Finite element analyses are frequently used to model growing fatigue cracks and the associated plasticity-induced crack closure. Two-dimensional, elastic-perfectly plastic finite element analyses of middle-crack tension (M(T)), bend (SEB), and compact tension (C(T)) geometries were conducted to study fatigue crack closure and to calculate the crack opening values under plane-strain and plane-stress conditions. The loading was selected to give the same maximum stress intensity factor in both geometries, and thus similar initial forward plastic zone sizes. Mesh refinement studies were performed on all geometries with various element types. For the C(T) geometry, negligible crack opening loads under plane-strain conditions were observed. In contrast, for the M(T) specimen, the plane-strain crack opening stresses were found to be significantly larger. This difference was shown to be a consequence of in-plane constraint. Under plane-stress conditions, it was found that the in-plane constraint has negligible effect, such that the opening values are approximately the same for the C(T), SEB, and M(T) specimens. Next, the crack opening values of the C(T), SEB and M(T) specimens were compared under various stress levels and load ratios. The effect of a highly refined mesh on crack opening values was noted and significantly lower crack opening values than those reported in literature were found. A new methodology is presented to calculate crack opening values in planar geometries using the crack surface nodal force distribution under minimum loading as determined from finite element analyses. The calculated crack opening values are compared with values obtained using finite element analysis and more conventional crack opening assessment methodologies. It is shown that the new method is independent of loading increment, integration method (normal and reduced integration), and crack opening assessment location. The compared opening values were in good agreement with strip-yield models.

No description available.

The aim of the thesis is the investigation of fracture-mechanics parameters on specimens made of quasi-brittle materials. The principles of two-parameter fracture mechanics are used. Couple of numerical simulations were done and their outputs are used for two main analysed specimen geometries. For simulations the finite element method software ANSYS is used. In the first part, the thesis focuses on bended specimens. The influence of different geometric parameters on fracture mechanics behaviour of cracked specimen is investigated. For model calibration the outputs of other authors are used. In the second part the specimens for modified compact-tension test (CT test) are analysed. Similar to the first part, the influence of geometric parameters of the specimen (in this case, the specimen size) on fracture mechanics parameters were investigated. The modified CT test was derived from CT test which is commonly used for metal materials testing as the suitable geometry for cement-based composite materials testing. The outputs of both parts are calibration polynomials, which are expressions obtained for different specimen geometries, giving the value of fracture mechanics parameter as the function of specimen geometry. As the example, calibration curves are used to obtain fracture toughness of tested material using the outputs from recent experiment.