light microscopy, powder X-ray diffraction and scanning electron microscopy methods.
Despite the great distances between the sampling localities and the distinct differences in bedrock geology, the mineral fraction of dust from all six cities is remarkably similar and dominated by quartz and feldspar, followed by lithic fragments, calcite, and amphibole. Some evidence of the influence of local geology can nevertheless be found. For example, a relatively higher proportion of sulphide minerals is observed in the two cities on the Canadian Shield where these minerals are clearly more abundant in the bedrock. Specimens from Sudbury, Canada’s largest mining centre located atop a nickel-sulphide mineral deposit, showed the highest sulphide contents. Quartz is the dominant mineral in all cities. All quartz grains have internal strain features and fluid inclusions that are indicative of a metamorphic-igneous provenance.
In all cities, sand is used on the streets as an abrasive for traction during the icy winter season. This sand is obtained in all cases from local glaciofluvial deposits that were ultimately derived principally from the rocks of the Canadian Shield in the last Pleistocene glaciations that affected all of Ontario. Thus, tracking in sand is the most plausible mechanism by which quartz was introduced into these homes since sampling was done, in all cases, in the winter season.
The results indicate that glacial deposits dominate the mineral composition of indoor dust in Ontario cities and that nature of the bedrock immediately underlying the sampling sites is relatively of minor importance.
|
5 |
The Mineralogical Composition of House Dust in Ontario, CanadaWoldemichael, Michael Haile January 2012 (has links)
Despite increasing concern about the presence of heavy metals, pesticides and other toxins in indoor environments, very little is known about the physical and chemical composition of ordinary household dust. This study represents the first systematic investigation of the mineralogical composition of indoor dust in residential housing in Canada.
Specimens of dust were obtained from homes in six geographically separate cities in the Province of Ontario: two located on the metamorphic and igneous rocks of the Precambrian Canadian Shield (Thunder Bay and Sudbury), the other four located on Palaeozoic limestone and shale dominated bedrock (Barrie, Burlington, Cambridge, and Hamilton). Forty samples of household vacuum dust were obtained. The coarse fraction (80 – 300 µm) of this dust was subjected to flotation (using water) to separate the organic components (e.g. insect fragments, dander), natural and synthetic materials (e.g. fibres, plastics) from the mineral residue. The mineral fraction was then analyzed using quantitative point counting, polarizing light microscopy, powder X-ray diffraction and scanning electron microscopy methods.
Despite the great distances between the sampling localities and the distinct differences in bedrock geology, the mineral fraction of dust from all six cities is remarkably similar and dominated by quartz and feldspar, followed by lithic fragments, calcite, and amphibole. Some evidence of the influence of local geology can nevertheless be found. For example, a relatively higher proportion of sulphide minerals is observed in the two cities on the Canadian Shield where these minerals are clearly more abundant in the bedrock. Specimens from Sudbury, Canada’s largest mining centre located atop a nickel-sulphide mineral deposit, showed the highest sulphide contents. Quartz is the dominant mineral in all cities. All quartz grains have internal strain features and fluid inclusions that are indicative of a metamorphic-igneous provenance.
In all cities, sand is used on the streets as an abrasive for traction during the icy winter season. This sand is obtained in all cases from local glaciofluvial deposits that were ultimately derived principally from the rocks of the Canadian Shield in the last Pleistocene glaciations that affected all of Ontario. Thus, tracking in sand is the most plausible mechanism by which quartz was introduced into these homes since sampling was done, in all cases, in the winter season.
The results indicate that glacial deposits dominate the mineral composition of indoor dust in Ontario cities and that nature of the bedrock immediately underlying the sampling sites is relatively of minor importance.
|
Page generated in 0.1491 seconds