<p>This work reports the chemical synthesis, characterisation and electrochemical application of titanium dioxide (TiO2) and iron oxide (Fe2O3) nanoparticles in the determination of phthalates. The other part of this work involved electrochemical polymerization of aniline doped with titanium and iron oxide nanoparticles for the sensor platform in the electrolytic determination of phthalates. The TiO2 and Fe2O3 nanoparticles were prepared by sol gel and hydrothermal methods respectively. Particle sizes of 20 nm (TiO2) and 50 nm (Fe2O3) were estimated from transmission electron microscopy (TEM) The other technical methods used in this study for the characterization of the TiO2 and iron oxide Fe2O3 NPs were SEM, XRD and UV- visible spectroscopy. Cyclic voltammetry, square wave voltammetry and electrochemical impedance spectroscopy (EIS) were used to study the electrochemical properties of the nanoparticles. These electrochemical studies of the nanoparticles were performed with a Fe2O3 or TiO2/nafion/glassy carbon membrane electrode in 0.1 M phosphate buffer (pH 7.0) and 0.1 M lithium perchlorate (pH 6.8) under an aerobic condition.</p>

Novel, tailored titanium dioxide pigments with controllable nanoscale morphological features were shown to significantly enhance the optical and strength properties of paper. The opacifying power of synthesized polycrystalline TiO2 particles in a cellulose matrix was found experimentally to be superior to that of a commercial rutile pigment, depending on the crystal structure of the synthesized particles. High aspect ratio polycrystalline rutile pigments composed of a linear linkage of several individual rutile crystals gave 6% more opacity than the commercial rutile pigment. Theoretical light scattering calculations using the T-Matrix Method showed the light scattering efficiency of linearly arranged polycrystalline rutile particles to depend on number and size of crystals composing the particle and confirmed the higher efficiency of the synthesized polycrystalline rutile pigments over commercial rutile. The opacifying power of hollow polycrystalline rutile particles was found experimentally to be superior to that of a commercial rutile pigment in a highly pressed bleached fiber matrix, depending on cavity size, while the opacifying power of silica-rutile titania core-shell particles was found comparable to commercial rutile at constant titania loading. The light scattering efficiency of titania core-shell particles was shown to be dependant on the light scattering efficiency of the core material. The overall particle shape and aspect ratio of titania core-shell and hollow nanoparticles were shown to be tunable by choosing an appropriate template and coating thickness in layer-by-layer or sol-gel templating synthesis. Inorganic-cellulose core-shell and hollow cellulose nanoparticles were prepared by self-encapsulation with regenerated cellulose via precipitation of cellulose in a polyacrylic acid hydrogel layer surrounding inorganic particle templates in 4-Methylmorpholine N-oxide (NMMO) monohydrate solution. This discrete encapsulation of inorganic pigments with a thin, uniform cellulose shell was found to increase the bondability improvement between the particles and a polysaccharide substrate. The crystallinity of several carbohydrate polymers was shown to significantly affect the bondability of encapsulated core-shell particles.

Magister Scientiae - MSc / This work reports the chemical synthesis, characterisation and electrochemical application of titanium dioxide (TiO2) and iron oxide (Fe2O3) nanoparticles in the determination of phthalates. The other part of this work involved electrochemical polymerization of aniline doped with titanium and iron oxide nanoparticles for the sensor platform in the electrolytic determination of phthalates. The TiO2 and Fe2O3 nanoparticles were prepared by sol gel and hydrothermal methods respectively. Particle sizes of 20 nm (TiO2) and 50 nm (Fe2O3) were estimated from transmission electron microscopy (TEM) The other technical methods used in this study for the characterization of the TiO2 and iron oxide Fe2O3 NPs were SEM, XRD and UV- visible spectroscopy. Cyclic voltammetry, square wave voltammetry and electrochemical impedance spectroscopy (EIS) were used to study the electrochemical properties of the nanoparticles. These electrochemical studies of the nanoparticles were performed with a Fe2O3 or TiO2/nafion/glassy carbon membrane electrode in 0.1 M phosphate buffer (pH 7.0) and 0.1 M lithium perchlorate (pH 6.8) under an aerobic condition. / South Africa

Ce travail de thèse est consacré à l'élaboration de membrane photocatalytique à partir de nanoparticules de TiO2 obtenues par voie sol-gel (système TTIP-eau). Les sols sont préparés dans un réacteur à micro-mélange rapide (turbulent). L'effet de l'hydrodynamique au sein de différents mélangeurs (T simple, T chicanes, T rétrécissement) sur la morphologie et l'activité photocatalytique de nanoparticules déposées sur des plaques d'α-alumine a été étudié. Les dépôts de TiO2 ont été réalisés durant la période d'induction de la réaction sol-gel. Le mélange des réactifs a été simulé en utilisant un logiciel de modélisation numérique (modèle k-ε), Les différences hydrodynamiques au sein du micro-mélange a seulement un impact significatif sur le temps de stabilité des nanoparticules (période d'induction). Des couches minces et des membranes photo-actives ont été réalisées en vue du couplage membrane et réaction photocatalytique. Ces membranes ont été caractérisées et testées en photocatalyse. Elles ont montrées de bonnes photo-activités. Des tests de couplage direct séparation/photodégradation ont été réalisés sur des solutions aqueuses d'acide orange 7. Ce dispositif expérimental a permis de mettre en évidence une augmentation de flux de perméation significative avec de l'eau et en présence de colorant en solution. L'effet de la concentration et du pH de la solution a été évalué sur les flux de perméat et sur la photodégradation. / This PhD work is devoted to the elaboration of photocatalytic membranes using TiO2 nanoparticles synthetized by sol-gel process (titanium tetra-isopropoxyde precursor – water). Sols are prepared in sol-gel reactor with rapid turbulent micro-mixing. The effect of hydrodynamic using 3 T mixers (T simple, T with 3 baffles and T with narrow) during the mixing was studied with k-ε modeling Computational fluid Dynamics (CFD), as well as the morphology and the photo-activity of thin layers deposited on alumina support during induction period. Differences on hydrodynamic during micro-mixing have only impact on the time of nanoparticles stability (induction period). Photo-active thin layers and membranes are synthesized for coupling membrane separation and photocatalytic reaction. Photocatalytic activities of thin layers and membranes are performed with an aqueous solution of acid orange 7. Significant increases of permeate flux are observed during the filtration of water and solution containing dye. Effects of concentration and pH are evaluated on permeation flux and photodegradation.

Nanoparticles present potential risk for environmental compartments including soil. Previous works have been focused on negative effects of nanoparticles on soil biota, however studies about the influence of nanoparticles on soil properties are still limited. This thesis investigates an impact of 20 nm titanium dioxide nanoparticles on selected water properties in soil organic matter exposed to air with various relative humidity. Indeed, at 43, 70 and 95 % dominate different water types, i.e. water adsorbed on soil organic matter, water in water molecular bridges and phase water, respectively. Differential scanning calorimetry (DSC) was used in the study. An important finding is that nanoparticles reduce the stability of water molecular bridges under 70% relative air humidity and generally reduce evaporation enthalpy of water, which represents the ability of the soil to retain water. In the next part the influence of nanoparticles on total water in soil was observed. Under low relative humidity, rutile and anatase affected soil in different ways due to their various hydrophilicity. Under higher relative humidity this effect disappeared. In the last part, ice melting and water evaporation enthalpies of nanoparticle solutions were measured to confirm the presumed effect of nanoparticles on water. The ice melting enthalpy of the solutions was higher relatively to pure water, while the evaporation enthalpy showed a reverse trend (decrease). This confirmed the effects of nanoparticles both for pure water and soil water.

La détection et la caractérisation des nanoparticules manufacturées (NPM) est l’une des premières étapes pour contrôler et diminuer leurs risques potentiels sur la santé humaine et l’environnement. Différents systèmes d’échantillonnage dans l’air existent pour l’évaluation d’une exposition aux NPM. Cependant, ils ne mesurent pas le risque potentiel de cette exposition à la santé humaine ni les mécanismes cellulaires qui en seraient responsables. Nos objectifs de recherche sont 1) Évaluer les effets de différents types de nanoparticules sur des cellules pulmonaires humaines et 2) Identifier de nouveaux mécanismes intracellulaires activés lors de l’exposition à divers types de NPM. Méthodologie: La lignée de cellules A549 a été utilisée. Trois types de NPM ont été étudiés (différentes concentrations et temps d’exposition): les nanoparticules de dioxyde de titane de type anatase (TiO2), les nanotubes de carbone simple paroi (NTCSP) et les nanoparticules de noir de carbone (NC). La viabilité cellulaire a été mesurée par le test MTS, le test PrestoBlue et le test d’exclusion du bleu de Trypan (uniquement pour les NTCSP). La mesure du stress oxydatif a été déterminée par la mesure des dérivés réactifs de l’oxygène (ROS) en utilisant l’essai DCFH-DA. L’activation d’une réponse anti-oxydative a été déterminée par la mesure de la forme réduite (GSH) et oxydée (GSSG) du glutathion, ainsi que du ratio GSH/GSSG (seulement avec NTCSP et TiO2). Résultats: Les trois nanoparticules ne semblent pas être toxiques pour les cellules A549 car il y a une diminution significative mais minime de la viabilité cellulaire. Cependant, elles induisent une augmentation du contenu intracellulaire en ROS qui est à la fois dépendante du temps et de la concentration. Aucun changement dans les concentrations de GSH et GSSG n’a été observé. En conclusion, nos données indiquent que la mesure de la viabilité n’est pas un critère suffisant pour conclure à la toxicité des NPM. La production de ROS est un critère intéressant, cependant il faudra démontrer l’activation de systèmes anti-oxydatifs pour expliquer l’absence de mortalité cellulaire suite à l’exposition aux NPM. / Detection and characterization of manufactured nanoparticles (NPs) is one of the first steps to control and reduce potential risks to human health and the environment. Various sampling schemes in air exist for the evaluation of exposure to NPs. However, they do not measure the potential risk of this exposure to the human health and the cellular mechanisms that are responsible. Our research objectives are 1) To evaluate the effects of different types of nanoparticles on human lung cells and 2) Identify new intracellular mechanisms activated during exposure to various types of NPs. Methodology: The cell line A549 was used. Three types of NPs were studied (different concentrations and exposure time): titanium dioxide nanoparticles of anatase (TiO2), the simple wall carbon nanotubes (SWCN) and black carbon nanoparticles (BC). Cell viability was measured by the MTS assay, the PrestoBlue assay and the Trypan blue due exclusion test (only for the SWCN). To investigate whether the NPs stimulated ROS generation in A549 cels, the intracellular ROS level was measured using the DCFH-DA assay. The potential induction of oxidative stress responses in cells when exposed to TiO2 and SWCN was determined by the quantification of the extracellular levels of reduced (GSH) and oxidized glutathione (GSSG) forms. Results: The three nanoparticles do not appear to be toxic to A549 cells because there is a significant but small decrease in cell viability. However, they induce ROS production which is both time and concentration dependent. No change in the concentrations of GSH and GSSG were observed. In conclusion, our data indicate that measuring the cell viability is not a sufficient criterion for concluding if the NPs are toxic. ROS production is an interesting criterion, however, we have to demonstrate the activation of anti-oxidative systems to explain the absence of cell death following exposure to the NPs.