A study has been made in CMOS RF-switches that can be used in the front-end of a multi-band radio targeting the 802.11a,b,g and W-CDMA standards and working in the frequency range 2.4-5.5GHz. Especially, one single-transistor switch and two types of transmission gates have been analyzed, simulated and compared with respect to loss, linearity, compression point and noise. From this, five different single-transistor switches have been designed for on-chip probing measurements. Special consideration has been taken to accommodate on-chip testing, thus additional structures have been designed. The simulations and design has been performed with Chartered 0.18um RF-CMOS process. The results from the simulations show that the single-transistor switch has better performance in loss, linearity, compression point and noise compared to the transmission gates. However, for the transmission gates the linearity can be increased beyond the linearity of the single-transistor switch if the widths of the transistors are made sufficiently large. For the single-transistor switch, simulation results show that the transistor length shall be kept to its minimum for best performance and that the number of fingers does not influence significantly. Also, there are optimum values for the loss in on-mode, the noise and the linearity and worst-case values for the loss in off-mode when the transistor width is varied. Consequently, the single- transistor switch can be tuned by its transistor width to accommodate desired performances.

The result of this master thesis report describes the advantages and the drawbacks that will arise when implementing an Ethernet based intercommunication system in military vehicles. The report presents a possible solution and describes how different sound applications will be implemented into the suggested solution. The report show that IP LAN in vehicles leads to more advantages than drawbacks. The main advantages are that all kind of media can share the same LAN and that there is a lot of knowledge of this technique in the civil area. The main drawback is about delay. The drawbacks are otherwise well known and methods are known to decrease the impact of them. In the suggested intercommunication system the processing delay gives the largest impact on not deliver data in real time. The suggested solution, with separate connections for intercom unit and PC platform to the switch at each crew member gives good reliability and security.

This thesis investigates four D flip-flops with data transmission look-ahead circuits. Based on logical effort and power-delay products to resize all the transistor widths along the critical path in µm CMOS technology. The main goal is to verify and proof this kind of circuits can be used when the input data have low switching probabilities. From comparing the average energy consumption between the normal D flip-flops and D flip-flops with look-ahead circuits, D flip-flops with look-ahead circuits consume less power when the data switching activities are low.

Low-sensitivity switched capacitor filters imitating 'R','L' and 'C' can be built by means of capacitances, ordinary switches and voltage inverter switches (VIS). These structures carry the inherent bilinear transformation of their doubly resistively terminated ladder reference filters. This one to one correspondence between the 's-domain' and the 'z-domain' results in the Nyquist criterion being the only limitation on the sampling frequency. This eliminates the necessity for oversampling and VIS filters can be designed for high operating rates. Filters based on VIS principle were analysed in previous literatures in the 'phi-domain'. In this thesis work, a successful attempt has been made to formulate an analysis procedure for discrete-time filters based on VIS principle in the 'z-domain'. Significant details have been brought out in comparison with the respective reference filter. A fifth-order lowpass filter has been designed and implemented to exhibit the closeness to the bilinearly transformed continuous-time reference filter. Settling time analysis has been done to justify the need for filters using VIS principle as compared to the filters employing integrator based switched capacitor filter. It is shown that VIS filter can be made to settle within half the period required for a conventional integrator based switched capacitor filter.

The objective of the proposed research is to use MEMS technology to develop low profile power inductors with minimized eddy current losses to be used in high power density compact switching converters. Eddy currents arise in high-flux density metallic cores as increased switching frequencies of DC-DC converters cause the skin depth to be small compared with the core thickness. Laminations can reduce the eddy current losses but converters operating with switching frequencies in the MHz regime may require submicron laminations. Previous research has been done to fabricate inductors with micron-scale laminated cores for high frequency switching converters. To optimize the previous fabrication technique, an automated electroplating system was developed for the fabrication of thick magnetic cores comprising large number of submicron laminations without human intervention. Inductors with higher inductance, quality factor and power handling capacity have been realized compared to previously developed inductors. The inductors are characterized in terms of saturation behavior and power handling capability. A miniaturized DC-DC converter with power conversion capacity of 10 Watts has been demonstrated using the fabricated inductor.

This study mainly concentrates on the exchange rate problems between Taiwan and China, so cross-strait economic and the evolution of exchange rate regulation regime would be the first work so as to provide some policy suggestions about the cross-strait trading settlement .The empirical work has two parts. The first part is examining the Currency Substitution(CS) of Taiwan, then uses Cointergration and Vector Estimate Correction Model for the short and long run condition. Currency Substitution would cause the volatility of exchange rate, and the next procedure is using the Markov Regime Switch Model to analyze the exchange rate of two countries from 03 January,1994 to 30 April,2012. The main purpose of this study is examining whether the two markets have a significant regime switch or not, then the empirical result finds that both markets have regime switch .Considering the difference of exchange rate regime in two countries, the decision of the cross rate becomes more prudent because China authority may underestimate the exchange to disturb the export of Taiwan.

This paper focuses on stock markets, including Portugal¡BItaly¡BIreland¡BGreece and Spain, and these are named PIGS by economists. Furthermore, we add the other three countries, U.S.A.¡BU.K. and Germany in this paper for investigating the dependence structure in the stock markets between these countries during the period 2001-2011. We implement a regime-switching copula model based on Gaussian copula, which uses a GARCH specification for the marginal distributions and the Gaussian copula for the joint distribution. Our method combines copulas and regime-switching models to demonstrate dependence sructures in stock markets between these countries. Based on this paper, we have two reports for international investors. First, if the dependency changes over time, the returns of portfolio diversification may be prone to diversification disasters, and the international investors' degrees of diversification can cause higher systemic risk in the period of financial crisis. Second, the phonomenon of the asymmetric dependence exists in financial markets, and we conclude that non-diversification may be better than diversification in the period of financial crisis.

Electronic devices, for logical and memory applications, are constructed based on bistable electronic units that can store binary information. Molecular electronics proposes the use of single molecules—with two distinctive states of conductance—as bistable units that can be used to create more complex electronic devices. The conductance of a molecule is strongly influenced by the contacts used to address it. The purpose of this work is to determine the electrical characteristics of several candidate molecular junctions, which are composed of a molecule and contacts. Specifically, we are interested in determining whether binary information, “0” or “1,” can be encoded in the low- and high-conductance states of the molecular junctions. First, we calculate quantum-mechanically the electronic structure of the molecular junction. Second, the continuous electronic states of the contacts, originated from their infinite nature, are obtained by solving the Schrödinger equation with periodic boundary conditions. Last, the electron transport through the molecular junctions is calculated based on a chemical interpretation of the Landauer formalism for coherent transport, which involves the information obtained from the molecule and the contacts. Metal-molecule-metal and metal-molecule-semiconductor junctions are considered. The molecule used is an olygo(phenylene ethynylene) composed of three benzene rings and a nitro group in the middle ring; this molecule is referred hereafter as the nitroOPE molecule. Gold, silicon, and metallic carbon nanotubes are used as contacts to the molecule. Results from the calculations show that the molecular junctions have distinctive states of conductance for different conformational and charge states. High conductance is found in the conformation in which all the benzene rings of the nitroOPE are coplanar. If the middle benzene ring is made perpendicular to the others, low conductance is found. Also, the negatively charged junctions (anion, dianion) show low conductance. Whenever a semiconducting contact is used, a flat region of zero current is found at low bias voltages. The results indicate that the use of Si contacts is possible; however, because of the flat region, the operating point of the devices needs to be moved to higher voltages.

In this work the interactions between neighboring superconducting thin film and ferromagnetic structures, i.e. superconductor-ferromagnet hybrid systems, were studied. A type-II superconducting thin film (Pb82Bi12), was deposited in close proximity to various ferromagnetic structures. These magnetic structures include: (i) alternating iron-brass shims of 275 mu m period, (ii) an array of 4 mu m wide Co stripes with smaller period (9 mu m), (iii) a square array of 50nm diameter, high aspect ratio (5-7) Ni rods with 250nm period. Measurements of critical transport current (IC), resistance (RH(T)) and second critical field (HC2) are reported. A variety of novel effects (enhancement of (IC) and (HC2), matching field effect, field compensation effect, and large hysteresis) are also reported. Using measurements on thin superconducting films atop a Co stripe array with a 9 mu m period, a superconductor-ferromagnet hybrid device (a mechanical superconducting persistent switch) is proposed. In addition, scanning Hall probe microscopy (SHPM) and other imaging techniques were used to characterize the magnetic properties of the systems mentioned. The SHPM was also used to acquire B-H and M-H curves. An additional sharp magnetic needle and electromagnetic coil assembly intended for micromanipulation of small magnetic particles and individual cells was also characterized.

Due to the World Wide Web (WWW) has expanded speedily, the interaction between the user and the Web site is becoming persistently. Most proposed load control schemes developed based on the traditional Web site providing static files are not suitable for the Web site today. The new generation of WWW provides more varied and secure services. The greater part of applications are belonging to the session-based service. In order to provide better quality of services for the users, Web cluster architecture becomes the popular solution for most Web sites. This architecture combines serveral servers to work together and deals satisfied with the exponential increasing in service on WWW. In this paper, we proposed a session-based admission control and load balancing mechanism for Web cluster systems. The admission control scheme is used to prevent Web system from becoming overload by determining whether an establishment of TCP connection is admitted or not. The load balancing scheme assigns new sessions to the suitable back-end server and achieves good load balancing among back-end servers, which also increases the throughput of system. The simulation results demonstrate that our mechanism utilizes system resource efficiently and takes system utilization and percentage of completed session into account simultaneously. Therefore, our mechanism can ensure the sessions would not be aborted midway. To compare with others, our mechanism can attain higher throughput and maintain the request average delay time. Furthermore, whether the back-end servers are identical in capacity or not, their load always get good balance.