Disorders of the autonomic nervous system constitute serious complications of spinal cord injury (SCI) and their treatment is usually highly prioritised by spinal patients. Among these, autonomic dysreflexia and impaired thermoregulation are potentially life threatening conditions and require effective management. Olfactory ensheathing cells (OECs), progenitor cells and polymeric scaffolds have been tested in animal models of SCI and some of them have been considered for clinical trials. However, evaluation of the effect of such interventions on autonomic functions has received only rudimentary attention and would require a more thorough experimental assessment before the methods are utilised in human patients. This thesis tested two potential therapeutic strategies for autonomic dysreflexia and examined disorders of thermoregulatory functions in a rat model of spinal cord transection. Magnitude and duration of autonomic dysreflexia were evaluated with radio telemetry in spinalised animals treated with (i) implants of OECs and olfactory neurosphere-derived cells seeded in poly(lactic co glycolic) porous scaffolds or with (ii) transplants of OECs alone. (iii) Effects of SCI and of OECs on the morphology of sympathetic preganglionic neurons (SPNs; which are involved in pathogenesis of autonomic dysreflexia) stained for NADPH diaphorase were examined. (iv) Doppler ultrasonography and infrared thermography were used to assess responses of tail blood flow and surface temperature to cold. Transplants of OECs alone, but not in combination with olfactory neurosphere-derived cells and polymeric scaffolds, resulted in significantly shortened episodes of autonomic dysreflexia. This may be attributed to the alterations to the morphology of SPNs adjacent to the lesion: a transient increase in the morphometric features of the SPNs was evoked by spinal cord transection and this was further altered by transplantation of OECs. The thesis also showed that local responses of tail blood flow and temperature to cold were not abolished by complete SCI suggesting that temperature homeostasis could still be maintained in response to cold. It is hypothesised that OECs facilitate improved recovery from autonomic dysreflexia through alteration of the morphology of SPNs. Furthermore, it is suggested that the role of the tail in heat conservation can be regulated by mechanisms that are independent of the descendent neural control from supraspinal centres.

"April 2002" Includes bibliographical references (leaves 200-249)

"April 2002" / Includes bibliographical references (leaves 200-249) / xv, 249 leaves : ill., plates (some col.) ; 30 cm. / Title page, contents and abstract only. The complete thesis in print form is available from the University Library. / Thesis (Ph.D.)--University of Adelaide, Dept. of Animal Science, 2003

The ability to resolve reactions within a monolith spatially and temporally is key in developing reliable kinetic models, as well as in validating proposed reaction mechanisms. In this work, two techniques, IR-thermography and spatially-resolved capillary inlet mass spectrometry (SpaciMS), were used to measure temperature and gas-phase concentrations. Specifically, they were applied to monitor the axial distribution of temperature and concentration profiles during propylene oxidation over a Pt/Al2O3 monolith-supported catalyst. Also, the effect of thermally aging the catalyst on the temperature and concentration patterns observed was investigated. During temperature programmed oxidation experiments, the data show that conversion of propylene began at the outlet, and a reaction front generated at the rear of the monolith traveled upstream, as a moving reaction zone, thereby creating a temperature wave pattern since the reaction is exothermic. The conversion was always complete downstream of this reaction zone at any point along the catalyst. When the reactor was cooled, the conversion of propylene started to drop, accompanied by a similar temperature wave pattern that traveled in the opposite direction (from upstream to downstream) and was attributed to a phenomenon known as wrong-way behavior. Finally, thermally aging the catalyst led to a slower and more localized moving hot zone.

The ability to resolve reactions within a monolith spatially and temporally is key in developing reliable kinetic models, as well as in validating proposed reaction mechanisms. In this work, two techniques, IR-thermography and spatially-resolved capillary inlet mass spectrometry (SpaciMS), were used to measure temperature and gas-phase concentrations. Specifically, they were applied to monitor the axial distribution of temperature and concentration profiles during propylene oxidation over a Pt/Al2O3 monolith-supported catalyst. Also, the effect of thermally aging the catalyst on the temperature and concentration patterns observed was investigated. During temperature programmed oxidation experiments, the data show that conversion of propylene began at the outlet, and a reaction front generated at the rear of the monolith traveled upstream, as a moving reaction zone, thereby creating a temperature wave pattern since the reaction is exothermic. The conversion was always complete downstream of this reaction zone at any point along the catalyst. When the reactor was cooled, the conversion of propylene started to drop, accompanied by a similar temperature wave pattern that traveled in the opposite direction (from upstream to downstream) and was attributed to a phenomenon known as wrong-way behavior. Finally, thermally aging the catalyst led to a slower and more localized moving hot zone.

This study expands on the work of ElHajjar and HajAli (2003) on a quantitative thermoelastic strain analysis method for composite materials. Computational models for various prepreg and thicksection composites are validated with experiments using this quantitative strain analysis method. This study provides this thermomechanical calibrations for prepreg S2glass/epoxy, Carbon/epoxy, and pultruded Eglass/polyester. A research collaboration with the Institute of Paper Science and Technology (IPST) focused on infrared thermography for defect detection in wood and fibrous materials and structural systems. This study provides some detailed information on various testing setups for fiber and corrugated board systems to analyze anomalies and manufacturing defects. Quantitative infrared thermography is suggested as a preferred method for assessing the bond quality in corrugated paper systems. Methods for tracking fullfield thermal data during fatigue have been developed for FRP composites. The temperature changes on the surface of an FRP composite caused by damage during fatigue are tracked and thermoelastic stress analysis (TSA) technique is developed to relate the surface deformation to the IR emission. Infrared thermography is developed for fatigue damage detection in FRP composites with stochastic methods for analyzing this fullfield data. Future damage detection techniques in aging aircraft will require quantitative and noncontact nondestructive evaluation (NDE) methods especially for composite components. Infrared (IR) thermograpy techniques are qualitatively used to assess and indirectly infer the durability of structural systems. A research collaboration with Lockheed Martin for nondestructive evaluation of composite lap shear joints led to a development of thermoelastic stress analysis techniques for evaluation aerospace structures. Infrared thermography is used to investigate failure initiation and progression in composite lap shear joints.

Comprehensive studies are needed to discover materials and construction technologies contributing to the thermal performance of historical buildings and to keep them in working order over time. Examined in this study were the thermal performance characteristics of Seng&uuml / l Hamami, a 15th Century Ottoman bath, to discover original thermo-physical properties of historic materials and to assess thermal failures in present situation by taking into consideration recent incompatible repair work. The analyses were done by using non-destructive investigation methods, such as microclimatic monitoring, quantitative infrared thermography (QIRT), heat and water vapour transfer calculations, supported by laboratory analyses on thermo-physical properties of historic materials. The results were evaluated in terms of thermal properties of historic materials establishing the historic dome section, microclimatic characteristics of Seng&uuml / l Hamami, its original thermal characteristics, and thermal failures occurred in time due to wrong repairs. An in-situ assessment method was also developed for the identification of thermal and moisture failures at real boundary conditions by joint interpretation of QIRT and heat transfer calculation results. The study showed that historic dome structure of Seng&uuml / l Hamami was originally configured to provide sufficient thermal insulation characteristics owing to good thermal properties of its materials. That success was attributed to conscious use of low-density, high-porosity historic materials having low thermal conductance and high vapour permeability characteristics. It was seen that the thermal performance of historic structure was severely destroyed by recent repairs using concrete and cement-based materials, which were incompatible with historic fabric of the structure due to their different thermo-physical properties.

This study presents results from non-destructive testing to evaluate the degradation of the CFRP-masonry bond using thermal imaging. The goal of the research was to identify locations where there was evidence of bond deterioration that could subsequently be verified through destructive pull-off testing. Four full-scale masonry walls were built outdoors at the University of South Florida in 1995 to evaluate the effectiveness of CFRP for repairing settlement damage. Two of the settlement-damaged walls were repaired using single layer, commercially available unidirectional CFRP systems that used Tonen (wall 3) and Henkel (wall 2) epoxies. These two walls were the subject of this investigation. Before non-destructive tests were initiated, historical site data on temperature, humidity and rainfall variation was compiled. Over seventeen years, the walls experienced ambient temperatures as high as 98°F and as low as 25°F. The average rainfall in Tampa is about 34 inches and the annual average high humidity is around 87%#37;. Because of the high temperature and humidity, the CFRP-masonry bond was exposed to a particularly aggressive environment. Three types of thermal evaluation were carried out: thermocouple monitoring and both passive (solar) and active (localized heating) infrared thermal imaging. Twenty-four thermocouples were used to observe the spatial variations in temperature on the wall. Data showed that the surface temperatures of the wall are uneven with one end being hotter than the other. Measurements indicated that the wall temperatures went as high as 103°F during the week of data collection in late March and early April of 2012. In contrast, the highest ambient temperature over the same period was 92°F. The high temperature experienced by the wall is below the glass transition temperature for the epoxies, which ranges from 140°F to 180°F. A FLIR Tau 320 thermal imaging camera was used to identify localized de-bonding. Solar radiation heated the walls and the goal of thermal imaging was to detect hot spots which are indicative of de-bonding. Although this technique is ideal for exterior applications, initial attempts were unsuccessful. Once de-bonds were located by sounding, the camera was capable of confirming two hot spots on wall 2. A thermal scanner built by the university from a series of ten Omega OS137 thermal sensors was used to obtain more complete thermal images of the walls. This scanner had a heating element which supplied heat and allowed for active thermography. The scanner detected 16 hot spots not seen with the thermal camera. Ten of the twelve spots on wall 2 are concentrated on a region of the wall which experienced the highest daily changes in temperature, which indicates that higher thermal and environmental cycling has caused greater de-bond. Based on the number of hot spots found using both active and passive thermography the Tonen epoxy is performing better than the Henkel epoxy. In general, the bond has endured; however, there are a few localized areas that have de-bonded. Pull-off tests are recommended on walls 2 and 3. Five locations in regions suspected to have poor bond and five locations in regions suspected to have good bond are identified for each wall.

Sleep is a behavioral condition fraught with mystery. Its definition—either a suite of diagnostic behavioral characters, electrophysiological signatures, or a combination of the two—varies in the literature and lacks an over-arching purpose. In spite of these vagaries, sleep supports a large and dynamic research community studying the mechanisms, ontogeny, possible functions and, to a lesser degree, its evolution across vertebrates and in a small number of invertebrates. Sleep has been described and examined in many social organisms, including eusocial honey bees (Apis mellifera), but the role of sleep within societies has rarely been addressed in non-human animals. I investigated uniquely social aspects of sleep within honey bees by asking basic questions relating to who sleeps, when and where individuals sleep, the flexibility of sleep, and why sleep is important within colonies of insects. First, I investigated caste-dependent sleep patterns in honey bees and report that younger workers (cell cleaners and nurse bees) exhibit arrhythmic and brief sleep bouts primarily while inside comb cells, while older workers (food storers and foragers) display periodic, longer sleep bouts primarily outside of cells. Next, I mapped sleep using remote thermal sensing across colonies of honey bees after introducing newly eclosed workers to experimental colonies and following them through periods of their adult lives. Bees tended to sleep outside of cells closer to the edge of the hive than when asleep inside cells or awake, and exhibited caste-dependent thermal patterns, both temporally and spatially. Wishing to test the flexibility of sleep, I trained foragers to a feeder and made a food resource available early in the morning or late in the afternoon. The bees were forced to shift their foraging schedule, which consequently also shifted their sleep schedule. Finally, I sleep-deprived a subset of foragers within a colony by employing a magnetic “insominator” to test for changes in their signaling precision. Sleep-deprived foragers exhibited reduced precision when encoding direction information to food sources in their waggle dances. These studies reveal patterns and one possible purpose of sleep in the context of a society. / text

Disorders of the autonomic nervous system constitute serious complications of spinal cord injury (SCI) and their treatment is usually highly prioritised by spinal patients. Among these, autonomic dysreflexia and impaired thermoregulation are potentially life threatening conditions and require effective management. Olfactory ensheathing cells (OECs), progenitor cells and polymeric scaffolds have been tested in animal models of SCI and some of them have been considered for clinical trials. However, evaluation of the effect of such interventions on autonomic functions has received only rudimentary attention and would require a more thorough experimental assessment before the methods are utilised in human patients. This thesis tested two potential therapeutic strategies for autonomic dysreflexia and examined disorders of thermoregulatory functions in a rat model of spinal cord transection. Magnitude and duration of autonomic dysreflexia were evaluated with radio telemetry in spinalised animals treated with (i) implants of OECs and olfactory neurosphere-derived cells seeded in poly(lactic co glycolic) porous scaffolds or with (ii) transplants of OECs alone. (iii) Effects of SCI and of OECs on the morphology of sympathetic preganglionic neurons (SPNs; which are involved in pathogenesis of autonomic dysreflexia) stained for NADPH diaphorase were examined. (iv) Doppler ultrasonography and infrared thermography were used to assess responses of tail blood flow and surface temperature to cold. Transplants of OECs alone, but not in combination with olfactory neurosphere-derived cells and polymeric scaffolds, resulted in significantly shortened episodes of autonomic dysreflexia. This may be attributed to the alterations to the morphology of SPNs adjacent to the lesion: a transient increase in the morphometric features of the SPNs was evoked by spinal cord transection and this was further altered by transplantation of OECs. The thesis also showed that local responses of tail blood flow and temperature to cold were not abolished by complete SCI suggesting that temperature homeostasis could still be maintained in response to cold. It is hypothesised that OECs facilitate improved recovery from autonomic dysreflexia through alteration of the morphology of SPNs. Furthermore, it is suggested that the role of the tail in heat conservation can be regulated by mechanisms that are independent of the descendent neural control from supraspinal centres.