<p>Results from this study enables a better understanding of groundwater surface water interactions in the TMG, particularly regarding aquatic ecosystems. It has also highlighted the necessity to do proper impact assessments before proceeding with bulk abstraction from this important aquifer. The results also demonstrated the importance of differentiating between real groundwater and non-groundwater discharge contributions to surface hydrology and where these interface areas are located.</p>

<p>Results from this study enables a better understanding of groundwater surface water interactions in the TMG, particularly regarding aquatic ecosystems. It has also highlighted the necessity to do proper impact assessments before proceeding with bulk abstraction from this important aquifer. The results also demonstrated the importance of differentiating between real groundwater and non-groundwater discharge contributions to surface hydrology and where these interface areas are located.</p>

Philosophiae Doctor - PhD / Results from this study enables a better understanding of groundwater surface water interactions in the TMG, particularly regarding aquatic ecosystems. It has also highlighted the necessity to do proper impact assessments before proceeding with bulk abstraction from this important aquifer. The results also demonstrated the importance of differentiating between real groundwater and non-groundwater discharge contributions to surface hydrology and where these interface areas are located. / South Africa

Philosophiae Doctor - PhD / The Table Mountain Group (TMG) Aquifer is a huge aquifer system which may provide large bulk water supplies for local municipalities and irrigation water for agriculture in the Western Cape and Eastern Cape Provinces in South Africa. In many locations, water pressure in an aquifer may force groundwater out of ground surface so that the borehole drilled into the aquifer would produce overflow without a pump. Appropriate testing and evaluation of such artesian aquifers is very critical for sound evaluation and sustainable utilization of groundwater resources in the TMG area. However, study on this aspect of hydrogeology in TMG is limited. Although the flow and storage of TMG aquifer was conceptualised in previous studies, no specific study on artesian aquifer in TMG was made available. There are dozens of flowing artesian boreholes in TMG in which the pressure heads in the boreholes are above ground surface locally. A common approach to estimate hydraulic properties of the aquifers underneath is to make use of free-flowing and recovery tests conducted on a flowing artesian borehole. However, such testing approach was seldom carried out in TMG due to lack of an appropriate device readily available for data collection. A special hydraulic test device was developed for data collection in this context. The test device was successfully tested at a flowing artesian borehole in TMG. The device can not only be used to measure simultaneous flow rate and pressure head at the test borehole, but also be portable and flexible for capturing the data during aquifer tests in similar conditions like artesian holes in Karoo, dolomite or other sites in which pressure head is above ground surface. The straight-line method proposed by Jacob-Lohman is often adopted for data interpretation. However, the approach may not be able to analyse the test data from flowing artesian holes in TMG. The reason is that the TMG aquifers are often bounded by impermeable faults or folds at local or intermediate scale, which implies that some assumptions of infinite aquifer required for the straight-line method cannot be fulfilled. Boundary conditions based on the Jacob-Lohman method need to be considered during the simulation. In addition, the diagnostic plot analysis method using reciprocal rate derivative is adapted to cross-check the results from the straight-line method. The approach could help identify the flow regimes and discern the boundary conditions, of which results further provide useful information to conceptualize the aquifer and facilitate an appropriate analytical method to evaluate the aquifer properties. Two case studies in TMG were selected to evaluate the hydraulic properties of artesian aquifers using the above methods. The transmissivities of the artesian aquifer in TMG range from 0.6 to 46.7 m2/d based on calculations with recovery test data. Storativities range from 10-4 to 10-3 derived from free-flowing test data analysis. For the aquifer at each specific site, the transmissivity value of the artesian aquifer in Rawsonville is estimated to be 7.5–23 m2/d, with storativity value ranging from 2.0×10-4 to 5.5×10-4. The transmissivity value of the artesian aquifer in Oudtshoorn is approximately 37 m2/d, with S value of 1.16×10-3. The simulation results by straight-line and diagnostic plot analysis methods, not only imply the existence of negative skin zone in the vicinity of the test boreholes, but also highlight the fact that the TMG aquifers are often bounded by impermeable faults or folds at local or intermediate scale. With the storativity values of artesian aquifers derived from data interpretation, total groundwater storage capacity of aquifers at two case studies was calculated. The figures will provide valuable information for decision-makers to plan and develop sustainable groundwater utilization of artesian aquifers in local or intermediate scales. With the hydraulic test device readily available for data collection, more aquifer tests can be carried out in other overflow artesian boreholes in TMG. It becomes feasible to determine the hydraulic properties of artesian aquifers for the entire TMG. Thereof quantification of groundwater resources of artesian aquifers in TMG at a mega-scale becomes achievable. This would also contribute towards global research initiative for quantification of groundwater resources at a mega-scale.

<p><font face="TimesNewRoman"> <p align="left">Research findings in current study provide a new insight into the fractured rock aquifers in the TMG area. Some of the results will have wide implications on the groundwater management and forms a solid basis the further study of the TMG aquifers.</p> </font></p>

<p><font face="TimesNewRoman"> <p align="left">Research findings in current study provide a new insight into the fractured rock aquifers in the TMG area. Some of the results will have wide implications on the groundwater management and forms a solid basis the further study of the TMG aquifers.</p> </font></p>

Philosophiae Doctor - PhD / Research findings in current study provide a new insight into the fractured rock aquifers in the TMG area. Some of the results will have wide implications on the groundwater management and forms a solid basis the further study of the TMG aquifers.

Philosophiae Doctor - PhD / Research findings in current study provide a new insight into the fractured rock aquifers in the TMG area. Some of the results will have wide implications on the groundwater management and forms a solid basis the further study of the TMG aquifers.

>Magister Scientiae - MSc / Deformation of the western part of the Table Mountain Group rocks during the Cape Orogeny created a series of folds and associated fractures. The subsequent continental break-up of Gondwana led to the development of large fault systems. These exert a major influence on deep and shallow groundwater flow. There are 3 main types of structures that are investigated. The geological contacts between hydraulically different lithologies, the primary characteristics of the sediments comprising the main geological units and the secondary structures developed from the tectonic events. These inter-alia include lithological boundaries, bedding and conjugate joints and large faults. Compartmentalisation of the aquifers by lithological and fault boundaries are the main regional level controls on flow in the study area. Joints are important for local control of flow, but cumulatively exert a regional effect as well. These controls exert a strong 3 dimensional impact on flow patterns within the area. Geological cross sections and detailed fieldwork combined with the conceptual models proposed are used to determine groundwater flow and the extent of the flow constraints. There is heterogeneity in the fault characteristics whilst there is consistence in the impermeable aquitards. These effect boundaries at the base of the aquifer, divide the aquifer into upper and lower units and cap the top of the aquifer. Using water level data, EC and pH an attempt is made to establish patterns created by structures, mainly faults. There appears to be some control of these shown by patterns seen on contour plots of the data. Understanding of the structures can significantly alter the way the available data could be interpreted. The integration of all available data into the conceptual model provides an effective research tool, which opens up further avenues for new approaches and methods for continued research in this area.