1 |
Adaptación de una Herramienta de Generación de Mallas Geométricas 3D a una Nueva ArquitecturaContreras Bertin, Felipe Ignacio January 2007 (has links)
El objetivo del presente trabajo es realizar una adaptación de un sistema de generación de mallas geométricas a una arquitectura orientada a objetos. Se espera entonces evaluar, en cuanto a la ingeniería de software, el sistema resultante. En base al objetivo descrito se realiza una investigación teórica de la ingeniería de software, los estudios de buenas prácticas realizados por el departamento, y una evaluación del sistema a actualizar. Por último se entrega la metodología de desarrollo para el buen cumplimiento de la adaptación.
|
2 |
Aerodynamic Loads on External Stores - Saab 39 Gripen : Evaluation of CFD methods for estimating loads on external storesSpjutare, Christian January 2009 (has links)
<p>External stores mounted on aircraft generate loads which need to be estimated before first takeoff. These loads can be measured in a wind tunnel but since the possible store configurations are basically endless, testing them all is neither economically feasible nor time efficient. Thus, scaling based on geometrical similarity is used. This can, however, be a crude method. Stores with similar geometrical properties can still behave in different ways due to aerodynamic interference caused by adjacent surfaces.</p><p>To improve the scaling performance, this work focuses on investigating two CFD codes, ADAPDT and Edge. The CFD simulations are used to derive the difference in aerodynamic coefficients, or the Δ-effect, between a reference store and the new untested store. The Δ-effect is then applied to an existing wind tunnel measurement of the reference store, yielding an estimation of the aerodynamic properties for the new store.</p><p>The results show that ADAPDT, using a coarse geometry representation, has large difficulties predicting the new store properties, even for a very simple store configuration on the aircraft. Therefore it is not suited to use as a scaling tool in its present condition. Edge on the other hand uses a more precise geometry representation and proves to deliver good estimations of the new store load behavior. Results are well balanced and mainly conservative. Some further work is needed to verify the performance but Edge is the recommended tool for scaling.</p><p> </p>
|
3 |
Aerodynamic Loads on External Stores - Saab 39 Gripen : Evaluation of CFD methods for estimating loads on external storesSpjutare, Christian January 2009 (has links)
External stores mounted on aircraft generate loads which need to be estimated before first takeoff. These loads can be measured in a wind tunnel but since the possible store configurations are basically endless, testing them all is neither economically feasible nor time efficient. Thus, scaling based on geometrical similarity is used. This can, however, be a crude method. Stores with similar geometrical properties can still behave in different ways due to aerodynamic interference caused by adjacent surfaces. To improve the scaling performance, this work focuses on investigating two CFD codes, ADAPDT and Edge. The CFD simulations are used to derive the difference in aerodynamic coefficients, or the Δ-effect, between a reference store and the new untested store. The Δ-effect is then applied to an existing wind tunnel measurement of the reference store, yielding an estimation of the aerodynamic properties for the new store. The results show that ADAPDT, using a coarse geometry representation, has large difficulties predicting the new store properties, even for a very simple store configuration on the aircraft. Therefore it is not suited to use as a scaling tool in its present condition. Edge on the other hand uses a more precise geometry representation and proves to deliver good estimations of the new store load behavior. Results are well balanced and mainly conservative. Some further work is needed to verify the performance but Edge is the recommended tool for scaling.
|
Page generated in 0.0356 seconds